LS-WOS V1 (Link & System-Level Wireless OFDM System Simulator Version 1)

This is the first time this simulator is published. We have tried to verify this simulator many times, however, there might still be some bugs. Please let us know if you found them. Thanks a lot.

It contains mainly two parts, i.e. link-level simulator and system-level simulator.

Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.

System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.


Link-level simulator support SISO, 1 by x MRC, 2 by 1 STBC/SFBC, 2 by 2 Alamouti, x by 1 Antenna selection, x by y antenna selection.
System-level simulator, currently support only SISO and 1 by 2 MRC.

To start with, go into the folder sys_link_simu, and excute the following commond from matlab:

sys_link_simu_func(a,b)

where a is the link adaptation interval, in terms of No. of OFDM frames. b is the power adaptation interval. e.g. a = b = 1.

results will be saved in sys_link_result folder.

Detained manual will be provided later in wikipedia. Link to the manual will be updated soon.

The authors are members of the Rate group @ Aalborg University, and are grateful for the support from AAU, CTIF and the rate group.

Yuanye Wang, Suvra Sekhar Das and Muhammad Imadur Rahman
in Aalborg University, Aalborg, Denmark
13:42 26-10-2007

email:
ywa@es.aau.dk