成人乱码手机视频,欧美韩日一区,欧美激情一级精品国产

BLUE-small

基于51單片機的電子時鐘(DS1302)設計

1、設計任務：設計一個能夠顯示年月日及時分秒的電子時鐘。 2、要求：利用單片機芯片AT89C52，和DS1302芯片，使得數碼管7SEG-MP X8-A-BLUE顯示年月日和時間，時間和年月日分開顯示，屏幕顯示時間。單片機電子時鐘

標簽： 1302 DS 51單片機電子時鐘

上傳時間： 2014-11-30

上傳用戶：xianglee
基于瑞薩電子微控制器的溫度控制系統設計

　　為了提高傳統溫度控制系統的性能，將PID控制理論與嵌入式系統相結合，采用瑞薩電子公司的H8S/2166作為核心處理器，AD公司的AD7705以及熱敏電阻溫度傳感器作為溫度檢測單元，利用4×6小鍵盤、LCD顯示器和S1D13305液晶控制器達到良好的人機交互，設計出了一個應用于化工領域的嵌入式實時溫度控制系統。相比于傳統溫度控制系統，該系統提供了更強的計算能力和可擴展能力，采用增量PID控制算法實現復雜控制。通過實驗，該系統能達到0.1 ℃的溫度控制精度以及小于120 s的溫度穩定時間。　　Abstract: 　　In order to improve the performance of conventional temperature control system， combining PID control theory with embedded systems， using the Renesas Electronics Corp. H8S/2166 micro-controller as a core processors， AD7705 and thermistor temperature sensor as a temperature detection unit and 4×6 small keyboard， LCD and S1D13305 LCD controller as a good human-computer interaction， this paper designed an embedded real-time temperature control system which is applied in chemical industry. Compared with conventional temperature control system， this system provides more computing power and extensibility， and adopts PID control algorithm for complex control. Through the experiment， the system can reach temperature control accuracy of 0.1 ℃ and temperature stabilization time of less than 120 seconds.

標簽： 瑞薩電子微控制器溫度控制系統設計

上傳時間： 2014-12-26

上傳用戶：003030
基于MAX7219的LED數碼顯示驅動電路設計

　　現有基于MAX7219芯片的數碼管驅動電路只適用于小尺寸LED，為擴展其使用范圍，在介紹動態顯示芯片MAX7219功能的基礎上，提出了一個基于該芯片的8位高亮度8英寸數碼管驅動電路。電路保留了MAX7219芯片的功能強大、編程簡單等優點，通過74LS273鎖存器和ULN2803達林頓驅動器，實現了對任意大尺寸數碼管提供較高電壓和電流驅動的靜態顯示，并亮度可調。　　Abstract: 　　The existing display-driving circuit based on MAX7219 was only applicable to small-size LED. To expand its use, based on the function introduction of dynamic display chip MAX7219, a display-driving circuit for high-brightness 8-bit LED with the size of 8-inch was proposed. The advantages of MAX7219 were retained, such as powerful function and simple programming. Static display with adjustable brightness for large-size LED with higher voltage and current was achieved with the help of 74LS273 and ULN2803.

標簽： 7219 MAX LED 數碼顯示

上傳時間： 2013-10-23

上傳用戶：31633073
基于ARM單片機的自動測高測距小車

生活中許多目標的高度和水平距離需要進行測量。目前主要的測量方法，仍以傳統的皮尺丈量為主，測量效率不高，有時還很不方便，沒有技術成熟的數字式測高測距產品。以基本的數學方法為理論依據，利用遙控小車做為載體，采用角度傳感器測量角度、霍爾傳感器測量水平距離等，通過單片機LM3S615進行數據計算，實現了對待測目標物體的高度、水平距離等數據的快速、精確和數字式的測量，高度測量精度可達99.06%，水平測量精度則可達98.06%。 Abstract: In our lives， the height and horizontal distance of some goals are needed to be measured. Because the currently used methods are still traditional tape-based measuring methods， and the measuring efficiency is low and inconvenient so some kinds of digital and portable measuring methods or instruments are needed. Based on the basic math theory， this paper designed and manufactured a portable， digital and remote controlled measuring mobile small vehicle， which assembled with angle measuring sensor for angle measurement and Hall sensor for horizontal distance measuring. MCU LM3S615 calculated the height and horizontal distance data gotten from these sensors. The measuring process is simple， the measuring results are more accurate and the measuring efficiency is higher than traditional measure instruments. The accuracy of height and distance measurement can reach 99.06% and 98.06%.

