The PCA9517 is a CMOS integrated circuit that provides level shifting between lowvoltage (down to 0.9 V) and higher voltage (2.7 V to 5.5 V) I2C-bus or SMBus applications.While retaining all the operating modes and features of the I2C-bus system during thelevel shifts, it also permits extension of the I2C-bus by providing bidirectional buffering forboth the data (SDA) and the clock (SCL) lines, thus enabling two buses of 400 pF. Usingthe PCA9517 enables the system designer to isolate two halves of a bus for both voltageand capacitance. The SDA and SCL pins are over voltage tolerant and arehigh-impedance when the PCA9517 is unpowered.
標簽： translating Level 9517 PCA
上傳時間： 2013-12-25
上傳用戶：wsf950131
The PCA9537 is a 10-pin CMOS device that provides 4 bits of General Purpose parallelInput/Output (GPIO) expansion with interrupt and reset for I2C-bus/SMBus applicationsand was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders.I/O expanders provide a simple solution when additional I/O is needed for ACPI powerswitches, sensors, push-buttons, LEDs, fans, etc.
上傳時間： 2013-10-14
上傳用戶：wuchunzhong
PCA9517 是一款基于CMOS 工藝的低電壓I2C 中繼器，在I2C 總線或SMBus 應用中進行高低電壓轉換。PCA9517 能夠在電平轉換期間保持總線所有的操作模式和特性，通過數據線（SDA）和時鐘線（SCL）的雙向緩存實現I2C 總線擴展，總線最大容性負載為400pF。PCA9517 能夠隔離器件總線兩端的電壓和容性負載。SDA 和SCL 引腳具有過壓保護功能，在掉電的情況下為高阻狀態。
上傳時間： 2013-10-08
上傳用戶：zgz317
The PCA9538 is a 16-pin CMOS device that provides 8 bits of General Purpose parallelInput/Output (GPIO) expansion with interrupt and reset for I2C-bus/SMBus applicationsand was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders.I/O expanders provide a simple solution when additional I/O is needed for ACPI powerswitches, sensors, push-buttons, LEDs, fans, etc.
上傳時間： 2014-01-24
上傳用戶：youmo81
The PCA9539; PCA9539R is a 24-pin CMOS device that provides 16 bits of GeneralPurpose parallel Input/Output (GPIO) expansion with interrupt and reset forI2C-bus/SMBus applications and was developed to enhance the NXP Semiconductorsfamily of I2C-bus I/O expanders. I/O expanders provide a simple solution when additionalI/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.
上傳時間： 2013-11-10
上傳用戶：ewtrwrtwe
PCA9518 是一款采用BiCMOS 工藝的總線集線器，通過它可以擴展I2C 和SMBus 系統。PCA9518 在保持總線操作模式和特性的情況下，通過緩存數據線（SDA）和時鐘線（SCL）的數據實現I2C 總線擴展，使總線最大容性負載為400pF。
上傳時間： 2013-11-16
上傳用戶：黃華強
The PCA9540B is a 1-of-2 bidirectional translating multiplexer, controlled via the I2C-bus.The SCL/SDA upstream pair fans out to two SCx/SDx downstream pairs, or channels.Only one SCx/SDx channel is selected at a time, determined by the contents of theprogrammable control register.
標簽： 2channel 9540B 9540 mult
上傳時間： 2014-12-28
上傳用戶：nshark
The PCA9541 is a 2-to-1 I2C-bus master selector designed for high reliability dual masterI2C-bus applications where system operation is required, even when one master fails orthe controller card is removed for maintenance. The two masters (for example, primaryand back-up) are located on separate I2C-buses that connect to the same downstreamI2C-bus slave devices. I2C-bus commands are sent by either I2C-bus master and are usedto select one master at a time. Either master at any time can gain control of the slavedevices if the other master is disabled or removed from the system. The failed master isisolated from the system and will not affect communication between the on-line masterand the slave devices on the downstream I2C-bus.
標簽： master C-bus 9541 PCA
上傳時間： 2013-10-09
上傳用戶：3294322651
PCA9519 是一個4 通道的I2C 總線/SMBus 中繼器，可以實現將低電壓兩線串行總線接口的處理器與標準的I2C 總線或SMBus I/O 相連。該中繼器在電平轉換中保持I2C 總線系統所有的模式和特點的同時，允許通過給數據總線（SDA）和時鐘總線（SCK）提供雙向緩沖區來擴展I2C 總線，從而使I2C 總線或SMBus 在高電壓下最大容限電容為400PF。SDA 和SCL 引腳具有耐壓保護功能，當PCA9519 掉電時，均呈現出高阻抗特性。
標簽： C-bus SMBus 9519 PCA
上傳時間： 2013-11-23
上傳用戶：brilliantchen
The PCA9542A is a 1-of-2 bidirectional translating multiplexer, controlled via the I2C-bus.The SCL/SDA upstream pair fans out to two SCx/SDx downstream pairs, or channels.Only one SCx/SDx channel is selected at a time, determined by the contents of theprogrammable control register. Two interrupt inputs, INT0 and INT1, one for each of theSCx/SDx downstream pairs, are provided. One interrupt output, INT, which acts as anAND of the two interrupt inputs, is provided.
標簽： 2channel 9542A 9542 mult
上傳時間： 2013-12-07
上傳用戶：europa_lin
蟲蟲下載站版權所有 京ICP備2021023401號-1
