實驗目的： 1、掌握EIGRP 的基本配置 2、掌握EIGRP 的通配符掩配置方法 3、掌握EIGRP 的自動匯總特性，理解EIGRP 的自動匯總的缺陷以及如何關閉自動匯總 4、掌握EIGRP 的手工匯總 5、掌握通過ip default-NETWORK 命令配置EIGRP 默認網絡 6、掌握EIGRP 的手工自動總結的配置方
上傳時間： 2013-10-13
上傳用戶：llwap
RMON（Remote NETWORK Monitoring，遠程網絡監視）主要實現了統計和告警功能，用于網絡中管理設備對被管理設備的遠程監控和管理。統計功能指的是被管理設備可以按周期或者持續跟蹤統計其端口所連接的網段上的各種流量信息，比如某段時間內某網段上收到的報文總數，或收到的超長報文的總數等。告警功能指的是被管理設備能監控指定MIB 變量的值，當該值達到告警閾值時（比如端口速率達到指定值，或者廣播報文的比例達到指定值），能自動記錄日志、向管理設備發送Trap消息。
標簽： RMON
上傳時間： 2013-10-11
上傳用戶：zxh122
This application note provides step-by-step instructions on how to recreate a Tri-Mode Ethernet(TEMAC) performance testing system using the ML405 board and MontaVista Linux 4.0. Thisapplication note shows how to set up a simple EDK Base System Builder system on the ML405Evaluation Platform and run performance tests. The NETWORK architecture for the test isdescribed. A system is built and downloaded into the FPGA. A MontaVista Linux kernel isconfigured, built, and downloaded into the ML405 Evaluation Platform. The instructions forobtaining and setting up the software used to perform the measurements, netperf, are given.
上傳時間： 2013-11-11
上傳用戶：saharawalker
The NCV7356 is a physical layer device for a single wire data linkcapable of operating with various Carrier Sense Multiple Accesswith Collision Resolution (CSMA/CR) protocols such as the BoschController Area NETWORK (CAN) version 2.0. This serial data linkNETWORK is intended for use in applications where high data rate is notrequired and a lower data rate can achieve cost reductions in both thephysical media components and in the microprocessor and/ordedicated logic devices which use the NETWORK.The NETWORK shall be able to operate in either the normal data ratemode or a high-speed data download mode for assembly line andservice data transfer operations. The high-speed mode is onlyintended to be operational when the bus is attached to an off-boardservice node. This node shall provide temporary bus electrical loadswhich facilitate higher speed operation. Such temporary loads shouldbe removed when not performing download operations.The bit rate for normal communications is typically 33 kbit/s, forhigh-speed transmissions like described above a typical bit rate of83 kbit/s is recommended. The NCV7356 features undervoltagelockout, timeout for faulty blocked input signals, output blankingtime in case of bus ringing and a very low sleep mode current.
上傳時間： 2013-10-24
上傳用戶：s藍莓汁
EPON主要由三個部分構成，包括光線路終端(OLlj Optical Line Terminal)、光分配網絡(ODN，Optical Distribution NETWORK)和光網絡單元(ONU，Optical NETWORK Unit .
上傳時間： 2013-11-11
上傳用戶：JGR2013
在研究傳統家用燃氣報警器的基礎上，以ZigBee協議為平臺，構建mesh網狀網絡實現網絡化的智能語音報警系統。由于傳感器本身的溫度和實際環境溫度的影響，傳感器標定后采用軟件補償方法。為了減少系統費用，前端節點采用半功能節點設備，路由器和協調器采用全功能節點設備，構建mesh網絡所形成的家庭內部報警系統，通過通用的電話接口連接到外部的公用電話網絡，啟動語音模塊進行報警。實驗結果表明，在2.4 GHz頻率下傳輸，有墻等障礙物的情況下，節點的傳輸距離大約為35 m，能夠滿足家庭需要，且系統工作穩定，但在功耗方面仍需進一步改善。 Abstract: On the basis of studying traditional household gas alarm system, this paper proposed the platform for the ZigBee protocol，and constructed mesh NETWORK to achieve NETWORK-based intelligent voice alarm system. Because of the sensor temperature and the actual environment temperature, this system design used software compensation after calibrating sensor. In order to reduce system cost, semi-functional node devices were used as front-end node, however, full-function devices were used as routers and coordinator，constructed alarm system within the family by building mesh NETWORK，connected to the external public telephone NETWORK through the common telephone interface, started the voice alarm module. The results indicate that nodes transmit about 35m in the distance in case of walls and other obstacles by 2.4GHz frequency transmission, this is able to meet family needs and work steadily, but still needs further improvement in power consumption.
上傳時間： 2013-10-30
上傳用戶：swaylong
為滿足無線網絡技術具有低功耗、節點體積小、網絡容量大、網絡傳輸可靠等技術要求，設計了一種以MSP430單片機和CC2420射頻收發器組成的無線傳感節點。通過分析其節點組成，提出了ZigBee技術中的幾種網絡拓撲形式，并研究了ZigBee路由算法。針對不同的傳輸要求形式選用不同的網絡拓撲形式可以盡大可能地減少系統成本。同時針對不同網絡選用正確的ZigBee路由算法有效地減少了網絡能量消耗，提高了系統的可靠性。應用試驗表明，采用ZigBee方式通信可以提高傳輸速率且覆蓋范圍大，與傳統的有線通信方式相比可以節約40%左右的成本。 Abstract: To improve the proposed technical requirements such as low-ower， small nodes， large capacity and reliable NETWORK transmission， wireless sensor nodes based on MSP430 MCU and CC2420 RF transceiver were designed. This paper provided NETWORK topology of ZigBee technology by analysing the component of the nodes and researched ZigBee routing algorithm. Aiming at different requirements of transmission mode to choose the different NETWORK topologies form can most likely reduce the system cost. And aiming at different NETWORK to choose the correct ZigBee routing algorithm can effectively reduced the NETWORK energy consumption and improved the reliability of the system. Results show that the communication which used ZigBee mode can improve the transmission rate， cover more area and reduce 40% cost compared with traditional wired communications mode.