標簽： ARM 單片機自動

上傳時間： 2013-10-30

上傳用戶：jackandlee
基于MSP430F247和TMP275的測溫儀

介紹了一種TI公司最新推出的MSP430F247單片機，利用它自帶的I2C模塊驅動I2C總線的溫度傳感器TMP275。TMP275是一款具有高精度、低功耗的新型溫度傳感器。由于TMP275具有可編程功能，纖小的封裝以及極大的溫度范圍，因而廣泛應用于組建超小型溫度測量裝置。 Abstract: A new single chip microcomputer MSP430F247 which is released by TI is introduced.It can drive I2C interface digital temperature sensor TMP275 with I2C module.TMP275 is a new temperature sensor which has high accurate,low power. Because TMP275 has programmable function,small packages and wide temperature range,it is applied widely in very little temperature measurment equipment.

標簽： 430F F247 MSP 430

上傳時間： 2013-12-06

上傳用戶：asdfasdfd
基于單總線器件DS18B20的溫度測量儀

針對目前采用的熱敏電阻測量方法，提出了采用單總線數字式溫度傳感器DS18B20和單片機組成的新型溫度測量儀。介紹DS18B20的結構和工作原理，以及單總線工作原理，給出了由Mega8單片機和DS18B20構成的單總線溫度測量儀的硬件電路及軟件流程圖。經試驗基于單總線器件DS18B20的溫度測量儀，具有測量準確、測溫范圍寬、體積小、控制方便等優點。 Abstract: This paper brings forward a new temperature meter composed of 1-Wire temperature sensor DS18B20 and MCU which has advantage of the thermistor. In the article, the DS18B20＇s structure and controlling principles are introduced and hardware circuit and software diagram of the temperature meter are given.After been tested,the temperature meter has the advantages of accurate measurement, wide temperature range, small volume and convenient controlling.

標簽： 18B B20 DS 18

上傳時間： 2013-10-31

上傳用戶：hzy5825468
基于MSP430F149的智能電池巡檢系統的設計

介紹了電力操作電源與智能電池巡檢系統的特點，給出了一種基于超低功耗單片機MSP430 F149針對中小型變電站自動化運行的專用設備的基本設計原理及實現方法，最后給出了詳細硬件構成和軟件實現。該系統能滿足中小型變電站安全、可靠、自動運行的要求，并通過與上位機的串行通信實現變電站的遠程管理和控制。 Abstract: The characters of the intelligent battery data logging system of the electric operation power are introduced.The basic design principle and the implemented methods of the special equipment which only designed for the middle or small transformer substation based on MSP430F149 are prescribed. Finally, the hardware block diagram and the software flow chart are also given. The function that the system finally needs to realize can basically meet with the middle or small transformer substation’s satisfy, reliably,and automatic running.And it can also realize the transformer substation long-distance management and control by serial communicating with the host computer.

