/********************************************************************** * Using inside operator with an array * * Author: Stuart Sutherland * * (c) Copyright 2003, Sutherland HDL, Inc. *** ALL RIGHTS RESERVED *** * www.sutherland-hdl.com * * Used with permission in the book, "SystemVerilog for Design" *  By Stuart Sutherland, Simon Davidmann, and Peter Flake. *  Book copyright: 2003, Kluwer Academic Publishers, Norwell, MA, USA *  www.wkap.il, ISBN: 0-4020-7530-8 * * Revision History: *   1.00 15 Dec 2003 -- original code, as included in book *   1.01 10 Jul 2004 -- cleaned up comments, added expected results *                       to output messages *   1.10 21 Jul 2004 -- corrected errata as printed in the book *                       "SystemVerilog for Design" (first edition) and *                       to bring the example into conformance with the *                       final Accellera SystemVerilog 3.1a standard *                       (for a description of changes, see the file *                       "errata_SV-Design-book_26-Jul-2004.txt") * * Caveat: Expected results displayed for this code example are based * on an interpretation of the SystemVerilog 3.1 standard by the code * author or authors.  At the time of writing, official SystemVerilog * validation suites were not available to validate the example. * * RIGHT TO USE: This code example, or any portion thereof, may be * used and distributed without restriction, provided that this entire * comment block is included with the example. * * DISCLAIMER: THIS CODE EXAMPLE IS PROVIDED "AS IS" WITHOUT WARRANTY * OF ANY KIND, EITHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED * TO WARRANTIES OF MERCHANTABILITY, FITNESS OR CORRECTNESS. IN NO * EVENT SHALL THE AUTHOR OR AUTHORS BE LIABLE FOR ANY DAMAGES, * INCLUDING INCIDENTAL OR CONSEQUENTIAL DAMAGES, ARISING OUT OF THE * USE OF THIS CODE. *********************************************************************/module test;  int d_array [0:1023];  initial begin     d_array[100] = 13;     if ( 13 inside {d_array} )       //...       $display("\nTest passed: value of 13 is inside d_array\n");     else       $display("\nTest failed: value of 13 was not inside d_array\n");     //if ( 15 inside d_array )  // incorrect syntax     if ( 15 inside {d_array} )       //...       $display("\nTest failed: value of 15 is inside d_array\n");     else       $display("\nTest passed: value of 15 was not inside d_array\n");     $finish;  endendmodule