為滿足無線網絡技術具有低功耗、節點體積小、網絡容量大、網絡傳輸可靠等技術要求，設計了一種以MSP430單片機和CC2420射頻收發器組成的無線傳感節點。通過分析其節點組成，提出了ZigBee技術中的幾種網絡拓撲形式，并研究了ZigBee路由算法。針對不同的傳輸要求形式選用不同的網絡拓撲形式可以盡大可能地減少系統成本。同時針對不同網絡選用正確的ZigBee路由算法有效地減少了網絡能量消耗，提高了系統的可靠性。應用試驗表明，采用ZigBee方式通信可以提高傳輸速率且覆蓋范圍大，與傳統的有線通信方式相比可以節約40%左右的成本。 Abstract: To improve the proposed technical requirements such as low-ower， small nodes， large capacity and reliable network transmission， wireless sensor nodes based on MSP430 MCU and CC2420 RF transceiver were designed. This paper provided network topology of ZigBee technology by analysing the component of the nodes and researched ZigBee routing algorithm. Aiming at different requirements of transmission mode to choose the different network topologies form can most likely reduce the system cost. And Aiming at different network to choose the correct ZigBee routing algorithm can effectively reduced the network energy consumption and improved the reliability of the system. Results show that the communication which used ZigBee mode can improve the transmission rate， cover more area and reduce 40% cost compared with traditional wired communications mode.
上傳時間： 2013-10-09
上傳用戶：robter
針對UHF讀寫器設計中，在符合EPC Gen2標準的情況下，對標簽返回的高速數據進行正確解碼以達到正確讀取標簽的要求，提出了一種新的在ARM平臺下采用邊沿捕獲統計定時器數判斷數據的方法，并對FM0編碼進行解碼。與傳統的使用定時器定時采樣高低電平的FM0解碼方法相比，該解碼方法可以減少定時器定時誤差累積的影響；可以將捕獲定時器數中斷與數據判斷解碼相對分隔開，使得中斷對解碼影響很小，實現捕獲與解碼的同步。通過實驗表明，這種方法提高了解碼的效率，在160 Kb/s的接收速度下，讀取一張標簽的時間約為30次/s。 Abstract: Aiming at the requirement of receiving correctly decoded data from the tag under high-speed communication which complied with EPC Gen2 standard in the design of UHF interrogator， the article introduced a new technology for FM0 decoding which counted the timer counter to judge data by using the edge interval of signal capture based on the ARM7 platform. Compared with the traditional FM0 decoding method which used the timer timed to sample the high and low level， the method could reduce the accumulation of timing error and could relatively separate capture timer interrupt and the data judgment for decoding， so that the disruption effect on the decoding was small and realizd synchronization of capture and decoding. Testing result shows that the method improves the efficiency of decoding， at 160 Kb/s receiving speed， the time of the interrogator to read a tag is about 30 times/s.
上傳時間： 2013-11-10
上傳用戶：liufei
At recent major international conferences on wireless communications, there have been several sessions on beyond third generation (3G) or fourth generation(4G)mobilecommunicationssystems,wheremodulation/demod- ulation and multiplexing/multiple access schemes related to multicarrier techniques have drawn a lot of attention. We often met at the conference venuesandrealizedthatnobookcoveredthebasicsofmulticarriertechniques to recent applications Aiming at the 4G systems. Therefore, we decided to write a book on multicarrier techniques for 4G mobile communications systems.
標簽： Communications Multicarrier Techniques Mobile for 4G
上傳時間： 2020-05-31
上傳用戶：shancjb
This paper presents a Hidden Markov Model (HMM)-based speech enhancement method, Aiming at reducing non-stationary noise from speech signals. The system is based on the assumption that the speech and the noise are additive and uncorrelated. Cepstral features are used to extract statistical information from both the speech and the noise. A-priori statistical information is collected from long training sequences into ergodic hidden Markov models. Given the ergodic models for the speech and the noise, a compensated speech-noise model is created by means of parallel model combination, using a log-normal approximation. During the compensation, the mean of every mixture in the speech and noise model is stored. The stored means are then used in the enhancement process to create the most likely speech and noise power spectral distributions using the forward algorithm combined with mixture probability. The distributions are used to generate a Wiener filter for every observation. The paper includes a performance evaluation of the speech enhancer for stationary as well as non-stationary noise environment.
標簽： Telecommunications Processing Signal for
上傳時間： 2020-06-01
上傳用戶：shancjb
We are very pleased to introduce the proceedings of the First EAI International Conference on Smart Grid Inspired Future Technologies (SmartGIFT 2016). This was the first SmartGIFT conference, Aiming to create a forum for researches, developers, and practitioners from both academia and industry to publish their key results and to disseminate state-of-the-art concepts and techniques in all aspects of smart grids. The 37 scientific participants had many fruitful discussions and exchanges that contributed to the success of the conference. Participants from 12 countries made the conference truly international in scope.
標簽： Technologies Inspired Future Smart Grid
上傳時間： 2020-06-07
上傳用戶：shancjb
針對交流電路過零檢測電路存在結構復雜、過零點檢測不準確、編程繁瑣等問題，設計了一種基于LM339的硬件結構簡單的過零檢測電路。通過仿真軟件Mulisim對該設計電路進行了仿真，實驗證明了該方案過零檢測的可行性、穩定性和可靠性，可直接作為交流電路中CPU的過零信號。Aiming at the problems of AC cilsuit zero crossing detection circuit such as complex structure, zero crossing detection and cumbersome programming, a zero crossing detection circuit with simple hardware structure based on LM339 was designed. The design circuit was simulated by simulation software Mulisim, and the feasibility, stability and reliability of zero crossing detection were proved by experiments, which can be used as zero crossing signal of CPU in AC circuit directly.
上傳時間： 2022-05-03
上傳用戶：
