亚洲欧美第一页_禁久久精品乱码_粉嫩av一区二区三区免费野_久草精品视频

蟲蟲首頁| 資源下載| 資源專輯| 精品軟件
登錄| 注冊

AFTER-school

  • ICCAVR自動下載程序

    CCAVR軟件有ISP功能,能過調用STK500完成的,只要設置好參數,在ICCAVR中就可以給芯片編程了,還可以讓程序一編譯完就自動下載到芯片中,相當方便。在Tools->environment options->ISP里設定STK500.exe的路徑。— 用于調用STK500程序。在Tools->In system programming 里Programmer Interface中選中STK500?!?選擇STK500下載方式。在Tools->In system programming 里把Auto Program After Compile 的小勾選上。— 編譯后自動編程。在Tools->In system programming 中還有一些設置項,大家可以根據需要進行相關設置。下面的圖片是操作過程。

    標簽: ICCAVR 自動 下載程序

    上傳時間: 2013-11-17

    上傳用戶:joseph

  • CAT823 CAT824 CAT825 帶看門狗和手動復位

    The CAT823, CAT824, and CAT825 provide basic reset and monitoring functions for the electronic systems. Each device monitors the system voltage and maintains a reset output until that voltage reaches the device’s specified trip value and then maintains the reset output active condition until the device’s internal timer, after a minimum timer of 140ms; toallow the systems power supply to stabilize.

    標簽: CAT 823 824 825

    上傳時間: 2014-11-18

    上傳用戶:BOBOniu

  • A Single-Chip Pulsoximeter Des

    This application report discusses the design of non-invasive optical plethysmographyalso called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). Thepulsoximeter consists of a peripheral probe combined with the MCU displaying theoxygen saturation and pulse rate on a LCD glass. The same sensor is used for bothheart-rate detection and pulsoximetering in this application. The probe is placed on aperipheral point of the body such as a finger tip, ear lobe or the nose. The probeincludes two light emitting diodes (LEDs), one in the visible red spectrum (660nm) andthe other in the infrared spectrum (940nm). The percentage of oxygen in the body isworked by measuring the intensity from each frequency of light after it transmitsthrough the body and then calculating the ratio between these two intensities.

    標簽: Pulsoximeter Single-Chip Des

    上傳時間: 2013-10-27

    上傳用戶:黑漆漆

  • Replacement of NXP PCA9518 wit

    The outputs of the PCA9518 are immediately available as soon as there is a voltage present on thesupply >~1V and behave as described above. The power-on reset of the PCA9518A keeps the outputsturned off during power-up and maintains the high impedance of the outputs throughout the power-upcycle. There is an additional built-in delay after power-up that allows the analog circuits to stabilize beforethe part is activated.

    標簽: Replacement 9518 NXP PCA

    上傳時間: 2013-10-26

    上傳用戶:13817753084

  • Clocking Options for Stellaris

    The main oscillator allows either a crystal or single-ended input clock signal. Cost-sensitiveapplications typically use an external crystal with the on-chip oscillator circuit since it is the mostcost-effective solution. It is also possible to use the internal oscillator to clock the device after theboot process has completed.

    標簽: Stellaris Clocking Options for

    上傳時間: 2013-10-14

    上傳用戶:pol123

  • 基于8086 CPU 的單芯片計算機系統的設計

    本文依據集成電路設計方法學,探討了一種基于標準Intel 8086 微處理器的單芯片計算機平臺的架構。研究了其與SDRAM,8255 并行接口等外圍IP 的集成,并在對AMBA協議和8086 CPU分析的基礎上,采用遵從AMBA傳輸協議的系統總線代替傳統的8086 CPU三總線結構,搭建了基于8086 IP 軟核的單芯片計算機系統,并實現了FPGA 功能演示。關鍵詞:微處理器; SoC;單芯片計算機;AMBA 協議 Design of 8086 CPU Based Computer-on-a-chip System(School of Electrical Engineering and Automation, Heifei University of Technology, Hefei, 230009,China)Abstract: According to the IC design methodology, this paper discusses the design of one kind of Computer-on-a-chip system architecture, which is based on the standard Intel8086 microprocessor,investigates how to integrate the 8086 CPU and peripheral IP such as, SDRAM controller, 8255 PPI etc. Based on the analysis of the standard Intel8086 microprocessor and AMBA Specification,the Computer-on-a-chip system based on 8086 CPU which uses AMBA bus instead of traditional three-bus structure of 8086 CPU is constructed, and the FPGA hardware emulation is fulfilled.Key words: Microprocessor; SoC; Computer-on-a-chip; AMBA Specification

