The makers of handheld medical, industrial and consumerdevices use a wide variety of high resolution, small tomedium sized color TFT LCD displays. The power supplydesigners for these displays must contend with shrinkingboard area, tight schedules, and variations in displaytypes and feature requirements. The LTC®3524 simplifi esthe designer’s job by combining a versatile, easily programmed,TFT LCD bias supply and white LED backlightdriver in a low profi le 4mm × 4mm QFN package.
上傳時間： 2013-10-26
上傳用戶：chens000
Avalanche photo diode (APD) receiver modules arewidely used in fi ber optic communication systems. AnAPD module contains the APD and a signal conditioningamplifi er, but is not completely self contained. It stillrequires signifi cant support circuitry including a highvoltage, low noise power supply and a precision currentmonitor to indicate the signal strength. The challenge issqueezing this support circuitry into applications withlimited board space. The LT®3482 addresses this challengeby integrating a monolithic DC/DC step-up converter andan accurate current monitor. The LT3482 can supportup to a 90V APD bias voltage, and the current monitorprovides better than 10% accuracy over four decades ofdynamic range (250nA to 2.5mA).
上傳時間： 2014-01-18
上傳用戶：wenyuoo
High voltage buck DC/DC controllers such as the LTC3890(dual output) and LTC3891 (single output) are popular inautomotive applications due to their extremely wide 4V to60V input voltage range, eliminating the need for a snubberand voltage suppression circuitry. These controllersare also well suited for 48V telecom applications whereno galvanic isolation is required.
上傳時間： 2013-10-31
上傳用戶：wwwe
Avalanche photodiodes (APDs) are widely utilized in laserbased fiberoptic systems to convert optical data intoelectrical form. The APD is usually packaged with a signalconditioning amplifier in a small module. An APD receivermodule and attendant circuitry appears in Figure 1. TheAPD module (figure right) contains the APD and a transimpedance(e.g., current-to-voltage) amplifier. An opticalport permits interfacing fiberoptic cable to the APD’sphotosensitive portion. The module’s compact constructionfacilitates a direct, low loss connection between theAPD and the amplifier, necessary because of the extremelyhigh speed data rates involved
上傳時間： 2013-10-25
上傳用戶：brain kung
Telecommunication, satellite links and set-top boxes allrequire tuning a high frequency oscillator. The actualtuning element is a varactor diode, a 2-terminal device thatchanges capacitance as a function of reverse bias voltage.1 The oscillator is part of a frequency synthesizingloop, as detailed in Figure 1. A phase locked loop (PLL)compares a divided down representation of the oscillatorwith a frequency reference. The PLL’s output is levelshifted to provide the high voltage necessary to bias thevaractor, which closes a feedback loop by voltage tuningthe oscillator. This loop forces the voltage controlledoscillator (VCO) to operate at a frequency determined bythe frequency reference and the divider’s division ratio.
上傳時間： 2013-12-20
上傳用戶：ABCDE
針對于目前CMOS電流控制電流傳輸器（CCCII）中普遍存在的溫度依賴性問題，提出一個新的溫度補償技術。這種技術主要使用電流偏置電路和分流電路為CCCII產生偏置電流，其中偏置電路中的電流和μC'OX成正比?；?.5μm CMOS工藝參數，運用HSPICE仿真軟件，對提出的電路進行仿真，仿真結果驗證了電路的正確性。
上傳時間： 2013-10-13
上傳用戶：歸海惜雪
摘要: 研究用內腔式He- Ne 激光器做光源時, 硅光電池實驗中光電檢流計讀數不穩定的現象。利用硅光電池分別觀測在不加偏振片、加上偏振片時內腔式He- Ne 激光器輸出的光強度, 得到激光經偏振片后輸出光強隨時間而變。利用共焦掃描干涉儀掃描出激光束的各個縱模, 實驗表明, 內腔式He- Ne 激光器每個縱模的偏振方向隨時間緩慢變化, 引起了實驗中輸出的光強變化。
上傳時間： 2013-11-17
上傳用戶：ArmKing88
維持高壓直流輸電系統的穩定、可靠運行是一項基本的要求。HVDC-r"程單極大地回路引起的直流偏磁、電力系統背景諧波和各種電力系統擾動等都有可能使HVDC系統運行于非理想的環境，在一定條件下甚至會導致HVDC系統穩定被破壞的嚴重后果。本文立足于交、直流系統的相互作用關系，以HVDC系統的穩定性為目標，重點研究了以下問題。
上傳時間： 2013-11-14
上傳用戶：xinhaoshan2016
提出了一種24V/15A 直流變換器的設計方法。主電路采用推挽正激電路，通過在傳統推挽電路的基礎上增加一個箝位電容，起到抑制偏磁和開關管關斷電壓尖峰的作用?？刂撇捎梅逯惦娏骺刂品绞剑≒eak CurrentControlled Model，簡稱PCCM），為了克服其對占空比要求的限制，加入了斜坡補償環節。在進行詳細的理論分析基礎上，給出了主電路和控制電路一些關鍵參數的設計步驟；最后通過原理樣機的研制，驗證了理論分析的正確性。
上傳時間： 2013-10-23
上傳用戶：dick_sh
6N137的結構原理如圖1所示，信號從腳2和腳3輸入，發光二極管發光，經片內光通道傳到光敏二極管，反向偏置的光敏管光照后導通，經電流-電壓轉換后送到與門的一個輸入端，與門的另一個輸入為使能端，當使能端為高時與門輸出高電平，經輸出三極管反向后光電隔離器輸出低電平。當輸入信號電流小于觸發閾值或使能端為低時，輸出高電平，但這個邏輯高是集電極開路的，可針對接收電路加上拉電阻或電壓調整電路。
上傳時間： 2014-03-24
上傳用戶：skhlm
