2012TI杯陜西賽題H題,2012TI杯陜西賽題B題--頻率補償電路.
上傳時間： 2013-10-07
上傳用戶：ysystc670
PSHLY-B回路電阻測試儀介紹
上傳時間： 2013-11-05
上傳用戶：木子葉1
摘要：本文詳細敘述了基于FPGA及單片機K實現時碼終端系統的設計方法，該系統可用于對國際通用時間格式碼IRIG碼（簡稱B碼）的解調，以及產生各種采樣、同步頻率信號，也可作為其它系統的時基和采樣、同步信號的基準。關鍵詞：單片機；IRIG-B格式碼；FPGA；解調；控制；接口
上傳時間： 2013-12-16
上傳用戶：CSUSheep
This white paper discusses how market trends, the need for increased productivity, and new legislation have accelerated the use of safety systems in industrial machinery. This TÜV-qualified FPGA design methodology is changing the paradigms of safety designs and will greatly reduce development effort, system complexity, and time to market. This allows FPGA users to design their own customized safety controllers and provides a significant competitive advantage over traditional microcontroller or ASIC-based designs. Introduction The basic motivation of deploying functional safety systems is to ensure safe operation as well as safe behavior in cases of failure. Examples of functional safety systems include train brakes, proximity sensors for hazardous areas around machines such as fast-moving robots, and distributed control systems in process automation equipment such as those used in petrochemical plants. The International Electrotechnical Commission’s standard, IEC 61508: “Functional safety of electrical/electronic/programmable electronic safety-related systems,” is understood as the standard for designing safety systems for electrical, electronic, and programmable electronic (E/E/PE) equipment. This standard was developed in the mid-1980s and has been revised several times to cover the technical advances in various industries. In addition, derivative standards have been developed for specific markets and applications that prescribe the particular requirements on functional safety systems in these industry applications. Example applications include process automation (IEC 61511), machine automation (IEC 62061), transportation (railway EN 50128), medical (IEC 62304), automotive (ISO 26262), power generation, distribution, and transportation. 圖Figure 1. Local Safety System
上傳時間： 2013-11-05
上傳用戶：維子哥哥
100-Gb光傳送網（OTN）復用轉發器 a. 提供連續數據范圍在600 Mbps到14.1 Gbps之間的串行收發器，通過使用方便的部分重新配置功能支持多標準客戶側接口； b. 44個獨立發送時鐘域，提高了時鐘靈活性； c. 收發器集成電信號散射補償（EDC）功能，可直接驅動光模塊（SFP+、SFP、QSFP、CFP）； d. 支持下一代光接口的28-Gbps收發器； e. 替代外部壓控晶體振蕩器（VCXO）的高級fPLL。
上傳時間： 2013-11-19
上傳用戶：zhyiroy
針對嵌入式機器視覺系統向獨立化、智能化發展的要求，介紹了一種嵌入式視覺系統--智能相機。基于對智能相機體系結構、組成模塊和圖像采集、傳輸和處理技術的分析，對國內外的幾款智能相機進行比較。綜合技術發展現狀，提出基于FPGA+DSP模式的硬件平臺，并提出智能相機的發展方向。分析結果表明，該系統設計可以實現脫離PC運行，完成圖像獲取與分析，并作出相應輸出。 Abstract: This paper introduced an embedded vision system-intelligent camera ，which was for embedded machine vision systems to an independent and intelligent development requirements. Intelligent camera architecture， component modules and image acquisition， transmission and processing technology were analyzed. After comparing integrated technology development of several intelligent cameras at home and abroad， the paper proposed the hardware platform based on FPGA+DSP models and made clear direction of development of intelligent cameras. On the analysis of the design， the results indicate that the system can run from the PC independently to complete the image acquisition and analysis and give a corresponding output.
上傳時間： 2013-10-24
上傳用戶：bvdragon
波長信號的解調是實現光纖光柵傳感網絡的關鍵，基于現有的光纖光柵傳感器解調方法，提出一種基于FPGA的雙匹配光纖光柵解調方法，此系統是一種高速率、高精度、低成本的解調系統，并且通過引入雙匹配光柵有效地克服了雙值問題同時擴大了檢測范圍。分析了光纖光柵的測溫原理并給出了該方案軟硬件設計，綜合考慮系統的解調精度和FPGA的處理速度給出了基于拉格朗日的曲線擬合算法。 Abstract: Sensor is one of the most important application of the fiber grating. Wavelength signal demodulating is the key techniques to carry out fiber grating sensing network， based on several existing methods of fiber grating sensor demodulation inadequate， a two-match fiber grating demodulation method was presented. This system is a high-speed， high precision， low-cost demodulation system. And by introducing a two-match grating effectively overcomes the problem of double value while expands the scope of testing. This paper analyzes the principle of fiber Bragg grating temperature and gives the software and hardware design of the program. Considering the system of demodulation accuracy and processing speed of FPGA，this paper gives the curve fitting algorithm based on Lagrange.
上傳時間： 2014-07-24
上傳用戶：caiguoqing
TKS仿真器B系列快速入門
上傳時間： 2013-10-31
上傳用戶：aix008
為了滿足超聲波探傷檢測的實時性需求，通過研究超聲波探傷的工作原理，提出了基于FPGA芯片的實時信號處理系統實現方案及硬件結構設計，并根據FPGA邏輯結構模型實現了軟件系統的模塊化設計。根據實驗測試及統計數據得出，基于FPGA芯片的信號處理系統提高了探傷檢測的準確性與穩定性，滿足了探傷過程中B超顯示的實時性要求。
上傳時間： 2013-10-23
上傳用戶：731140412
一個簡單好用的B+樹算法實現
上傳時間： 2015-01-04
上傳用戶：縹緲
