計算Mel倒譜系數的matlab程序： MELCEPST Calculate the mel cepstrum of a signal C=(S,FS,W,NC,P,N,INC,FL,FH) 使用: c=melcepst(s,fs) ％ calculate mel cepstrum with 12 coefs, 256 sample frames
標簽： Calculate MELCEPST cepstrum matlab
上傳時間： 2017-01-04
上傳用戶：youmo81
歷史上著名的p先生和s先生謎題，非常有意思。
標簽：
上傳時間： 2017-02-25
上傳用戶：liuchee
Handbook of Applied Cryptography, by A. Menezes, P. van Oorschot, and S. Vanstone, CRC Press, 1996
標簽： A. P. S. Cryptography
上傳時間： 2014-01-22
上傳用戶：playboys0
voodshe hren kakayato vsyakuyu huinyu zalivaty(p.s. kto ponimaet po russki-ne kachaite!)
標簽： p.s. russki-ne kakayato kachaite
上傳時間： 2014-01-01
上傳用戶：it男一枚
A Convex Hull is the smallest convex polygon that contains every point of the set S. A polygon P is convex if and only if, for any two points A and B inside the polygon, the line segment AB is inside P. One way to visualize a convex hull is to put a "rubber band" around all the points, and let it wrap as tight as it can. The resultant polygon is a convex hull.
上傳時間： 2013-12-23
上傳用戶：it男一枚
P/S 測試程序，可能有點幫助。。。。。。。。。。。。。
標簽： 測試程序
上傳時間： 2017-04-27
上傳用戶：ve3344
DE2 S O P C 用硬件語言 描述地 開發板上測試 CLM模塊 實現視頻傳輸
上傳時間： 2017-06-04
上傳用戶：lepoke
求一個復正弦加白噪聲隨機過程的信號： xn=exp(j*pi*n-j*pi)+exp(j*w0*n-j*0.7*pi)+v v(n)為零均值白噪聲。S/N=10dB。取P=3，構造4階的自相關矩陣R的基于MUSIC算法的功率譜估計的MATLAB程序
上傳時間： 2017-08-31
上傳用戶：franktu
Single-Ended and Differential S-Parameters Differential circuits have been important incommunication systems for many years. In the past,differential communication circuits operated at lowfrequencies, where they could be designed andanalyzed using lumped-element models andtechniques. With the frequency of operationincreasing beyond 1GHz, and above 1Gbps fordigital communications, this lumped-elementapproach is no longer valid, because the physicalsize of the circuit approaches the size of awavelength.Distributed models and analysis techniques are nowused instead of lumped-element techniques.Scattering parameters, or S-Parameters, have beendeveloped for this purpose [1]. These S-Parametersare defined for single-ended networks. S-Parameterscan be used to describe differential networks, but astrict definition was not developed until Bockelmanand others addressed this issue [2]. Bockelman’swork also included a study on how to adapt single-ended S-Parameters for use with differential circuits[2]. This adaptation, called “mixed-mode S-Parameters,” addresses differential and common-mode operation, as well as the conversion betweenthe two modes of operation.This application note will explain the use of single-ended and mixed-mode S-Parameters, and the basicconcepts of microwave measurement calibration.
上傳時間： 2014-03-25
上傳用戶：yyyyyyyyyy
Agilent AN 154 S-Parameter Design Application Note S參數的設計與應用 The need for new high-frequency, solid-state circuitdesign techniques has been recognized both by microwaveengineers and circuit designers. These engineersare being asked to design solid state circuitsthat will operate at higher and higher frequencies.The development of microwave transistors andAgilent Technologies’ network analysis instrumentationsystems that permit complete network characterizationin the microwave frequency rangehave greatly assisted these engineers in their work.The Agilent Microwave Division’s lab staff hasdeveloped a high frequency circuit design seminarto assist their counterparts in R&D labs throughoutthe world. This seminar has been presentedin a number of locations in the United States andEurope.From the experience gained in presenting this originalseminar, we have developed a four-part videotape, S-Parameter Design Seminar. While the technologyof high frequency circuit design is everchanging, the concepts upon which this technologyhas been built are relatively invariant.The content of the S-Parameter Design Seminar isas follows:
標簽： S參數
上傳時間： 2013-12-19
上傳用戶：aa54
