The port was tested on Wind River System Sbc8560 board<www.windriver.com>. U-Boot was installed on the flash memory of theCPU card (no the SODIMM).NOTE: Please configure uboot compile to the proper PCI frequency andsetup the appropriate DIP switch settings.SBC8560 board:Make sure boards switches are set to their appropriate conditions.Refer to the Engineering Reference Guide ERG-00300-002. Of particularimportance are: 1) the settings for JP4 (JP4 1-3 and 2-4), whichselect the on-board FLASH device (Intel 28F128Jx); 2) The settingsfor the Clock SW9 (33 MHz or 66 MHz).	Note:	SW9 Settings: 66 MHz		4:1 ratio CCB clocks:SYSCLK		3:1 ration e500 Core:CCB		pos1 - on, pos2 - on, pos3 - off, pos4 - on, pos5 - off, pos6 - on	Note:	SW9 Settings: 33 MHz		8:1 ratio CCB clocks:SYSCLK		3:1 ration e500 Core:CCB		pos1 - on, pos2 - on, pos3 - on, pos4 - off, pos5 - off, pos6 - onFlashing the FLASH device with the "Wind River ICE":1) Properly connect and configure the Wind River ICE to the target   JTAG port. This includes running the SBC8560 register script. Make   sure target memory can be read and written.2) Build the u-boot image:	make distclean	make SBC8560_66_config or SBC8560_33_config	make CROSS_COMPILE=.../ELDK3.0/ppc_8xx-/ all   Note: reference is made to the ELDK3.0 compiler. Further, it seems	 the ppc_8xx compiler is required for the 85xx (no 85xx	 designated compiler in ELDK3.0)3) Convert the uboot (.elf) file to a uboot.bin file (using   visionClick converter). The bin file should be converted from   fffc0000 to ffffffff4) Setup the Flash Utility (tools menu) for:   Do a "dc clr" [visionClick] to load the default register settings   Determine the clock speed of the PCI bus and set SW9 accordingly	Note: the speed of the PCI bus defaults to the slowest PCI card   PlayBack the "default" register file for the SBC8560   Select the uboot.bin file with zero bias   Select the initialize Target prior to programming   Select the V28F640Jx (8192 x 8) 1 device FLASH Algorithm   Select the erase base address from FFFC0000 to FFFFFFFF   Select the start address from 0 with size of 40005) Erase and Program