提出一種高性能全數字式正弦波逆變電源的設計方案。該方案分為前后兩級，前級采用推挽升壓電路將輸入的直流電升壓到350 V左右的母線電壓，后級采用全橋逆變電路，逆變橋輸出經濾波器濾波后，用隔離變壓器進行電壓采樣，電流互感器進行電流采樣，以形成反饋環節，增加電源輸出的穩定性。升壓級PWM驅動及逆變級SPWM驅動均由STM32單片機產生，減小了硬件開支。基于上述方案試制的400 W樣機，具有輸出短路保護、過流保護及輸入過壓保護、欠壓保護功能，50 Hz輸出時頻率偏差小于0.05 Hz，滿載（400 W）效率高于87%，電壓精度為220 V±1%，THD小于1.5%。
標簽： STM 32 單片機 數控
上傳時間： 2013-11-17
上傳用戶：guojin_0704
針對飛行模擬器座艙數據采集的復雜性，設計了一種基于以太網分布式的數據采集控制系統，該系統是RCM5700微處理器模塊上的以太網應用。在系統的基礎上具體討論了PoE技術的應用，在傳輸數據的網線上同時提供電流，提出并實現了一種包括輔助電源在內的完整可靠的PoE供電方案。設計采用美國國家半導體的LM5073和LM5576并根據不同的負載情況，進行穩定可靠的電壓轉換，以滿足數據采集電路的要求。實驗結果表明：該設計穩定可靠，滿足低于13 W的采集節點供電要求，提高了模擬器信號采集系統的通用性和標準化程度，避免了以往數據采集節點單獨繁瑣的電源設計。 Abstract: Aiming at the complexity of large avion simulation and controlling，the simulator cabin distribute data collecting and control system was designed. This system is the application of RCM5700 on Ethernet. Based on this system，PoE technique that makes Ethernet can also provide power were expounded with emphasis and included FAUX design the PoE resolution was realized. To achieve the requirement of this system，LM5073 and LM5576 were used to DC-DC switch. From the data of experiment，the design filled the requirement of power-need of node whose power was lower than 13W. The application of the technique can advance the degree of simulation data collections currency and standardization and avoid designing additional power system.
標簽： 以太網 分布式 數據采集 控制系統
上傳時間： 2013-11-09
上傳用戶：xyipie
個人第一個作品——紀念這連日來奮戰后的挫敗
標簽： 三極管 PN結 溫度特性 溫度傳感器
上傳時間： 2013-10-25
上傳用戶：釣鰲牧馬
特點 精確度0.05%滿刻度 ±1位數 顯示范圍-19999-99999可任意規劃 可直接量測直流4至20mA電流,無需另接輔助電源 尺寸小(24x48x50mm),穩定性高 分離式端子,配線容易 CE 認證 主要規格 輔助電源: None 精確度: 0.05% F.S. ±1 digit(DC) 輸入抗阻: approx. 250 ohm with 20mA input 輸入電壓降: max. DC5V with 20mA input 最大過載能力: < ±50mA 取樣時間: 2.5 cycles/sec. 顯示值范圍: -19999 - 99999 digit adjustable 歸零調整范圍: -999-999 digit adjustable 最大值調整范圍: -999-999 digit adjustable 過載顯示: " doFL " or "-doFL" 極性顯示: " 一 " for negative readings 顯示幕 : Brigh Red LEDs high 8.6mm(.338") 溫度系數 : 50ppm/℃ (0-50℃) 參數設定方式: Touch switches 記憶型式: Non-volatile E2 外殼材料: ABS 絕緣耐壓能力: 2KVac/1 min. (input/case) 使用環境條件: 0-50℃(20 to 90% RH non-condensed) 存放環境條件: 0-70℃(20 to 90% RH non-condensed) 外型尺寸: 24x48x50mm CE認證: EN 55022:1998/A1:2000 Class A EN 61000-3-2:2000 EN 61000-3-3:1995/A1:2001 EN 55024:1998/A1:2001
上傳時間： 2013-10-09
上傳用戶：lhuqi
多遠程二極管溫度傳感器-Design Considerations for pc thermal management Multiple RDTS (remote diode temperature sensing) provides the most accurate method of sensing an IC’s junction temperature. It overcomes thermal gradient and placement issues encountered when trying to place external sensors. PCB component count decreases when using a device that provides multiple inputs.Better temperature sensing improves product performance and reliability. Disk drive data integrity suffers at elevated temperatures. IBM published an article stating that a 5°C rise in operating temperature causes a 15% increase in the drive’s failure rate. The overall performance of a system can be improved by providing a more accurate temperature measurement of the most critical devices allowing them to run just a few degrees hotter.The LM83 directly senses its own temperature and the temperature of three external PN junctions. One is dedicated to the CPU of choice, the other two go to other parts of your system that need thermal monitoring such as the disk drive or graphics chip. The SMBus-compatible LM83 supports SMBus timeout and logic levels. The LM83 has two interrupt outputs; one for user-programmable limits and WATCHDOG capability (INT), the other is a Critical Temperature Alarm output (T_CRIT_A) for system power supply shutdown.
