#include <common.h>#include <mpc8xx.h>#include <pcmcia.h>#undef	CONFIG_PCMCIA#if defined(CONFIG_CMD_PCMCIA)#define	CONFIG_PCMCIA#endif#if defined(CONFIG_CMD_IDE) && defined(CONFIG_IDE_8xx_PCCARD)#define	CONFIG_PCMCIA#endif#ifdef	CONFIG_PCMCIA/* some sane bit macros */#define _BD(_b)				(1U << (31-(_b)))#define _BDR(_l, _h)			(((((1U << (31-(_l))) - 1) << 1) | 1) & ~((1U << (31-(_h))) - 1))#define _BW(_b)				(1U << (15-(_b)))#define _BWR(_l, _h)			(((((1U << (15-(_l))) - 1) << 1) | 1) & ~((1U << (15-(_h))) - 1))#define _BB(_b)				(1U << (7-(_b)))#define _BBR(_l, _h)			(((((1U << (7-(_l))) - 1) << 1) | 1) & ~((1U << (7-(_h))) - 1))#define _B(_b)				_BD(_b)#define _BR(_l, _h)			_BDR(_l, _h)#define PCMCIA_BOARD_MSG "NETTA"static const unsigned short vppd_masks[2] = { _BW(14), _BW(15) };static void cfg_vppd(int no){	volatile immap_t *immap = (immap_t *)CFG_IMMR;	unsigned short mask;	if ((unsigned int)no >= sizeof(vppd_masks)/sizeof(vppd_masks[0]))		return;	mask = vppd_masks[no];	immap->im_ioport.iop_papar &= ~mask;	immap->im_ioport.iop_paodr &= ~mask;	immap->im_ioport.iop_padir |=  mask;}static void set_vppd(int no, int what){	volatile immap_t *immap = (immap_t *)CFG_IMMR;	unsigned short mask;	if ((unsigned int)no >= sizeof(vppd_masks)/sizeof(vppd_masks[0]))		return;	mask = vppd_masks[no];	if (what)		immap->im_ioport.iop_padat |= mask;	else		immap->im_ioport.iop_padat &= ~mask;}static const unsigned short vccd_masks[2] = { _BW(10), _BW(6) };static void cfg_vccd(int no){	volatile immap_t *immap = (immap_t *)CFG_IMMR;	unsigned short mask;	if ((unsigned int)no >= sizeof(vccd_masks)/sizeof(vccd_masks[0]))		return;	mask = vccd_masks[no];	immap->im_ioport.iop_papar &= ~mask;	immap->im_ioport.iop_paodr &= ~mask;	immap->im_ioport.iop_padir |=  mask;}static void set_vccd(int no, int what){	volatile immap_t *immap = (immap_t *)CFG_IMMR;	unsigned short mask;	if ((unsigned int)no >= sizeof(vccd_masks)/sizeof(vccd_masks[0]))		return;	mask = vccd_masks[no];	if (what)		immap->im_ioport.iop_padat |= mask;	else		immap->im_ioport.iop_padat &= ~mask;}static const unsigned short oc_mask = _BW(8);static void cfg_oc(void){	volatile immap_t *immap = (immap_t *)CFG_IMMR;	unsigned short mask = oc_mask;	immap->im_ioport.iop_pcdir &= ~mask;	immap->im_ioport.iop_pcso  &= ~mask;	immap->im_ioport.iop_pcint &= ~mask;	immap->im_ioport.iop_pcpar &= ~mask;}static int get_oc(void){	volatile immap_t *immap = (immap_t *)CFG_IMMR;	unsigned short mask = oc_mask;	int what;	what = !!