    標簽: 8086 CPU 單芯片 計算機系統

    上傳時間: 2013-12-27

    上傳用戶:kernor

  • 帶通濾波器設計計算

    摘 要:用一種新的思路和方法,先計算低通、再計算高通濾波器的有關參數,然后組合成帶通濾波器.關鍵詞:濾波器;參數;新思路中圖分類號: TN713. 5  文獻識別碼:B  文章編號:1008 - 1666 (1999) 04 - 0089 - 03A New Consideration of the Band Filter’s CalculationGuo Wencheng( S hao Yang B usiness and Technology school , S haoyang , Hunan ,422000 )Abstract :This essay deals with a new method of calculating the band filters - first calculatingthe relevant parameters of low - pass filters ,then calculating the ones of high - pass filters.Key words :filter ; parameters ;new considercation八十年代后,信息產業得到了迅猛發展. 帶通濾波器在微波通信、廣播電視和精密儀器設備中得到了廣泛應用. 帶通濾波器性能的優劣,對提高接收機信噪比,防止鄰近信道干擾,提高設備的技術指標,有著十分重要的意義.我在長期的教學實踐中,用切比雪夫型方法設計、計算出寬帶濾波器集中參數元件的數據. 該濾波器可運用在檢測微波頻率的儀器和其他設備中. 再將其思路和計算方法介紹給大家,供參考.

    標簽: 帶通濾波器設計 計算

    上傳時間: 2014-12-28

    上傳用戶:Yukiseop

  • XAPP694-從配置PROM讀取用戶數據

    This application note describes how to retrieve user-defined data from Xilinx configurationPROMs (XC18V00 and Platform Flash devices) after the same PROM has configured theFPGA. The method to add user-defined data to the configuration PROM file is also discussed.The reference design described in this application note can be used in any of the followingXilinx FPGA architectures: Spartan™-II, Spartan-IIE, Spartan-3, Virtex™, Virtex-E, Virtex-II,and Virtex-II Pro.

    標簽: XAPP PROM 694 讀取

    上傳時間: 2013-11-11

    上傳用戶:zhouli

  • XAPP719 -利用USR_ACCESS寄存器實現PowerPC高速緩存配置

    The Virtex™-4 user access register (USR_ACCESS_VIRTEX4) is a 32-bit register thatprovides direct access to bitstream data by the FPGA fabric. It is useful for loadingPowerPC™ 405 (PPC405) processor caches and/or other data into the FPGA after the FPGAhas been configured, thus achieving partial reconfiguration. The USR_ACCESS_VIRTEX4register is programmed through the bitstream with a command that writes a series of 32-bitwords.

    標簽: USR_ACCESS PowerPC XAPP 719

    上傳時間: 2013-11-13

    上傳用戶:我累個乖乖

  • 基于FPGA+DSP模式的智能相機設計

    針對嵌入式機器視覺系統向獨立化、智能化發展的要求,介紹了一種嵌入式視覺系統--智能相機?;趯χ悄芟鄼C體系結構、組成模塊和圖像采集、傳輸和處理技術的分析,對國內外的幾款智能相機進行比較。綜合技術發展現狀,提出基于FPGA+DSP模式的硬件平臺,并提出智能相機的發展方向。分析結果表明,該系統設計可以實現脫離PC運行,完成圖像獲取與分析,并作出相應輸出。 Abstract:  This paper introduced an embedded vision system-intelligent camera ,which was for embedded machine vision systems to an independent and intelligent development requirements. Intelligent camera architecture, component modules and image acquisition, transmission and processing technology were analyzed. After comparing integrated technology development of several intelligent cameras at home and abroad, the paper proposed the hardware platform based on FPGA+DSP models and made clear direction of development of intelligent cameras. On the analysis of the design, the results indicate that the system can run from the PC independently to complete the image acquisition and analysis and give a corresponding output.

    標簽: FPGA DSP 模式 智能相機

    上傳時間: 2013-10-24

    上傳用戶:bvdragon

主站蜘蛛池模板: 陵川县| 广元市| 汉沽区| 塔河县| 莱西市| 肇东市| 周口市| 万全县| 通山县| 泊头市| 惠东县| 电白县| 闽侯县| 浦东新区| 涡阳县| 大丰市| 全椒县| 双牌县| 若尔盖县| 阳高县| 郸城县| 砀山县| 浑源县| 阳泉市| 丽江市| 封丘县| 蓬莱市| 兰西县| 黔东| 尚义县| 石泉县| 彭泽县| 嵩明县| 松潘县| 祁阳县| 八宿县| 汾阳市| 无极县| 保康县| 腾冲县| 财经|