David B. Probert, Ph.D. Windows Kernel Development Microsoft Corporation 微軟windows kernel課程的powerpoint
標簽: B. Corporation Development Microsoft
上傳時間: 2013-12-15
上傳用戶:wangyi39
C++ Primer 第三版(Stanley B.Lippman,Josee Lajoie [同作者作品] 潘愛民譯 ) 源代碼
標簽: Lippman Stanley Primer Lajoie
上傳時間: 2013-12-21
上傳用戶:lmeeworm
Program to implement a list data structure in C++ (partial) With debug output for poor-man s animation
標簽: implement structure poor-man Program
上傳時間: 2016-02-02
上傳用戶:litianchu
Ink Blotting One method for escaping from a maze is via ‘ink-blotting’. In this method your starting square is marked with the number ‘1’. All free, valid squares north, south, east and west around the number ‘1‘ are marked with a number ‘2’. In the next step, all free, valid squares around the two are marked with a ‘3’ and the process is repeated iteratively until : The exit is found (a free square other than the starting position is reached on the very edge of the maze), or, No more free squares are available, and hence no exit is possible.
標簽: method ink-blotting Blotting escaping
上傳時間: 2014-12-03
上傳用戶:123啊
利用C++解決CAGD中的一些問題,如B樣條類,畫b樣條曲線的程序
上傳時間: 2013-12-16
上傳用戶:xiaohuanhuan
利用C++解決CAGD中的連續的三次B樣條插值問題
上傳時間: 2013-12-22
上傳用戶:silenthink
Use A/D converter in dspic sleep mode for accurate A/D conversion.
標簽: conversion converter accurate dspic
上傳時間: 2014-01-10
上傳用戶:sevenbestfei
Use A/D channel scan mode in dspic programming
標簽: programming channel dspic scan
上傳時間: 2016-02-03
上傳用戶:bibirnovis
A loopback sample for using SPI in dspic
標簽: loopback sample dspic using
上傳時間: 2016-02-03
上傳用戶:rocketrevenge
A new cable fault location method based on wavelet reconstruction is proposed. In this method the difference between the currents of faulty phase and sound phase under the high voltage pulse excitation is used as the measured signal and is decomposed in multi-scale by wavelet transform, then reconstructed in single scale. Comparing with traditional fault location method by travelling wave, the presented method will not be interfered by the reflected wave from the branch joint of cables or from other positions where the impedances are not matched and not be influenced by fault types, otherwise, the reflected waves can be recognized even the faulty position is near to the measuring terminal, at the same time, the influence of the wave speed uncertainty can be reduced. The correctness of the proposed method is proved by simulation results.
標簽: method reconstruction location proposed
上傳時間: 2016-02-04
上傳用戶:maizezhen