Xilinx FPGAs require at least two power supplies: VCCINTfor core circuitry and VCCO for I/O interface. For the latestXilinx FPGAs, including Virtex-II Pro, Virtex-II and Spartan-3, a third auxiliary supply, VCCAUX may be needed. Inmost cases, VCCAUX can share a power supply with VCCO.The core voltages, VCCINT, for most Xilinx FPGAs, rangefrom 1.2V to 2.5V. Some mature products have 3V, 3.3Vor 5V core voltages. Table 1 shows the core voltagerequirement for most of the FPGA device families. TypicalI/O voltages (VCCO) vary from 1.2V to 3.3V. The auxiliaryvoltage VCCAUX is 2.5V for Virtex-II Pro and Spartan-3, andis 3.3V for Virtex-II.
上傳時間： 2013-10-22
上傳用戶：liu999666
Xilinx Next Generation 28 nm FPGA Technology Overview Xilinx has chosen 28 nm high-κ metal gate (HKMG) highperformance,low-power process technology and combined it with a new unified ASMBL™ architecture to create a new generation of FPGAs that offer lower power and higher performance. These devices enable unprecedented levels of integration and bandwidth and provide system architects and designers a fully programmable alternative to ASSPs and ASICs.
上傳時間： 2014-12-28
上傳用戶：zhang97080564
WP369可擴展式處理平臺-各種嵌入式系統的理想解決方案 ：Delivering unrivaled levels of system performance,flexibility, scalability, and integration to developers,Xilinx's architecture for a new Extensible Processing Platform is optimized for system power, cost, and size. Based on ARM's dual-core Cortex™-A9 MPCore processors and Xilinx’s 28 nm programmable logic,the Extensible Processing Platform takes a processor-centric approach by defining a comprehensive processor system implemented with standard design methods. This approach provides Software Developers a familiar programming environment within an optimized, full featured,powerful, yet low-cost, low-power processing platform.
上傳時間： 2013-10-22
上傳用戶：685
選擇映射法（SLM）和概率類算法都可以降低OFDM （Orthogonal Frequency Division Multiplexing）系統的PAPR（Peak to Average Power Ratio），傳統SLM算法自身較為復雜，但由于其優良的性能，棄之可惜。研究表明，SLM算法和限幅類算法在性能上具有一定的互補性。任何一個算法未必能達到抑制PAPR的理想效果，在深入研究了兩個算法的基礎上，將其優點聯合起來，以達到降低OFDM系統PAPR的目的。最后對聯合改進算法進行了分析與仿真，并驗證了聯合改進算法的有效性和可行性
上傳時間： 2013-11-22
上傳用戶：xinhaoshan2016
大功率，遠距離傳輸wifi模塊
上傳時間： 2014-12-29
上傳用戶：ljt101007
針對飛行模擬器座艙數據采集的復雜性，設計了一種基于以太網分布式的數據采集控制系統，該系統是RCM5700微處理器模塊上的以太網應用。在系統的基礎上具體討論了PoE技術的應用，在傳輸數據的網線上同時提供電流，提出并實現了一種包括輔助電源在內的完整可靠的PoE供電方案。設計采用美國國家半導體的LM5073和LM5576并根據不同的負載情況，進行穩定可靠的電壓轉換，以滿足數據采集電路的要求。實驗結果表明：該設計穩定可靠，滿足低于13 W的采集節點供電要求，提高了模擬器信號采集系統的通用性和標準化程度，避免了以往數據采集節點單獨繁瑣的電源設計。 Abstract: Aiming at the complexity of large avion simulation and controlling，the simulator cabin distribute data collecting and control system was designed. This system is the application of RCM5700 on Ethernet. Based on this system，PoE technique that makes Ethernet can also provide power were expounded with emphasis and included FAUX design the PoE resolution was realized. To achieve the requirement of this system，LM5073 and LM5576 were used to DC-DC switch. From the data of experiment，the design filled the requirement of power-need of node whose power was lower than 13W. The application of the technique can advance the degree of simulation data collections currency and standardization and avoid designing additional power system.