標簽： Considerat Design 遠程 二極管
上傳時間： 2014-12-21
上傳用戶：ljd123456
Linear Technology offers some of the highest performance RF and signal chain solutions for wireless and cellularinfrastructure. These products support worldwide standards including, LTE, WiMAX, GSM,W-CDMA, TD-SCDMA,CDMA, and CDMA2000. Other wireless systems include broadband microwave data links, secure communications,satellite receivers, broadband wireless access, wireless broadcast systems, RFID readers and cable infrastructure
上傳時間： 2013-11-04
上傳用戶：kiklkook
設計了Ka波段螺旋線行波管的慢波結構,分析其色散特性曲線和耦合阻抗,對高頻系統進行了優化;利用PIC粒子模擬得到在工作頻帶內飽和輸出功率＞73.5 W,增益畸變＜2%,并對試制樣管進行了試驗,測得在工作頻帶內輸出功率＞45 W,電子效率＞12.5%,采用4級降壓收集極后總效率大于40%,最后對模擬結果和實測結果的差異原因進行了簡單分析。
標簽： 行波管 慢波 模擬設計
上傳時間： 2013-12-14
上傳用戶：米米陽123
真空斷路器滅弧室觸頭是斷路器實現分閘合閘的關鍵部件，需定期檢查，但常規人工檢測方法費時費力。經過對真空斷路器滅弧室機械結構特點與動作過程的研究，設計出一種基于ARM處理器的觸頭磨損度檢測系統，此系統由安裝在斷路器端的從機和安裝在控制室電腦上的主機適配器組成，系統使用搭載ARM1176JZF-S處理器的S3C6410芯片、AD3812模塊、W-DCD5位移傳感器、4432系列射頻無線模塊等器件實現了在機房使用一臺PC機或手機短信對多臺真空斷路器滅弧室觸頭磨損進行遠程檢測與控制。經測試，系統檢測誤差低于0.78%。系統檢測精度高，使用方便實時性好，可靠性強，大大減少了以往的觸頭檢測工作量。
標簽： ARM 真空斷路器 檢測系統 磨損
上傳時間： 2013-10-14
上傳用戶：nanshan
本書是c語言的設計者之一dennis m．ritchie和著名的計算機科學家brian w．kernighan合著的一本介紹c語言的權威經典著作。我們現在見到的大量論述c語言程序設計的教材和專著均以此書為藍本。
標簽： Turbo C程序設計 語言
上傳時間： 2013-10-10
上傳用戶：sunchao524
實現了整條支路的LED路燈定時控制開關燈、自動開關燈、獨立控制開關燈及故障報警等多項功能。對1 W LED路燈單元可調恒流驅動電源，可以按照設定要求調節LED輸出功率大小，實現調光功能。
標簽： 單片機 路燈 模擬控制系統
上傳時間： 2013-11-13
上傳用戶：大三三
蟲蟲下載站版權所有 京ICP備2021023401號-1
