微電腦型單相交流集合式電表（單相二線系統） 特點： 精確度0.25%滿刻度±1位數 可同時量測與顯示交流電壓,電流,頻率,瓦特,(功率因數/視在功率) 交流電壓,電流,瓦特皆為真正有效值(TRMS) 交流電流,瓦特之小數點可任意設定 瓦特單位W或KW可任意設定 CT比可任意設定(1至999) 輸入與輸出絕緣耐壓 2仟伏特/1分鐘( 突波測試強度4仟伏特(1.2x50us) 數位RS-485界面 (Optional) 主要規格： 精確度: 0.1% F.S.±1 digit (Frequency) 0.25% F.S.±1 digit(ACA,ACV,Watt,VA) 0.25% F.S. ±0.25o(Power Factor) (-.300~+.300) 輸入負載: <0.2VA (Voltage) <0.2VA (Current) 最大過載能力: Current related input: 3 x rated continuous 10 x rated 30 sec. 25 x rated 3sec. 50 x rated 1sec. Voltage related input: maximum 2 x rated continuous 過載顯示: "doFL" 顯示值范圍: 0~600.0V(Voltage) 0~999.9Hz(Frequency)(<20% for voltage input) 0~19999 digit adjustable(Current,Watt,VA) 取樣時間: 2 cycles/sec. RS-485通訊位址: "01"-"FF" RS-485傳輸速度: 19200/9600/4800/2400 selective RS-485通信協議: Modbus RTU mode 溫度系數: 100ppm/℃ (0-50℃) 顯示幕: Red high efficiency LEDs high 10.16 mm(0.4") 參數設定方式: Touch switches 記憶型式: Non-volatile E²PROM memory 絕緣抗阻: >100Mohm with 500V DC 絕緣耐壓能力: 2KVac/1 min. (input/output/power) 1600 Vdc (input/output) 突波測試: ANSI c37.90a/1974,DIN-IEC 255-4 impulse voltage 4KV(1.2x50us) 使用環境條件: 0-50℃(20 to 90% RH non-condensed) 存放環境條件: 0-70℃(20 to 90% RH non-condensed) CE認證: EN 55022:1998/A1:2000 Class A EN 61000-3-2:2000 EN 61000-3-3:1995/A1:2001 EN 55024:1998/A1:2001
上傳時間： 2015-01-03
上傳用戶：幾何公差
Abstract: This application note explains how to design an intelligent lighting controller that senses and measures the ambient lightlevel with an ambient light sensor (ALS). Equipped with a real-time clock (RTC), the controller also knows when to turn lighting on oroff at specified times. The system presented in this document can be used to control all luminaires that are mains-supply operated.Controller software is also provided in hex format.
標簽： 智能照明控制器 測量 環境光線
上傳時間： 2013-11-18
上傳用戶：AbuGe
Modern electronic systems solve so many difficult problems that they often seem like magic. Nonetheless, these systems all have thesame basic limitation: they need a source of electrical power! Most of the time this is a straightforward challenge for the electronicdesigner, because there are many power-delivery solutions. Yet sometimes a device has no direct power source, and running wiresor replacing batteries is impractical. Even when long-life batteries are usable, they eventually need to be replaced, which requires aservice call.
標簽： 能量收集
上傳時間： 2015-01-03
上傳用戶：zukfu
The AN10 begins with a survey of methods for measuring op amp settling time. This commentary develops into circuits for measuring settling time to 0.0005%. Construction details and results are presented. Appended sections cover oscilloscope overload limitations and amplifier frequency compensation.
標簽： 運算放大器 穩定時間 測量
上傳時間： 2013-11-14
上傳用戶：JIMMYCB001
在Multisim 10軟件環境下，設計一種由運算放大器構成的精確可控矩形波信號發生器，結合系統電路原理圖重點闡述了各參數指標的實現與測試方法。通過改變RC電路的電容充、放電路徑和時間常數實現了占空比和頻率的調節，通過多路開關投入不同數值的電容實現了頻段的調節，通過電壓取樣和同相放大電路實現了輸出電壓幅值的調節并提高了電路的帶負載能力，可作為頻率和幅值可調的方波信號發生器。Multisim 10仿真分析及應用電路測試結果表明，電路性能指標達到了設計要求。 Abstract: Based on Multisim 10， this paper designed a kind of rectangular-wave signal generator which could be controlled exactly composed of operational amplifier， the key point was how to implement and test the parameter indicators based on the circuit diagram. The duty and the frequency were adjusted by changing the time constant and the way of charging and discharging of the capacitor， the width of frequency was adjusted by using different capacitors provided with multiple switch， the amplitude of output voltage was adjusted by sampling voltage and using in-phase amplifier circuit，the ability of driving loads was raised， the circuit can be used as squarewave signal generator whose frequency and amplitude can be adjusted. The final simulation results of Multisim 10 and the tests of applicable circuit show that the performance indicators of the circuit meets the design requirements.
