a_bit equ 20h ;個位數存放處
b_bit equ 21h ;十位數存放處
temp equ 22h ;計數器寄存器
star: mov temp,#0 ;初始化計數器
stlop: acall display
inc temp
mov a,temp
cjne a,#100,next ;=100重來
mov temp,#0
next: ljmp stlop
;顯示子程序
display: mov a,temp ;將temp中的十六進制數轉換成10進制
mov b,#10 ;10進制/10=10進制
div ab
mov b_bit,a ;十位在a
mov a_bit,b ;個位在b
mov dptr,#numtab ;指定查表啟始地址
mov r0,#4
dpl1: mov r1,#250 ;顯示1000次
dplop: mov a,a_bit ;取個位數
MOVC A,@A+DPTR ;查個位數的7段代碼
mov p0,a ;送出個位的7段代碼
標簽：
直接驅動
數碼管
計數器
程序
上傳時間：
2013-11-06
上傳用戶：lx9076
Single-Ended and Differential S-Parameters
Differential circuits have been important incommunication systems for many years. In the past,differential communication circuits operated at lowfrequencies, where they could be designed andanalyzed using lumped-element models andtechniques. With the frequency of operationincreasing beyond 1GHz, and above 1Gbps fordigital communications, this lumped-elementapproach is no longer valid, because the physicalsize of the circuit approaches the size of awavelength.Distributed models and analysis techniques are nowused instead of lumped-element techniques.Scattering parameters, or S-parameters, have beendeveloped for this purpose [1]. These S-parametersare defined for single-ended networks. S-parameterscan be used to describe differential networks, but astrict definition was not developed until Bockelmanand others addressed this issue [2]. Bockelman’swork also included a study on how to adapt single-ended S-parameters for use with differential circuits[2]. This adaptation, called “mixed-mode S-parameters,” addresses differential and common-mode operation, as well as the conversion betweenthe two modes of operation.This application note will explain the use of single-ended and mixed-mode S-parameters, and the basicconcepts of microwave measurement calibration.
標簽：
差分電路
單端
模式
上傳時間：
2014-03-25
上傳用戶：yyyyyyyyyy
