<strike id="k464i"></strike>
<table id="k464i"></table> <li id="k464i"></li> MPC7400 Part Number SpeciÞcationThis document describes part number speciÞc changes to recommended operating conditions and revised electrical speciÞcations,as applicable, from those described in the generalMPC7400 Hardware SpeciÞcations.SpeciÞcations provided in this Part Number SpeciÞcation supersede those in theMPC7400 Hardware SpeciÞcationsdated 9/99(order #: MPC7400EC/D) for these part numbers only; speciÞcations not addressed herein are unchanged. This document isfrequently updated, refer to the website at http://www.mot.com/SPS/PowerPC/ for the latest version.Note that headings and table numbers in this data sheet are not consecutively numbered. They are intended to correspond to theheading or table affected in the general hardware speciÞcation.
上傳時間： 2014-12-28
上傳用戶：huyahui
This document describes part number speciÞc changes to recommended operating conditions and revised electrical speciÞcations,as applicable, from those described in the generalMPC7400 Hardware SpeciÞcations.SpeciÞcations provided in this Part Number SpeciÞcation supersede those in theMPC7400 Hardware SpeciÞcationsdated 9/99(order #: MPC7400EC/D) for these part numbers only; speciÞcations not addressed herein are unchanged. This document isfrequently updated, refer to the website at http://www.mot.com/SPS/PowerPC/ for the latest version.Note that headings and table numbers in this data sheet are not consecutively numbered. They are intended to correspond to theheading or table affected in the general hardware speciÞcation.Part numbers addressed in this document are listed in Table A. For more detailed ordering information see Table B.
上傳時間： 2013-11-19
上傳用戶：qiaoyue
I2C interface, is a very powerful tool for system designers. Theintegrated protocols allow systems to be completely software defined.Software development time of different products can be reduced byassembling a library of reusable software modules. In addition, themultimaster capability allows rapid testing and alignment ofend-products via external connections to an assembly-line computer.The mask programmable 87LPC76X and its EPROM version, the87LPC76X, can operate as a master or a slave device on the I2Csmall area network. In addition to the efficient interface to thededicated function ICs in the I2C family, the on-board interfacefacilities I/O and RAM expansion, access to EEPROM andprocessor-to-processor communications.
標簽： microcontro Using 76X LPC
上傳時間： 2013-12-30
上傳用戶：Artemis
winCE msdn講座 XP Embedded Now and the future Windows XP Embedded Developmentand Deployment Model OverviewWindows XP Embedded Component ModelWindows XP Embedded Studio Tools Microsoft WindowsXP Embedded Product Highlights Componentized version of Windows XP Professional~ 12,000 components and updates as of Service Pack 2Flexible localizationSame binaries and API as Windows XP ProfessionalHotfixes and service packsEmbedded Enabling FeaturesRuns on standard PC hardwareSupports boot on hard drives, compact flash, DiskOnChipand read-only mediaSupport for remote install and remote bootHeadless device and remote management supportIntegration with Microsoft management tools
上傳時間： 2013-10-31
上傳用戶：jrsoft
Keil uVision2是目前使用廣泛的單片機開發軟件，它集成了源程序編輯和程序調試于一體，支持匯編、C、PL/M語言。 這里我們僅僅介紹 Keil uVision2 的簡單使用，更詳細的使用方法見本光盤\單片機軟件\Keil c51\Keil書籍與資料目錄中的內容。 keil C51 v6.12 的安裝： 先運行光盤中 單片機軟件\setup\setup.exe 安裝程序，選擇安裝“Eval Version”版進行安裝。一直點擊“Yes”或“Next”，直到“Finish”完成。 之后運行同目錄中的 Keil uv2 漢化安裝.exe 安裝漢化程序。 keil C51 v6.12 的使用： 點擊桌面快捷圖標，可以直接進入主畫面：現在，我們來做個實際程序，請跟著我一步一步學著做，實際體驗一下從編輯源程序到程序調試的全過程。 這里讓我們做一個 讓單片機 P0 口所驅動的 LED 燈隔一個亮隔一個滅 的程序。 在Keil系統中，每做個獨立的程序，都視為工程（或者叫項目）。首先從菜但的“工程”中“新建工程...”，建立我們將要做的工程項目：新建的工程要起個與工程項目意義一致的名字，可以是中文名；我們這里的程序是實驗測試程序，所以起的名字為 Test ，并將 Test 工程“保存”到 C:\Keil 下：接下來，Keil環境要求我們為 Test 工程選擇一個單片機型號；我們選擇 Atmel 公司的 89C51（雖然我們使用的是89S51，但由于89S51與89C51內、外部結構完全一樣，所以這里依然選擇“89C51”）。“確定”后工程項目就算建立了。
上傳時間： 2013-10-12
上傳用戶：zzzzzz
Texas Instruments and its subsidiaries (TI) reserve the right to make changes to their productsor to discontinue any product or service without notice, and advise customers to obtain the latestversion of relevant information to verify, before placing orders, that information being relied onis current and complete. All products are sold subject to the terms and conditions of sale suppliedat the time of order acknowledgement, including those pertaining to warranty, patentinfringement, and limitation of liability
上傳時間： 2013-12-26
上傳用戶：凌云御清風
CCStudio Platinum Edition is available in a number of ways. Existingcustomers who are up-to-date with their subscription service withTexas Instruments will receive their update automatically on a CD inthe mail. New customers who wish to purchase a copy of CCStudioPlatinum Edition can order TMDSCCSALL-1 starting May 23, 2005. A120-day Trial version will be also be available on CDROM startingJuly 11, 2005. Users may order the CDROM of the 120-day free copy
上傳時間： 2014-12-28
上傳用戶：gououo
USB接口控制器參考設計,xilinx提供VHDL代碼 usb xilinx vhdl ; This program is free software; you can redistribute it and/or modify ; it under the terms of the GNU General Public License as published by ; the Free Software Foundation; either version 2 of the License, or ; (at your option) any later version. ; ; This program is distributed in the hope that it will be useful, ; but WITHOUT ANY WARRANTY; without even the implied warranty of ; MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the ; GNU General Public License for more details. ; ; You should have received a copy of the GNU General Public License ; along with this program; if not, write to the Free Software ; Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA.
上傳時間： 2013-10-12
上傳用戶：windgate
8051參考設計，與其他8051的免費IP相比，文檔相對較全，Oregano System 提供 This is version 1.3 of the MC8051 IP core. September 2002: Oregano Systems - Design & Consulting GesmbH Change history: - Improved tb_mc8051_siu_sim.vhd to verify duplex operation. - Corrected problem with duplex operation in file mc8051_siu_rtl.vhd
上傳時間： 2014-12-28
上傳用戶：tb_6877751
This article describes the procedure to configure and program EXAR Corporation’s PowerXR Digital Power devicesvia I2C interface. Details shown here apply to XRP7704/08/40 and XRP7713/14 devices and PowerArchitectsoftware version 3.00.
上傳時間： 2013-10-20
上傳用戶：tianyi223