(immap->im_ioport.iop_pcdat & mask);;	return what;}static const unsigned short shdn_mask = _BW(12);static void cfg_shdn(void){	volatile immap_t *immap = (immap_t *)CFG_IMMR;	unsigned short mask;	mask = shdn_mask;	immap->im_ioport.iop_papar &= ~mask;	immap->im_ioport.iop_paodr &= ~mask;	immap->im_ioport.iop_padir |=  mask;}static void set_shdn(int what){	volatile immap_t *immap = (immap_t *)CFG_IMMR;	unsigned short mask;	mask = shdn_mask;	if (what)		immap->im_ioport.iop_padat |= mask;	else		immap->im_ioport.iop_padat &= ~mask;}static void cfg_ports (void){	volatile immap_t	*immap;	volatile cpm8xx_t	*cp;	immap = (immap_t *)CFG_IMMR;	cp    = (cpm8xx_t *)(&(((immap_t *)CFG_IMMR)->im_cpm));	cfg_vppd(0); cfg_vppd(1);	/* VPPD0,VPPD1 VAVPP => Hi-Z */	cfg_vccd(0); cfg_vccd(1);	/* 3V and 5V off */	cfg_shdn();	cfg_oc();	/*	* Configure Port A for TPS2211 PC-Card Power-Interface Switch	*	* Switch off all voltages, assert shutdown	*/	set_vppd(0, 1); set_vppd(1, 1);	set_vccd(0, 0); set_vccd(1, 0);	set_shdn(1);	udelay(100000);}int pcmcia_hardware_enable(int slot){	volatile immap_t	*immap;	volatile cpm8xx_t	*cp;	volatile pcmconf8xx_t	*pcmp;	volatile sysconf8xx_t	*sysp;	uint reg, pipr, mask;	int i;	debug ("hardware_enable: " PCMCIA_BOARD_MSG " Slot %c\n", 'A'+slot);	udelay(10000);	immap = (immap_t *)CFG_IMMR;	sysp  = (sysconf8xx_t *)(&(((immap_t *)CFG_IMMR)->im_siu_conf));	pcmp  = (pcmconf8xx_t *)(&(((immap_t *)CFG_IMMR)->im_pcmcia));	cp    = (cpm8xx_t *)(&(((immap_t *)CFG_IMMR)->im_cpm));	/* Configure Ports for TPS2211A PC-Card Power-Interface Switch */	cfg_ports ();	/* clear interrupt state, and disable interrupts */	pcmp->pcmc_pscr =  PCMCIA_MASK(_slot_);	pcmp->pcmc_per &= ~PCMCIA_MASK(_slot_);	/*	* Disable interrupts, DMA, and PCMCIA buffers	* (isolate the interface) and assert RESET signal	*/	debug ("Disable PCMCIA buffers and assert RESET\n");	reg  = 0;	reg |= __MY_PCMCIA_GCRX_CXRESET;	/* active high */	reg |= __MY_PCMCIA_GCRX_CXOE;		/* active low  */	PCMCIA_PGCRX(_slot_) = reg;	udelay(500);	/*	* Make sure there is a card in the slot, then configure the interface.	*/	udelay(10000);	debug ("[%d] %s: PIPR(%p)=0x%x\n",	       __LINE__,__FUNCTION__,	       &(pcmp->pcmc_pipr),pcmp->pcmc_pipr);	if (pcmp->pcmc_pipr & (0x18000000 >> (slot << 4))) {		printf ("   No Card found\n");		return (1);	}	/*	* Power On: Set VAVCC to 3.3V or 5V, set VAVPP to Hi-Z	*/	mask = PCMCIA_VS1(slot) | PCMCIA_VS2(slot);	pipr = pcmp->pcmc_pipr;	debug ("PIPR: 0x%x ==> VS1=o%s, VS2=o%s\n",	       pipr,	       (reg&PCMCIA_VS1(slot))?"n":"ff",	       (reg&PCMCIA_VS2(slot))?"n":"ff");	if ((pipr & mask) == mask) {		set_vppd(0, 1); set_vppd(1, 1); 		/* VAVPP => Hi-Z */		set_vccd(0, 0); set_vccd(1, 1); 		/* 5V on, 3V off */		puts (" 5.0V card found: ");	} else {		set_vppd(0, 1); set_vppd(1, 1); 		/* VAVPP => Hi-Z */		set_vccd(0, 1); set_vccd(1, 0); 		/* 5V off, 3V on */		puts (" 3.3V card found: ");	}	/*  Wait 500 ms; use this to check for over-current */	for (i=0; i<5000; ++i) {		if (!get_oc()) {			printf ("   *** Overcurrent - Safety