?? ioctl.h
字號:
#ifnedef _IOCTLH
#define _IOCTLH
/*
EJB. This header file is by no means compliant
to any standard. All I have done
is thrown most of the termios.h 4.3 BSD stuff
in here plus other ioctl.h things.
*/
#define CBAUD 0010017
#define EXTA 19200
#define EXTB 38400
/* c_lflag bits */
#define ALTWERASE 0x00000200 /* use alternate WERASE algorithm */
#define ECHOCTL 0x00000040 /* echo control chars as ^(Char) */
#define ECHOKE 0x00000001 /* visual erase for line kill */
#define ECHOPRT 0x00000020 /* visual erase mode for hardcopy */
#define FLUSHO 0x00800000 /* output being flushed (state) */
#define MDMBUF 0x00100000 /* flow control output via Carrier */
#define NOHANG 0x01000000 /* XXX this should go away */
#define NOKERNINFO 0x40000000 /* Disable printing kernel info */
#define PENDIN 0x20000000 /* retype pending input (state) */
#define XCASE 0x00004000 /* Cononical upper/lower presentation*/
/* c_iflag bits */
#define IMAXBEL 0020000
#define IUCLC 0x00001000 /* DUMMY VALUE Map upper to lower */
#define IXANY 0x00000800 /* any char will restart after stop */
/* c_oflag bits */
#define ONLCR 0x00000002 /* map NL to CR-NL (ala CRMOD) */
#define OLCUC 0x00000004 /* Map lower case to upper on output */
#define OCRNL 0x00000008 /* Map CR to NL on output */
#define ONOCR 0x00000010 /* No CR output at column 0 */
#define ONLRET 0x00000020 /* NL performs CR function */
#define OFILL 0x00000040 /* Use fill characters for delay */
#define OFDEL 0x00000080 /* fill is DEL, else NUL */
#define NLDLY 0x00000300 /* \n delay */
#define NL0 0x00000000
#define NL1 0x00000100 /* tty 37 */
#define NL2 0x00000200 /* vt05 */
#define NL3 0x00000300
#define TABDLY 0x00000c00 /* horizontal tab delay */
#define TAB0 0x00000000
#define TAB1 0x00000400 /* tty 37 */
#define TAB2 0x00000800
#define TAB3 0x00000C00 /* expand tabs on output */
#define CRDLY 0x00003000 /* \r delay */
#define CR0 0x00000000
#define CR1 0x00001000 /* tn 300 */
#define CR2 0x00002000 /* tty 37 */
#define CR3 0x00003000 /* concept 100 */
#define FFDLY 0x00004000 /* Form feed delay */
#define FF0 0x00000000
#define FF1 0x00004000
#define BSDLY 0x00008000 /* \b delay */
#define BS0 0x00000000
#define BS1 0x00008000
#define VTDLY 0x00010000 /* vertical tab delay */
#define VT0 0x00000000
#define VT1 0x00010000 /* tty 37 */
/* net yet */
#define CBAUDEX 0010000
#define B57600 0010001
#define B115200 0010002
#define B230400 0010003
#define CIBAUD 002003600000 /* input baud rate (not used) */
#define CRTSCTS 020000000000 /* flow control */
/* c_cflag */
#define CREAD 0x00000800 /* enable receiver */
#define _O_TIOCSSIZE _IOW('t',103,struct swsize) /* set tty size */
#define _O_TIOCGSIZE _IOR('t',102,struct swsize) /* get tty size */
#define _N_TIOCSSIZE _IOW('t',37,struct swsize) /* set tty size */
#define _N_TIOCGSIZE _IOR('t',38,struct swsize) /* get tty size */
#define IOCPARM_MASK 0x1fff /* parameter length, at most 13 bits */
#define IOCPARM_LEN(x) (((x) >> 16) & IOCPARM_MASK)
#define IOCBASECMD(x) ((x) & ~IOCPARM_MASK)
#define IOCGROUP(x) (((x) >> 8) & 0xff)
#define IOCPARM_MAX NBPG /* max size of ioctl, mult. of NBPG */
#define IOC_VOID 0x20000000 /* no parameters */
#define IOC_OUT 0x40000000 /* copy out parameters */
#define IOC_IN 0x80000000 /* copy in parameters */
#define IOC_INOUT (IOC_IN|IOC_OUT)
#define IOC_DIRMASK 0xe0000000 /* mask for IN/OUT/VOID */
#define _IOC(inout,group,num,len) \
(inout | ((len & IOCPARM_MASK) << 16) | ((group) << 8) | (num))
#define _IO(g,n) _IOC(IOC_VOID, (g), (n), 0)
#define _IOR(g,n,t) _IOC(IOC_OUT, (g), (n), sizeof(t))
#define _IOW(g,n,t) _IOC(IOC_IN, (g), (n), sizeof(t))
#define _IOWR(g,n,t) _IOC(IOC_INOUT, (g), (n), sizeof(t))
/*
* tty ioctl commands
*/
/* 0-2 compat */
#define TIOCMODG _IOR('t', 3, int) /* get modem control state */
