The Point-to-Point Protocol (PPP)
for the
Transmission of Multi-Protocol Datagrams
over Point-to-Point Links
Status of this Memo
This RFC specifies an IAB standards track protocol for the Internet
community, and requests discussion and suggestions for improvements.
Please refer to the current edition of the "IAB Official Protocol
Standards" for the standardization state and status of this protocol.
Distribution of this memo is unlimited.
fwknop stands for "Firewall Knock Operator" and is an upcoming piece of software that will be released at the DEFCON 12 conference in July, 2004 in Las Vegas.
fwknop implements network access controls (via iptables) based on a flexible port knocking mini-language, but with a twist it combines port knocking and passive operating system fingerprinting to make it possible to do things like only allow, say, Linux-2.4/2.6 systems to connect to your SSH daemon.
fwknop supports shared, Multi-Protocol port knock sequences along with both relative and absolute timeouts, and coded port knock sequences encrypted with the Rijndael block cipher.
Real-Time Transport Protocol (RTP) Payload Format and File Storage
Format for the Adaptive Multi-Rate (AMR) and Adaptive Multi-Rate
Wideband (AMR-WB) Audio Codecs
Host Identity Protocol on Linux is an implemetation of the Host Identity Protocol (HIP) and the related architecture. HIP is a proposal to change the TCP/IP stack to securely support mobility and multi-homing. Additionally, it provides for enhanced security and privacy and advanced network concepts, such as moving networks and mobile ad hoc networks. HIP is "cool", which means that as a mobile VPN solution, when your network interfaces go up or down, there is no need to re-establish a secure tunnel.
IEEE 802.11F-2003 IEEE Recommended Practice for Multi-Vendor Access Point Interoperability via an Inter-Access Point Protocol Across Distribution Systems Supporting IEEE 802.11 Operation
詳細介紹工控軟件組態王與單片機多機串口通訊的設計原理。分析組態王提供的直接與單片機串口通信方法的優點，給出系統基于RS-485總線傳輸的接口電路原理圖。根據組態王提供的通訊協議和單片機多機串口通訊的原理，給出程序設計流程與思路。
Abstract:
In this paper，the design principle of communication between multi-SCM and KingView by serial ports is described in detail.We analysis the advantage of method supplied by KingView,by which KingView can communicate with serial ports of SCM directly，and provide the system’s interface circuit based on the RS-485transmission line.We provide flow diagram of programming and thinking on the basis of communication protocol supplied by KingView and principle of communication among multi-SCM through serial ports.
The Controller Area Network (CAN) is a serial, asynchronous, multi-master communication protocol forconnecting electronic control modules, sensors and actuators in automotive and industrial applications.With the SJA1000, Philips Semiconductors provides a stand-alone CAN controller which is more than a simpleeplacement of the PCA82C200.Attractive features are implemented for a wide range of applications, supporting system optimization, diagnosisand maintenance.