shutdown ***\n");			set_vccd(0, 0); set_vccd(1, 0); 		/* VAVPP => Hi-Z */			return (1);		}		udelay (100);	}	debug ("Enable PCMCIA buffers and stop RESET\n");	reg  =  PCMCIA_PGCRX(_slot_);	reg &= ~__MY_PCMCIA_GCRX_CXRESET;	/* active high */	reg &= ~__MY_PCMCIA_GCRX_CXOE;		/* active low  */	PCMCIA_PGCRX(_slot_) = reg;	udelay(250000);	/* some cards need >150 ms to come up :-( */	debug ("# hardware_enable done\n");	return (0);}#if defined(CONFIG_CMD_PCMCIA)int pcmcia_hardware_disable(int slot){	volatile immap_t	*immap;	volatile pcmconf8xx_t	*pcmp;	u_long reg;	debug ("hardware_disable: " PCMCIA_BOARD_MSG " Slot %c\n", 'A'+slot);	immap = (immap_t *)CFG_IMMR;	pcmp  = (pcmconf8xx_t *)(&(((immap_t *)CFG_IMMR)->im_pcmcia));	/* Configure PCMCIA General Control Register */	debug ("Disable PCMCIA buffers and assert RESET\n");	reg  = 0;	reg |= __MY_PCMCIA_GCRX_CXRESET;	/* active high */	reg |= __MY_PCMCIA_GCRX_CXOE;		/* active low  */	PCMCIA_PGCRX(_slot_) = reg;	/* All voltages off / Hi-Z */	set_vppd(0, 1); set_vppd(1, 1);	set_vccd(0, 1); set_vccd(1, 1);	udelay(10000);	return (0);}#endifint pcmcia_voltage_set(int slot, int vcc, int vpp){	volatile immap_t	*immap;	volatile cpm8xx_t	*cp;	volatile pcmconf8xx_t	*pcmp;	u_long reg;	ushort sreg;	debug ("voltage_set: "			PCMCIA_BOARD_MSG			" Slot %c, Vcc=%d.%d, Vpp=%d.%d\n",	'A'+slot, vcc/10, vcc%10, vpp/10, vcc%10);	immap = (immap_t *)CFG_IMMR;	cp    = (cpm8xx_t *)(&(((immap_t *)CFG_IMMR)->im_cpm));	pcmp  = (pcmconf8xx_t *)(&(((immap_t *)CFG_IMMR)->im_pcmcia));	/*	* Disable PCMCIA buffers (isolate the interface)	* and assert RESET signal	*/	debug ("Disable PCMCIA buffers and assert RESET\n");	reg  = PCMCIA_PGCRX(_slot_);	reg |= __MY_PCMCIA_GCRX_CXRESET;	/* active high */	reg |= __MY_PCMCIA_GCRX_CXOE;		/* active low  */	PCMCIA_PGCRX(_slot_) = reg;	udelay(500);	/*	* Configure Port C pins for	* 5 Volts Enable and 3 Volts enable,	* Turn all power pins to Hi-Z	*/	debug ("PCMCIA power OFF\n");	cfg_ports ();	/* Enables switch, but all in Hi-Z */	sreg  = immap->im_ioport.iop_pcdat;	set_vppd(0, 1); set_vppd(1, 1);	switch(vcc) {		case  0:			break;	/* Switch off		*/		case 33:			set_vccd(0, 1); set_vccd(1, 0);			break;		case 50:			set_vccd(0, 0); set_vccd(1, 1);			break;		default:			goto done;	}	/* Checking supported voltages */	debug ("PIPR: 0x%x --> %s\n",	       pcmp->pcmc_pipr,	       (pcmp->pcmc_pipr & 0x00008000) ? "only 5 V" : "can do 3.3V");done:			debug ("Enable PCMCIA buffers and stop RESET\n");	reg  =  PCMCIA_PGCRX(_slot_);	reg &= ~__MY_PCMCIA_GCRX_CXRESET;	/* active high */	reg &= ~__MY_PCMCIA_GCRX_CXOE;		/* active low  */	PCMCIA_PGCRX(_slot_) = reg;	udelay(500);	debug ("voltage_set: " PCMCIA_BOARD_MSG " Slot %c, DONE\n",	       slot+'A');	return (0);}#endif	/* CONFIG_PCMCIA */