AWGN with BFSK and AMPS
上傳時間： 2015-08-13
上傳用戶：yulg
A case study on D-AMPS 1900 channels. An exact analytical expression for the tracking MSE on two-tap FIR channels is presented and utilized.
標簽： analytical expression channels tracking
上傳時間： 2013-12-01
上傳用戶：edisonfather
milli AMPS meter using atmega8
上傳時間： 2017-09-18
上傳用戶：cuiyashuo
This application note is an overview discussion of theLinear Technology SPICE macromodel library. It assumeslittle if any prior knowledge of this software library or itshistory. However, it does assume familiarity with both theanalog simulation program SPICE (or one of its manyderivatives), and modern day op AMPS, including bipolar,JFET, and MOSFET amplifier technologies
上傳時間： 2013-11-14
上傳用戶：zhanditian
Following chapter introduces the mobile communication, gives a short history of wireless communication evolution, and highlights some application scenarios predestined for the use of mobile devices. Cellular and wireless based systems related to different generations of mobile communication, including GSM, IS-95, PHS, AMPS, D-AMPS, cdma2000 and WCDMA are also described by this Chapter. Much attention in this chapter is given to express the wireless based networks, such as Wi-Fi and WiBro/WiMax, and wireless broadcasting systems, including DMB, DVB-H, and ISDB-T. We conclude the chapter with the future vision of mobile communication evolution
標簽： Technologies Enhanced Access Radio
上傳時間： 2020-05-27
上傳用戶：shancjb
The third generation (3G) mobile communication system is the next big thing in the world of mobile telecommunications. The first generation included analog mobile phones [e.g., Total Access Communications Systems (TACS), Nordic Mobile Telephone (NMT), and Advanced Mobile Phone Service (AMPS)], and the second generation (2G) included digital mobile phones [e.g., global system for mobile communications (GSM), personal digital cellular (PDC), and digital AMPS (D-AMPS)]. The 3G will bring digital multimedia handsets with high data transmission rates, capable of providing much more than basic voice calls.
標簽： Communications Introduction Mobile 3G to
上傳時間： 2020-05-27
上傳用戶：shancjb
Wherever possible the overall technique used for this series will be "definition by example" withgeneric formulae included for use in other applications. To make stability analysis easy we will usemore than one tool from our toolbox with data sheet information, tricks, rules-of-thumb, SPICESimulation, and real-world testing all accelerating our design of stable operational amplifier (op amp)circuits. These tools are specifically targeted at voltage feedback op AMPS with unity-gain bandwidths<20 MHz, although many of the techniques are applicable to any voltage feedback op amp. 20 MHz ischosen because as we increase to higher bandwidth circuits there are other major factors in closing theloop: such as parasitic capacitances on PCBs, parasitic inductances in capacitors, parasitic inductancesand capacitances in resistors, etc. Most of the rules-of-thumb and techniques were developed not justfrom theory but from the actual building of real-world circuits with op AMPS <20 MHz.
標簽： 運算放大器
上傳時間： 2021-11-01
上傳用戶：
為了實時檢測血氧量,能使缺氧特別敏感的腦組織或心臟類疾病患者得到及時治療,采用近紅外雙波長透射式光電脈搏血氧測定法,以H橋電路對發射光源進行控制及通用運算放大器搭建濾波電路。運用參數理論計算和計算機仿真結果相對比的方法,通過Mu ltisim軟件對所設計電路進行仿真,仿真結果與理論參數計算相吻合,證明了電路參數設計的可行性,為血氧儀的實物制作提供參考。For real-time detection of oxygen saturation for timely treatment of the brain or heart,which are very sensitive to oxygen inadequacy,the near-infrared wavelengths double photoelectric pulse oximeter transmission method is adopted.The illuminant is controlled with the H bridge circuit and the filter circuit is built with general op-AMPS.Parameters by theoretical calculation is compared with the computer simulation results in Multisim and satisfactory results are obtained.It is shown that the design of the circuit parameters is feasible and can be a help in making the physical blood-oxygen monitor.
上傳時間： 2022-05-12
上傳用戶：