標簽： Multisim 矩形波 信號發生器 仿真
上傳時間： 2014-01-21
上傳用戶：shen007yue
QX5305 是一款高效率，穩定可靠的高亮度LED燈驅動控制IC，內置高精度比較器，off-time控制電路，恒流驅動控制電路等，特別適合大功率，多個高亮度LED燈串恒流驅動。 QX5305采用固定off-time控制工作方式，其工作頻率可高達2.5MHz，可使外部電感和濾波電容、體積減少，效率提高。 在DIM腳加PWM信號，可調節LED燈的亮度。 通過調節外置的電阻，能控制高亮度LED燈的驅動電流，使LED燈亮度達到預期恒定亮度，流過高亮度LED燈的電流可從幾毫安到2安培變化。 方框圖： 管腳排列圖： QX5305的特性 可編程驅動電流，最高可達2A 高效率：最高達95% 寬輸入電壓范圍：2.5V~36V 高工作頻率：2.5MHz 工作頻率可調：500KHz~2.5MHz 驅動LED燈功能強：LED燈串可從1個到幾十個LED高亮度燈 亮度可調：通過EN端PWM，調節LED燈亮度 QX5305應用范圍 干電池供電LED燈串 LED燈杯 RGB大顯屏高亮度LED燈 平板顯示器LED背光燈 恒流充電器控制 通用恒流源。 工作原理簡述： QX5305 采用峰值電流檢測和固定off-time控制方式。片內的R-S觸發器分別由off-time定時器置位和CS比較器、FB比較復位，它控制外部MOSFET管并和功率電感 L、LED、肖特基二極管共同構成一個自振蕩的，連續電感電流模式的升壓型恒流LED驅動電路（參見圖1）。 除了固定off-time控制這點外，QX5305的工作方式和普通的電流模式PWM控制型DC/DC升壓電路非常相似。當工作在連續電流模式下時，流過功率電感的電流IL如圖所示：
上傳時間： 2013-10-26
上傳用戶：TF2015
TheTool is highy customizable map editor(based on QT) which can be extended via LUA scripts. A first implentation is ready and can be published to the public. The editor is the perfect tool who wants to design some 3d games but don t have time to write
標簽： customizable extended TheTool scripts
上傳時間： 2013-12-12
上傳用戶：lanwei
摘要 ? ? ? ? 設計時的自動化加快了編碼，并保證所有過程都用相同的命名規范和結構來生成。為了在大型 SQL 項目中盡量提高編碼的效率，作者編寫了一系列的設計時（design-time）存儲過程，用它們來生成運行時（run-time）存儲過程，并一直在工程中使用。最近，作者更新了其存儲過程以便使用 SQL Server 2000 的特性，其中包括用戶定義函數。本文所及內容涵蓋創建并執行這些動態 T-SQL 腳本以使普通的數據庫存儲過程編碼自動化。
標簽： 計時 自動化 編碼
上傳時間： 2014-01-11
上傳用戶：遠遠ssad
The Gray Watson debugging malloc library is C source code for a drop in replacement for the system malloc & other memory manage ment routines. What is unique about this library is that it contains a number of powerful debugging facilities including very comprehensive heap testing and ex- cellent run-time debugging information.
標簽： replacement debugging for library
上傳時間： 2015-02-05
上傳用戶：TF2015
dances Act now and you ll be given a free membership to a top Internet firm who is changing people s lives for the better.Mary L. White of LA. stays at home with her children and works just 3 1/2 hours a day... she now earns twice as much money as she did before. Frank Herns Jr. of NY takes 2 vacations a year to the Caribbean and enjoys more time and freedom than ever before. Jane Kennedy of FL fired her boss after 5 months. She finally has the time and money she needs to complete her college education. Craig Garcia of CA tripled his income in just 90 days because took advantage of his free membership.
標簽： membership Internet changing dances
上傳時間： 2015-03-08
上傳用戶：xhz1993
蟲蟲下載站版權所有 京ICP備2021023401號-1