上傳時間： 2013-10-09
上傳用戶：robter
ZigBee技術是一種應用于短距離范圍內，低傳輸數據速率下的各種電子設備之間的無線通信技術。ZigBee名字來源于蜂群使用的賴以生存和發展的通信方式，蜜蜂通過跳ZigZag形狀的舞蹈來通知發現的新食物源的位置、距離和方向等信息，以此作為新一代無線通訊技術的名稱。ZigBee過去又稱為“HomeRF Lite”、“RF-EasyLink”或“FireFly”無線電技術，目前統一稱為ZigBee技術。 2、ZigBee技術的特點 自從馬可尼發明無線電以來，無線通信技術一直向著不斷提高數據速率和傳輸距離的方向發展。例如：廣域網范圍內的第三代移動通信網絡（3G）目的在于提供多媒體無線服務，局域網范圍內的標準從IEEE802.11的1Mbit/s到IEEE802.11g的54Mbit/s的數據速率。而當前得到廣泛研究的ZigBee技術則致力于提供一種廉價的固定、便攜或者移動設備使用的極低復雜度、成本和功耗的低速率無線通信技術。這種無線通信技術具有如下特點： 功耗低：工作模式情況下，ZigBee技術傳輸速率低，傳輸數據量很小，因此信號的收發時間很短，其次在非工作模式時，ZigBee節點處于休眠模式。設備搜索時延一般為30ms，休眠激活時延為15ms，活動設備信道接入時延為15ms。由于工作時間較短、收發信息功耗較低且采用了休眠模式，使得ZigBee節點非常省電，ZigBee節點的電池工作時間可以長達6個月到2年左右。同時，由于電池時間取決于很多因素，例如：電池種類、容量和應用場合，ZigBee技術在協議上對電池使用也作了優化。對于典型應用，堿性電池可以使用數年，對于某些工作時間和總時間（工作時間+休眠時間）之比小于1%的情況，電池的壽命甚至可以超過10年。 數據傳輸可靠：ZigBee的媒體接入控制層（MAC層）采用talk-when-ready的碰撞避免機制。在這種完全確認的數據傳輸機制下，當有數據傳送需求時則立刻傳送，發送的每個數據包都必須等待接收方的確認信息，并進行確認信息回復，若沒有得到確認信息的回復就表示發生了碰撞，將再傳一次，采用這種方法可以提高系統信息傳輸的可靠性。同時為需要固定帶寬的通信業務預留了專用時隙，避免了發送數據時的競爭和沖突。同時ZigBee針對時延敏感的應用做了優化，通信時延和休眠狀態激活的時延都非常短。 網絡容量大：ZigBee低速率、低功耗和短距離傳輸的特點使它非常適宜支持簡單器件。ZigBee定義了兩種器件：全功能器件（FFD）和簡化功能器件（RFD）。對全功能器件，要求它支持所有的49個基本參數。而對簡化功能器件，在最小配置時只要求它支持38個基本參數。一個全功能器件可以與簡化功能器件和其他全功能器件通話，可以按3種方式工作，分別為：個域網協調器、協調器或器件。而簡化功能器件只能與全功能器件通話，僅用于非常簡單的應用。一個ZigBee的網絡最多包括有255個ZigBee網路節點，其中一個是主控（Master）設備，其余則是從屬（Slave）設備。若是通過網絡協調器（NETWORK Coordinator），整個網絡最多可以支持超過64000個ZigBee網路節點，再加上各個NETWORK Coordinator可互相連接，整個ZigBee網絡節點的數目將十分可觀。 兼容性：ZigBee技術與現有的控制網絡標準無縫集成。通過網絡協調器（Coordinator）自動建立網絡，采用載波偵聽/沖突檢測（CSMA-CA）方式進行信道接入。為了可靠傳遞，還提供全握手協議。
標簽： zigbee
上傳時間： 2013-11-24
上傳用戶：siguazgb
Agilent AN 154 S-Parameter Design Application Note S參數的設計與應用 The need for new high-frequency, solid-state circuitdesign techniques has been recognized both by microwaveengineers and circuit designers. These engineersare being asked to design solid state circuitsthat will operate at higher and higher frequencies.The development of microwave transistors andAgilent Technologies’ NETWORK analysis instrumentationsystems that permit complete NETWORK characterizationin the microwave frequency rangehave greatly assisted these engineers in their work.The Agilent Microwave Division’s lab staff hasdeveloped a high frequency circuit design seminarto assist their counterparts in R&D labs throughoutthe world. This seminar has been presentedin a number of locations in the United States andEurope.From the experience gained in presenting this originalseminar, we have developed a four-part videotape, S-Parameter Design Seminar. While the technologyof high frequency circuit design is everchanging, the concepts upon which this technologyhas been built are relatively invariant.The content of the S-Parameter Design Seminar isas follows:
標簽： S參數
上傳時間： 2013-12-19
上傳用戶：aa54
Today in many applications such as NETWORK switches, routers, multi-computers,and processor-memory interfaces, the ability to integrate hundreds of multi-gigabit I/Os is desired to make better use of the rapidly advancing IC technology.
上傳時間： 2013-10-30
上傳用戶：ysjing