上傳時間： 2013-11-09
上傳用戶：xyipie
This article describes the procedure to configure and program EXAR Corporation’s PowerXR Digital Power devicesvia I2C interface. Details shown here apply to XRP7704/08/40 and XRP7713/14 devices and PowerArchitectsoftware version 3.00.
上傳時間： 2013-10-20
上傳用戶：tianyi223
W-RXM2013基于高性能ASK無線超外差射頻接收芯片 設計，是一款完整的、體積小巧的、低功耗的無線接 收模塊。 模塊采用超高性價比ISM頻段接收芯片設計 主要設定為315MHz-433MHz頻段，標準傳輸速率下接 收靈敏度可達到-115dbm。并且具有行業內同類方案W-RXM2013 Micrel、SYNOXO、PTC等知名品牌的芯片所不具備的超強抗干擾能力。外圍省去10.7M的中頻 器件模塊將芯片的使能腳引出，可作休眠喚醒控制，也可通過電阻跳線設置使能置高控制。 本公司推出該款模塊力求解決客戶開發產品過程中無線射頻部分的成本壓力，為客戶提供 性能卓越價格優勢突出的電子組件。模塊接口采用金手指方式,方便生產及應用。天線輸入部 分可以將接收天線焊接在模塊上面，也可以通過接口轉接至客戶主機板上，應用非常靈活。 優勢應用：機電控制板、電源控制板、高低溫環境數據監測等復雜條件下 的控制指令的無線傳輸。 1.1 基本特性 λ ●省電模式下，低電流損耗 ●方便投入應用 ●高效的串行編程接口 ●工作溫度范圍：﹣40℃～＋85℃ ●工作電壓：2.4~ 5.5 Volts. ●有效頻率：250-348Mhz, 400-464Mhz ●靈敏度高（-115dbm）、功耗低在3.5mA@315MHz應用下 ●待機電流小于1uA，系統喚醒時間5ms（RF Input Power=-60dbm）
上傳時間： 2013-10-08
上傳用戶：dapangxie
Abstract: This reference design provides design ideas for a cost-effective, low-power liquid-level measurement dataacquisition system (DAS) using a compensated silicon pressure sensor and a high-precision delta-sigma ADC. Thisdocument discusses how to select the compensated silicon pressure sensor, suggest system algorithms, and providenoise analyses. It also describes calibration ideas to improve system performance while also reducing complexity andcost.
上傳時間： 2013-10-08
上傳用戶：sjy1991
特點 最高輸入頻率 10KHz 顯示范圍0-9999（一段設定）0至999999累積量 計數速度 50/10000脈波/秒可選擇 輸入脈波具有預設刻度功能 累積量同步（批量）或非同步（批次）計數可選擇 數位化指撥設定操作簡易 計數暫時停止功能 1組報警功能 2:主要規格 脈波輸入型式: Jump-pin selectable current sourcing(NPN) or current sinking (PNP) 脈波觸發電位: HI bias (CMOS) (VIH=7.5V, VIL=5.5V) LO bias (TTL) (VIH=3.7V, VIL=2.0V) 最高輸入頻率: <10KHz (up,down,up/down mode) 輸出動作時間 : 0.1 to 99.9 second adjustable 輸出復歸方式: Manual(N) or automatic (R or C) can be modif 繼電器容量: AC 250V-5A, DC 30V-7A 顯示值范圍: 0-9999（PV,SV） 0-999999(TV) 顯示幕: Red high efficiency LEDs high 7.0mm (.276")(PV,SV) Red high efficiency LEDs high 9.2mm (.36")(TV) 參數設定方式: Touch switches 感應器電源: 12VDC +/-3%(<60mA) 記憶方式: Non-volatile E2PROM memory 絕緣耐壓能力: 2KVac/1 min. (input/output/power) 1600Vdc (input/output) 使用環境條件: 0-50℃(20 to 90% RH non-condensed) 存放環境條件: 0-70℃(20 to 90% RH non-condensed) CE認證: EN 55022:1998/A1:2000 Class A EN 61000-3-2:2000 EN 61000-3-3:1995/A1:2001 EN 55024:1998/A1:2001
上傳時間： 2013-10-24
上傳用戶：wvbxj
