Hid Led Tester is a simple USB（interrupt mode）device tester package. There are firmware and software in it. Hid Led tester follows USB HID protocol, we don’t need to install driver for the device, and Windows (Win 2000 and later) will install the device automatic.
USB Thumb Drive Designer Reference Manual. This manual describes a reference design of USB2.0 Thumb Drive solution by using the MC9S12UF32
microcontroller.
* This driver is to be used as a skeleton driver to be able to create a
* USB driver quickly. The design of it is based on the usb-serial and
* dc2xx drivers.
The USB Multi-Interface driver is a replacement driver for the system provided Multi-Interface driver. This driver was developed to overcome some bugs that are included in the build in driver and to introduce new features. The driver is compatible to the system provided Multi-Interface driver. If the driver is installed on a system, it does not automatically replace the system provided driver. It exists parallel to the system driver and is assigned to a device during the installation process.
This software package contains the USB framework core developped by ATMEL,
as well as a CDC driver for an USB to serial converter.
The following files are included :
- core/
-> Source code for the framework core
-> Makefile for the core
- cdc/
-> Source code for the CDC driver
-> Makefile for the CDC driver
- lib/
-> Lib v3 files for every supported chips
- bin/
-> Compiled binaries for every supported chips
- ./
-> Makefile for the framework
-> Startup file
This software package contains the USB framework core developped by ATMEL,
as well as a Mass storage driver. The MSD driver uses the internal flash
of the chip to operate as a disk-on-key.
The following files are included :
- core/
-> Source code for the framework core
-> Makefile for the core
- msd/
-> Source code for the Mass Storage driver
-> Makefile for the MSD driver
- bin/
-> Compiled binaries for every supported chips
- lib/
-> Lib v3 files for every supported chips
- ./
-> Makefile for the framework
-> Startup file
