Text File for the SMC TokenCard TokenRing Linux driver (smctr.c).        By Jay Schulist <jschlst@samba.org>The Linux SMC Token Ring driver works with the SMC TokenCard Elite (8115T) ISA and SMC TokenCard Elite/A (8115T/A) MCA adapters.Latest information on this driver can be obtained on the Linux-SNA WWW site.Please point your browser to: http://www.linux-sna.orgThis driver is rather simple to use. Select Y to Token Ring adapter supportin the kernel configuration. A choice for SMC Token Ring adapters willappear. This drives supports all SMC ISA/MCA adapters. Choose thisoption. I personally recommend compiling the driver as a module (M), but if youyou would like to compile it staticly answer Y instead.This driver supports multiple adapters without the need to load multiple copiesof the driver. You should be able to load up to 7 adapters without any kernelmodifications, if you are in need of more please contact the maintainer of thisdriver.Load the driver either by lilo/loadlin or as a module. When a module using thefollowing command will suffice for most:# modprobe smctrsmctr.c: v1.00 12/6/99 by jschlst@samba.orgtr0: SMC TokenCard 8115T at Io 0x300, Irq 10, Rom 0xd8000, Ram 0xcc000.Now just setup the device via ifconfig and set and routes you may have. Afterthis you are ready to start sending some tokens.Errata:1). For anyone wondering where to pick up the SMC adapters please browse    to http://www.smc.com2). If you are the first/only Token Ring Client on a Token Ring LAN, please    specify the ringspeed with the ringspeed=[4/16] module option. If no    ringspeed is specified the driver will attempt to autodetect the ring    speed and/or if the adapter is the first/only station on the ring take    the appropriate actions.     NOTE: Default ring speed is 16MB UTP.3). PnP support for this adapter sucks. I recommend hard setting the     IO/MEM/IRQ by the jumpers on the adapter. If this is not possible    load the module with the following io=[ioaddr] mem=[mem_addr]    irq=[irq_num].    The following IRQ, IO, and MEM settings are supported.    IO ports:    0x200, 0x220, 0x240, 0x260, 0x280, 0x2A0, 0x2C0, 0x2E0, 0x300,    0x320, 0x340, 0x360, 0x380.    IRQs:    2, 3, 4, 5, 7, 8, 9, 10, 11, 12, 13, 14, 15    Memory addresses:    0xA0000, 0xA4000, 0xA8000, 0xAC000, 0xB0000, 0xB4000,    0xB8000, 0xBC000, 0xC0000, 0xC4000, 0xC8000, 0xCC000,    0xD0000, 0xD4000, 0xD8000, 0xDC000, 0xE0000, 0xE4000,    0xE8000, 0xEC000, 0xF0000, 0xF4000, 0xF8000, 0xFC000This driver is under the GNU General Public License. Its Firmware image isincluded as an initialized C-array and is licensed by SMC to the Linuxusers of this driver. However no warranty about its fitness is expressed orimplied by SMC.