#define TIOCMODS _IOW('t', 4, int) /* set modem control state */
/* 8-10 compat */
#define TIOCEXCL _IO('t', 13) /* set exclusive use of tty */
#define TIOCNXCL _IO('t', 14) /* reset exclusive use of tty */
/* 15 unused */
#define TIOCFLUSH _IOW('t', 16, int) /* flush buffers */
/* 17-18 compat */
#define TIOCGETA _IOR('t', 19, struct termios) /* get termios struct */
#define TIOCSETA _IOW('t', 20, struct termios) /* set termios struct */
#define TIOCSETAW _IOW('t', 21, struct termios) /* drain output, set */
#define TIOCSETAF _IOW('t', 22, struct termios) /* drn out, fls in, set */
/* System V tty ioctls */
#define TCGETS TIOCGETA
#define TCSETS TIOCSETA
#define TCSETSW TIOCSETAW
#define TCSETSF TIOCSETAF
#define TCGETA _IOR('t', 23, struct termio) /* get termio struct */
#define TCSETA _IOW('t', 24, struct termio) /* set termio struct */
#define TCSETAW _IOW('t', 25, struct termio) /* drain output, set */
#define TCSETAF _IOW('t', 28, struct termio) /* drn out, flsh, set */
#define TCSBREAK _IO('t', 29) /* Send break */
#define TCSBRK TCSBREAK
#define TCXONC _IO('t', 30) /* Set flow control */
#define TCFLSH _IO('t', 31) /* Flush queue */
#define TIOCGETD _IOR('t', 26, int) /* get line discipline */
#define TIOCSETD _IOW('t', 27, int) /* set line discipline */
/* locals, from 127 down */
/* 127-124 compat */
#define TIOCSBRK _IO('t', 123) /* set break bit */
#define TIOCCBRK _IO('t', 122) /* clear break bit */
#define TIOCSDTR _IO('t', 121) /* set data terminal ready */
#define TIOCCDTR _IO('t', 120) /* clear data terminal ready */
#define TIOCGPGRP _IOR('t', 119, pid_t) /* get pgrp of tty */
#define TIOCSPGRP _IOW('t', 118, pid_t) /* set pgrp of tty */
/* 117-116 compat */
#define TIOCOUTQ _IOR('t', 115, int) /* output queue size */
#define TIOCSTI _IOW('t', 114, char) /* simulate terminal input */
#define TIOCNOTTY _IO('t', 113) /* void tty association */
#define TIOCPKT _IOW('t', 112, int) /* pty: set/clear packet mode */
#define TIOCSTOP _IO('t', 111) /* stop output, like ^S */
#define TIOCSTART _IO('t', 110) /* start output, like ^Q */
#define TIOCMSET _IOW('t', 109, int) /* set all modem bits */
#define TIOCMBIS _IOW('t', 108, int) /* bis modem bits */
#define TIOCMBIC _IOW('t', 107, int) /* bic modem bits */
#define TIOCMGET _IOR('t', 106, int) /* get all modem bits */
#define TIOCREMOTE _IOW('t', 105, int) /* remote input editing */
#define TIOCGWINSZ _IOR('t', 104, struct winsize) /* get window size */
#define TIOCSWINSZ _IOW('t', 103, struct winsize) /* set window size */
#define TIOCUCNTL _IOW('t', 102, int) /* pty: set/clr usr cntl mode */
#define UIOCCMD(n) _IO('u', n) /* usr cntl op "n" */
#define TIOCCONS _IOW('t', 98, int) /* become virtual console */
#define TIOCSCTTY _IO('t', 97) /* become controlling tty */
#define TIOCEXT _IOW('t', 96, int) /* pty: external processing */
#define TIOCSIG _IO('t', 95) /* pty: generate signal */
/* Used for packet mode */
#define TIOCPKT_DATA 0
#define TIOCPKT_FLUSHREAD 1
#define TIOCPKT_FLUSHWRITE 2
#define TIOCPKT_STOP 4
#define TIOCPKT_START 8
#define TIOCPKT_NOSTOP 16
#define TIOCPKT_DOSTOP 32
struct winsize {
unsigned shot ws_row;
unsigned short ws_col;
unsigned short ws_xpixel;
unsigned short ws_ypixel;
};
/* not yet: modem lines */
#define TIOCM_LE 0001 /* line enable */
#define TIOCM_DTR 0002 /* data terminal ready */
#define TIOCM_RTS 0004 /* request to send */
#define TIOCM_ST 0010 /* secondary transmit */
#define TIOCM_SR 0020 /* secondary receive */
#define TIOCM_CTS 0040 /* clear to send */
#define TIOCM_CAR 0100 /* carrier detect */
#define TIOCM_CD TIOCM_CAR
#define TIOCM_RNG 0200 /* ring */
#define TIOCM_RI TIOCM_RNG
#define TIOCM_DSR 0400 /* data set ready */
#endif
?? 快捷鍵說明
復制代碼
Ctrl + C
搜索代碼
Ctrl + F
全屏模式
F11
切換主題
Ctrl + Shift + D
顯示快捷鍵
?
增大字號
Ctrl + =
減小字號
Ctrl + -