This is a software implementation of the USB Low-speed protocol for
the Atmel ATtiny microcontrollers. Of course, it will also work on the
ATmega series.
USBHostSlave is a USB 1.1 host and Device IP core.
– Supports full speed (12Mbps) and low speed (1.5Mbps) operation.
– USB Device has four endpoints, each with their own independent FIFO.
– Supports the four types of USB data transfer control, bulk, interrupt, and isochronous
transfers.
– Host can automatically generate SOF packets.
– 8-bit Wishbone slave bus interface.
– FIFO depth configurable via paramters.
Abstract: High-speed and Low-speed data converters serve critical functions in modern broadband mobile radios. This application note outlines how todetermine high-speed data converter performance requirements in baseband sampling radio architectures. Also, system partition strategies andadvantages are outlined when considering a high-speed analog front-end (AFE) solution.
SL811開發資料_包含源程序_電路圖_芯片資料:SL811HS Embedded USB Host/Slave Controller.The SL811HS is an Embedded USB Host/Slave Controller capable of communicate with either full-speed or Low-speed USB peripherals. The SL811HS can interface to devices such as microprocessors, microcontrollers, DSPs, or directly to a variety of buses such as ISA, PCMCIA, and others. The SL811HS USB Host Controller conforms to USB Specification 1.1.The SL811HS USB Host/Slave Controller incorporates USB Serial Interface functionality along with internal full-/Low-speed transceivers.The SL811HS supports and operates in USB full-speed mode at 12 Mbps, or at Low-speed 1.5-Mbps mode.The SL811HS data port and microprocessor interface provide an 8-bit data path I/O or DMA bidirectional, with interrupt support to allow easy interface to standard microprocessors or microcontrollers such as Motorola or Intel CPUs and many others. Internally,the SL811HS contains a 256-byte RAM data buffer which is used for control registers and data buffer.The available package types offered are a 28-pin PLCC (SL811HS) and a 48-pin TQFP package (SL811HST-AC). Both packages operate at 3.3 VDC. The I/O interface logic is 5V-tolerant.
with serial bus (Universal Serial Bus) is used to apply USB peripherals connected to the mainframe external bus structure, it is mainly used in medium-speed and Low-speed peripherals
For nearly a hundred years telecommunications provided mainly voice services and very low speed
data (telegraph and telex). With the advent of the Internet, several data services became mainstream
in telecommunications; to the point that voice is becoming an accessory to IP-centric data networks.
Today, high-speed data services are already part of our daily lives at work and at home (web surfing,
e-mail, virtual private networks, VoIP, virtual meetings, chats...). The demand for high-speed data
services will grow even more with the increasing number of people telecommuting.
The SL11RIDE is a low cost, high speed Universal Serial Bus RISC based Controller board. It contains a
16-bit RISC processor with built in SL11RIDE ROM to greatly reduce firmware development efforts. Its
serial flash EEPROM interface offers low cost storage for USB device configuration and customer product
specific functions. New functions can be programmed into the I2C by downloading it from a USB Host
PC. This unique architecture provides the ability to upgrade products, in the field, without changing the
peripheral hardware.
Supplemental information for a high-speed serial bus that integrates well with most IEEE standard
32-bit and 64-bit parallel buses is specified. It is intended to extend the usefulness of a low-cost interconnect
between external peripherals, IEEE Std 1394-1995. This standard follows the ISO/IEC 13213:1994 Command
and Status Register (CSR) architecture.