標簽： 430F F149 MSP 430

上傳時間： 2013-11-25

上傳用戶：黃華強
基于ADuC841的膜片鉗放大器系統設計

為降低成本和解決現有膜片鉗放大器系統中PC機的干擾問題，研究了一種基于單片機的膜片鉗放大器小系統。該系統采用ADI公司生產的ADuC841作為控制核心，并且配置相應的液晶顯示模塊LCM3202401。模擬電路部分采用高輸入阻抗的AD8627實現微電流信號的采集，并由后級電路進行信號的放大和電阻電容的補償。它具有硬件電路簡單、體積小、使用方便的特點。既可以單獨作為小系統實現采集和顯示，也可以通過紅外方式和PC機進行通訊，在PC機上進行信號的處理。 Abstract: In order to reduce cost and resolve the interferential problem with PC in existing patch clamp amplifiers, a small patch clamp amplifier system design based on microcontroller is studied. It adopts a new high performance microconverter ADuC841 by the ADI as the control core in the system, configuring a liquid crystal module LCM3202401. In the analog circuit, AD8627 with high input impedance is used to detect the low current，signal magnification, as well as resistance and capacitance compensation are accomplished by subsequent circuits. It has the advantage of simple hardware circuit design, small volume and convenient operation. It can either be used as an independent system to measure and show signal detected or transmit to PC by infrared ray.

標簽： ADuC 841 膜片鉗放大器

上傳時間： 2013-11-06

上傳用戶：yy_cn
基于C8051F系列單片機的無線收發電路設計

基于幅移鍵控技術ASK（Amplitude-Shift Keying），以C8051F340單片機作為監測終端控制器，C8051F330D單片機作為探測節點控制器，采用半雙工的通信方式，通過監控終端和探測節點的無線收發電路，實現數據的雙向無線傳輸。收發電路采用直徑為0.8 mm的漆包線自行繞制成圓形空心線圈天線，天線直徑為（3.4±0.3）cm。試驗表明，探測節點與監測終端的通信距離為24 cm，通過橋接方式，節點收發功率為102 mW時，節點間的通信距離可達20 cm。與傳統無線收發模塊相比，該無線收發電路在受體積、功耗、成本限制的場合有廣闊的應用前景。 Abstract: Based on ASK technology and with the C8051F340 and C8051F330D MCU as the controller， using half-duplex communication mode， this paper achieves bi-directional data transfer. Transceiver circuit constituted by enameled wire which diameter is 0.8mm and wound into a diameter （3.4±0.3） cm circular hollow coil antenna. Tests show that the communication distance between detection and monitoring of the terminal is 24cm，the distance is up to 20cm between two nodes when using the manner of bridging and the node transceiver power is 102mW. Compared with the conventional wireless transceiver modules， the circuit has wide application prospect in small size， low cost and low power consumption and other characteristics.

標簽： C8051F 單片機無線收發電路設計

上傳時間： 2013-10-19

上傳用戶：xz85592677
基于ROM單片機的漢字輸入法的實現

在需要實時大量輸入漢字的顯示控制處理應用中，利用傳統單片機實現顯示控制的設計方法是較難實現的。帶漢字字庫的液晶模塊的使用使得小容量ROM單片機的大量漢字信息輸入與顯示成為可能。提出了針對漢字字庫編碼的二級索引拼音輸入檢索方法,介紹了以ST7920作為控制器的帶漢字字庫的液晶顯示模塊的接口方法及漢字顯示和控制原理，給出了通用計算機鍵盤在單片機中的串行接口，采用該技術可大大增強單片機的漢字輸入功能。為小容量ROM單片機的大批量漢字信息處理提供了一種漢字輸入解決方案。 Abstract: It is difficult to realize Chinese characters input method based on the embedded system by using the traditional design method of display control. It is possible to input and display Chinese characters based on the embedded system with the ROM of small content by using the LCD module with Chinese characters.Chinese characters input method of the quadric index recall in allusion to Chinese characters code is brought forward.The interface and the principle of Chinese characters display control based on the LCD module controlled with the ST7920 is introduced too.The serial interface of the computer keyboard in common use and the embedded system is given at the same time. It can enhance the embedded system function of Chinese characters input by using this technology, and provide a kind of Chinese characters input scheme for the embedded system with small capacity ROM.

標簽： ROM 單片機漢字輸入法

上傳時間： 2013-11-19

上傳用戶：jhksyghr