-
MTK = "Media Tek Inc."
MTK6218 = "6218 USB Modem Driver"
Serial.SvcDesc = "USB Serial Emulation modem driver"
標簽：
Serial
6218
MTK
USB
上傳時間：
2014-08-26
上傳用戶：zhanditian
-
The MSP-FET430U14 is a powerful flash Emulation tool to quickly begin application development on the MSP430 MCU. It includes USB debugging interface used to program and debug the MSP430 in-system through the JTAG interface or the pin saving Spy Bi-Wire (2-wire JTAG) protocol. The flash memory can be erased and programmed in seconds with only a few keystrokes, and since the MSP430 flash is ultra-low power, no external power supply is required.
The debugging tool interfaces the MSP430 to the included integrated software environment and includes code to start your design immediately. The MSP-FET430UIF development tools supports development with all MSP430 flash devices
標簽：
JTAG
MSP
430
USB
上傳時間：
2013-10-28
上傳用戶：13691535575
-
本文依據集成電路設計方法學，探討了一種基于標準Intel 8086 微處理器的單芯片計算機平臺的架構。研究了其與SDRAM，8255 并行接口等外圍IP 的集成，并在對AMBA協議和8086 CPU分析的基礎上，采用遵從AMBA傳輸協議的系統總線代替?zhèn)鹘y(tǒng)的8086 CPU三總線結構，搭建了基于8086 IP 軟核的單芯片計算機系統，并實現了FPGA 功能演示。關鍵詞：微處理器； SoC；單芯片計算機；AMBA 協議
Design of 8086 CPU Based Computer-on-a-chip System（School of Electrical Engineering and Automation, Heifei University of Technology, Hefei, 230009,China）Abstract: According to the IC design methodology, this paper discusses the design of one kind of Computer-on-a-chip system architecture, which is based on the standard Intel8086 microprocessor,investigates how to integrate the 8086 CPU and peripheral IP such as, SDRAM controller, 8255 PPI etc. Based on the analysis of the standard Intel8086 microprocessor and AMBA Specification,the Computer-on-a-chip system based on 8086 CPU which uses AMBA bus instead of traditional three-bus structure of 8086 CPU is constructed, and the FPGA hardware Emulation is fulfilled.Key words: Microprocessor; SoC; Computer-on-a-chip; AMBA Specification
標簽：
8086
CPU
單芯片
計算機系統
上傳時間：
2013-12-27
上傳用戶：kernor
-
The C500 microcontroller family usually provides only one on-chip synchronous serialchannel (SSC). If a second SSC is required, an Emulation of the missing interface mayhelp to avoid an external hardware solution with additional electronic components.The solution presented in this paper and in the attached source files emulates the mostimportant SSC functions by using optimized SW routines with a performance up to 25KBaud in Slave Mode with half duplex transmission and an overhead less than 60% atSAB C513 with 12 MHz. Due to the implementation in C this performance is not the limitof the chip. A pure implementation in assembler will result in a strong reduction of theCPU load and therefore increase the maximum speed of the interface. In addition,microcontrollers like the SAB C505 will speed up the interface by a factor of two becauseof an optimized architecture compared with the SAB C513.Moreover, this solution lays stress on using as few on-chip hardware resources aspossible. A more excessive consumption of those resources will result in a highermaximum speed of the emulated interface.Due to the restricted performance of an 8 bit microcontroller a pin compatible solution isprovided only; the internal register based programming interface is replaced by a set ofsubroutine calls.The attached source files also contain a test shell, which demonstrates how to exchangeinformation between an on-chip HW-SSC and the emulated SW-SSC via 5 external wiresin different operation modes. It is based on the SAB C513 (Siemens 8 bit microcontroller).A table with load measurements is presented to give an indication for the fraction of CPUperformance required by software for emulating the SSC.
標簽：
synchronous
Emulating
serial
上傳時間：
2014-01-31
上傳用戶：z1191176801
-
The LPC2292/2294 microcontrollers are based on a 16/32-bit ARM7TDMI-S CPU with real-time Emulation and embedded trace support, together with 256 kB of embedded high-speed flash memory. A 128-bit wide memory interface and a unique accelerator architecture enable 32-bit code execution at the maximum clock rate. For critical code size applications, the alternative 16-bit Thumb mode reduces code by more than 30 pct with minimal performance penalty.
With their 144-pin package, low power consumption, various 32-bit timers, 8-channel 10-bit ADC, 2/4 (LPC2294) advanced CAN channels, PWM channels and up to nine external interrupt pins these microcontrollers are particularly suitable for automotive and industrial control applications as well as medical systems and fault-tolerant maintenance buses. The number of available fast GPIOs ranges from 76 (with external memory) through 112 (single-chip). With a wide range of additional serial communications interfaces, they are also suited for communication gateways and protocol converters as well as many other general-purpose applications.
Remark: Throughout the data sheet, the term LPC2292/2294 will apply to devices with and without the /00 or /01 suffix. The suffixes /00 and /01 will be used to differentiate from other devices only when necessary.
標簽：
lpc
datasheet
2292
2294
上傳時間：
2014-12-30
上傳用戶：aysyzxzm
-
Applying power to a standard logic chip, SRAM, or EPROM, usually results in output pinstracking the applied voltage as it rises. Programmable logic attempts to emulate that behavior,but physics forbids perfect Emulation, due to the device programmability. It requires care tospecify the pin behavior, because programmable parts encounter unknown variables – yourdesign and your power environment.
標簽：
Xilinx
XAPP
CPLD
440
上傳時間：
2013-11-24
上傳用戶：253189838
-
The TapiComm sample uses both the Telephony API and the Win32 Communications API to demonstrate one way to implement a very simple TTY application. While the user interface and TTY Emulation are very rudimentary, the TAPI and comm modules are fairly complete.
標簽：
Communications
demonstrate
API
Telephony
上傳時間：
2014-12-07
上傳用戶：chenxichenyue
-
Bochs is a highly portable open source IA-32 (x86) PC emulator
written in C++, that runs on most popular platforms. It includes
Emulation of the Intel x86 CPU, common I/O devices, and a custom
BIOS. Currently, Bochs can be compiled to emulate a 386, 486,
Pentium, Pentium Pro or AMD64 CPU, including optional MMX, SSE,
SSE2 and 3DNow! instructions. Bochs is capable of running most
Operating Systems inside the Emulation including Linux, DOS,
Windows 95/98 and Windows NT/2000.
Bochs was written by Kevin Lawton and is currently maintained by
the Bochs project at "http://bochs.sourceforge.net".
標簽：
emulator
portable
written
highly
上傳時間：
2015-04-06
上傳用戶：FreeSky
-
This book describes the following communications applications: Mail, Message Handler( MH), Transmission ControlProtocol/ Internet Protocol(TCP/ IP), Basic Networking Utilities( BNU), and Asynchronous Terminal Emulation( ATE). It provides overviews, concepts, and procedures on receiving and sending mail and messages, transferring files( ftp command), printing files from and to a remote system, running commands on other systems, communicating between local and remote systems, and customizing the communications environment.
標簽：
communications
applications
Transmiss
describes
上傳時間：
2013-12-18
上傳用戶：woshini123456
-
This a USB core stack for
the built-in USB device of LPC214x microcontrollers.
It handles the hardware interface and
USB enumeration/configuration.
Also included are application examples like
a USB joystick HID and USB serial port Emulation.
標簽：
microcontrollers
USB
the
built-in
上傳時間：
2015-11-14
上傳用戶：talenthn
