#include <mega16.h>
	#ifndef __SLEEP_DEFINED__
	#define __SLEEP_DEFINED__
	.EQU __se_bit=0x40
	.EQU __sm_mask=0xB0
	.EQU __sm_powerdown=0x20
	.EQU __sm_powersave=0x30
	.EQU __sm_standby=0xA0
	.EQU __sm_ext_standby=0xB0
	.EQU __sm_adc_noise_red=0x10
	.SET power_ctrl_reg=mcucr
	#endif

int zkb;
int zq;
int t1,t2;


// Timer 2 overflow interrupt service routine
interrupt [TIM2_OVF] void timer2_ovf_isr(void)
{
// Reinitialize Timer 2 value
//每次觸發為20微秒
TCNT2=0xEC;           //反轉值，理論值為0xEC 但是實測值為0xEF  有點沒搞懂  ??

  if((--zq)==0)
  {
    PORTB^=0B00000001;    //PORTB.0 反轉
    if(PORTB.0==1){
      zq=t1;
    }else
    {
      zq=t2;
    }
  }
}

// Declare your global variables here
void delay_1ms(void); //函數聲明，本實驗中會用到這兩個函數
void delay_nms(unsigned int n);


void main(void)
{
int aa=20;

/*初始化參數*/
zkb=1500;
t1=zkb/20;
t2=(20000-zkb)/20;
zq=t1;

/********************************************/

PORTB=0x00;
DDRB=0x00;
DDRB.0=1;      //置為輸出

PORTB.0=1;

// Timer/Counter 2 initialization
// Clock source: System Clock
// Clock value: 1000.000 kHz
// Mode: Normal top=FFh
// OC2 output: Disconnected
ASSR=0x00;
TCCR2=0x02;
TCNT2=0xEF;
OCR2=0x00;

// Timer(s)/Counter(s) Interrrupt(s) initialization
TIMSK=0x40;

// Global enable interrupts
#asm("sei")

while (1)
      {
        //下面是測試代碼
        delay_nms(150);
        zkb+=aa;
        if(zkb==1000||zkb==2000){    //標準應該是1000至2000
          aa=-aa;
          delay_nms(500);
        }
        t1=zkb/20;
        t2=(20000-zkb)/20;

      }
}

void delay_1ms(void)//1ms延時函數
{
  unsigned int i;
  for (i=0;i<150;i++)
  {
  }
}

void delay_nms(unsigned int n)//延時n毫秒
{
  unsigned int i;
  for (i=0;i<n;i++)//執行n次1毫秒延時
  delay_1ms();
}