(cpu/mpc7xxx/start.S)start:    b boot_coldstart_warm:    b boot_warmboot_cold:boot_warm:    clear bats    init l2 (if enabled)    init altivec (if enabled)    invalidate l2 (if enabled)    setup bats (from defines in config_EVB)    enable_addr_trans: (if MMU enabled)	enable MSR_IR and MSR_DR    jump to in_flashin_flash:    enable l1 dcache    gal_low_init: (board/evb64260/sdram_init.S)	config SDRAM (CFG, TIMING, DECODE)	init scratch regs (810 + 814)	detect DIMM0 (bank 0 only)	config SDRAM_PARA0 to 256/512Mbit	bl sdram_op_mode	detect bank0 width	    write scratch reg 810	config SDRAM_PARA0 with results	config SDRAM_PARA1 with results	detect DIMM1 (bank 2 only)	config SDRAM_PARA2 to 256/512Mbit	detect bank2 width	    write scratch reg 814	config SDRAM_PARA2 with results	config SDRAM_PARA3 with results	setup device bus timings/width	setup boot device timings/width	setup CPU_CONF (0x0)	setup cpu master control register 0x160	setup PCI0 TIMEOUT	setup PCI1 TIMEOUT	setup PCI0 BAR	setup PCI1 BAR	setup MPP control 0-3	setup GPP level control	setup Serial ports multiplex    setup stack pointer (r1)    setup GOT    call cpu_init_f    	debug leds    board_init_f: (common/board.c)	board_early_init_f:	    remap gt regs?	    map PCI mem/io	    map device space	    clear out interupts	init_timebase	env_init	serial_init	console_init_f	display_options	initdram: (board/evb64260/evb64260.c)	    detect memory	    for each bank:		dram_size()		setup PCI slave memory mappings		setup SCS   	setup monitor	alloc board info struct	init bd struct	relocate_code: (cpu/mpc7xxx/start.S)	    copy,got,clearbss	    board_init_r(bd, dest_addr) (common/board.c)		setup bd function pointers		trap_init		flash_init: (board/evb64260/flash.c)		setup bd flash info		cpu_init_r: (cpu/mpc7xxx/cpu_init.c)		    nothing		mem_malloc_init		malloc_bin_reloc		spi_init (r or f)??? (CFG_ENV_IS_IN_EEPROM)		env_relocated		misc_init_r(bd): (board/evb64260/evb64260.c)		    mpsc_init2