The PCA9534 is a 16-pin CMOS device that provide 8 bits of General Purpose parallel Input/Output (GPIO) expansion for I2C-bus/SMBus applications and was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders. The improvements include higher drive capability, 5 V I/O tolerance, lower supply current, individual I/O configuration, 400 kHz clock frequency, and smaller packaging. I/O expanders provide a simple solution when additional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.
上傳時間： 2013-11-17
上傳用戶：vodssv
SAE J1939協議是由汽車工程協會(SAE)定義的，SAE J1939協議在商用車輛、艦船、軌道機車、農業機械和大型發動機中是應用最廣泛的應用層協議，基于傳輸可靠性能優越的CAN-bus總線，可達到250Kbps的通訊速率。在協議中，不僅指定了傳輸類型、報文結構及其分段、流量檢查等，而且報文內容本身也做了精確的定義，SAE J1939協議由美國SAE( Society of Automotive Engineer)組織維護和推廣
上傳時間： 2013-12-02
上傳用戶：lyson
The CAT25128 is a 128−Kb Serial CMOS EEPROM device internally organized as 16Kx8 bits. This features a 64−byte page write buffer and supports the Serial Peripheral Interface (SPI) protocol. The device is enabled through a Chip Select (CS) input. In addition, the required bus signals are clock input (SCK), data input (SI) and data output (SO) lines. The HOLD input may be used to pause any serial communication with the CAT25128 device. The device featuressoftware and hardware write protection, including partial as well as full array protection.
上傳時間： 2013-11-15
上傳用戶：fklinran
1.1 微型計算機的組成及工作原理1.1.1 微型計算機中的基本概念1. 微處理器2. 微型計算機 (1)單片微處理機 (2)通用微型計算機3. 微型計算機系統1.1.2 微機基本結構 微型計算機的基本組成如圖1.1所示，它由中央處理器（CPU）、存儲器（Memory）、輸入輸出接口（I/O接口）和系統總線（BUS）構成。 1.1.3 微型計算機的基本工作過程 微型計算機的基本工作過程是執行程序的過程，也就是CPU自動從程序存放的第1個存儲單元起，逐步取出指令、分析指令，并根據指令規定的操作類型和操作對象，執行指令規定的相關操作。如此重復，周而復始，直至執行完程序的所有指令，從而實現程序的基本功能，這就是微型計算機的基本工作原理。 1.2 典型單片機產品簡介1.2.1 MCS-51單片機系列 MCS-51可分為兩個子系列和4種類型，如表1-1所示。按資源的配置數量，MCS-51系列分為51和52兩個子系列，其中51子系列是基本型，而52子系列屬于增強型。表1-1 MCS-51系列單片機分類
上傳時間： 2013-11-07
上傳用戶：debuchangshi
HCS12微控制器MC9S12DP256 第一步： 1) HCS12 技術概述2) Operating Modes工作模式3) Resource Mapping資源映射4) External Bus Interface外部總線接口5) Port Integration Module端口集成模塊6) Background Debug Mode背景調試模塊
上傳時間： 2013-12-20
上傳用戶：源碼3
The PCA82C250 and PCA82C251 are advanced transceiver products for use in automotive and general industrialapplications with transfer rates up to 1 Mbit/s. They support the differential bus signal representation beingdescribed in the international standard for in-vehicle CAN high-speed applications (ISO 11898). Controller AreaNetwork (CAN) is a serial bus protocol being primarily intended for transmission of control related data between anumber of bus nodes.
上傳時間： 2013-11-24
上傳用戶：Alick
The PCA9516 is a BiCMOS integrated circuit intended forapplication in I2C and SMBus systems.While retaining all the operating modes and features of the I2Csystem, it permits extension of the I2C-bus by buffering both the data(SDA) and the clock (SCL) lines, thus enabling five buses of 400 pF.The I2C-bus capacitance limit of 400 pF restricts the number ofdevices and bus length. Using the PCA9516 enables the systemdesigner to divide the bus into five segments off of a hub where anysegment to segment transition sees only one repeater delay.
上傳時間： 2013-11-21
上傳用戶：q123321
The PCA9517 is a CMOS integrated circuit that provides level shifting between lowvoltage (down to 0.9 V) and higher voltage (2.7 V to 5.5 V) I2C-bus or SMBus applications.While retaining all the operating modes and features of the I2C-bus system during thelevel shifts, it also permits extension of the I2C-bus by providing bidirectional buffering forboth the data (SDA) and the clock (SCL) lines, thus enabling two buses of 400 pF. Usingthe PCA9517 enables the system designer to isolate two halves of a bus for both voltageand capacitance. The SDA and SCL pins are over voltage tolerant and arehigh-impedance when the PCA9517 is unpowered.
標簽： translating Level 9517 PCA
上傳時間： 2013-12-25
上傳用戶：wsf950131
The PCA9518 is a BiCMOS integrated circuit intended forapplication in I2C and SMBus systems.While retaining all the operating modes and features of the I2Csystem, it permits extension of the I2C-bus by buffering both thedata (SDA) and the clock (SCL) lines, thus enabling virtuallyunlimited buses of 400 pF.
標簽： Expandable 5channel 9518 PCA
上傳時間： 2013-10-23
上傳用戶：dumplin9
The PCA9539; PCA9539R is a 24-pin CMOS device that provides 16 bits of GeneralPurpose parallel Input/Output (GPIO) expansion with interrupt and reset forI2C-bus/SMBus applications and was developed to enhance the NXP Semiconductorsfamily of I2C-bus I/O expanders. I/O expanders provide a simple solution when additionalI/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.
上傳時間： 2013-11-10
上傳用戶：ewtrwrtwe
