針對船舶氣象儀保障維修而設計的船舶氣象儀測試系統，包括信息處理終端、主儀器檢測模塊、傳感器檢測模塊，各個模塊都采用基于AVR單片機的嵌入式系統，模塊之間通過CAN總線進行通信。結果表明，船舶氣象儀測試系統能夠快速檢測船舶氣象儀故障，與單純依靠人工方式排查故障相比，故障檢測時間縮短了60%以上。
Abstract:
The test system of ship meteorological instrument was developed to satisfy the maintenance of ship meteorological instruments，which composed of information ProcessING terminal， testing module of main instrument and testing module of sensors. Each of these modules included an embedded system based on microcontroller of AVR series and communicated with other module by CAN bus. The results show that the test system can judge the fault of ship meteorological instrument quickly and shorten the fault detection time as much as 60% compared with simple manual troubleshooting.
隨著單片機功能集成化的發展，其應用領域也逐漸地由傳統的控制，擴展為控制處理、數據處理以及數字信號處理（DSP，Digital Signal ProcessING）等領域。凌陽的16位單片機就是為適應這種發展而設計的。它的CPU內核采用凌陽最新推出的µ’nSP™（Microcontroller and Signal Processor）16位微處理器芯片（以下簡稱µ’nSP™）。圍繞µ’nSP™所形成的16位µ’nSP™系列單片機（以下簡稱µ’nSP™家族）采用的是模塊式集成結構，它以µ’nSP™內核為中心集成不同規模的ROM、RAM和功能豐富的各種外設接口部件。
This application note describes how to decode standard DTMF tones using the minimum number of external discrete components and a PIC. The two examples use a PIC which has an 8 bit timer and either a comparator or an ADC, although it can be modified for use on a PIC which has only digital I/O. The Appendices have example code for the 16C662 (with comparator) and 16F877 (using the ADC).
As the majority of the Digital Signal ProcessING is done in software, little is required in the way of external signal conditioning. Software techniques are used to model the individual elements of a DTMF Decoder IC.
基于多點網絡的水廠自動監控系統設計Design of MPI Based Automatic Monitoring and Control System in Water Works劉 美 俊(湖南工程學院，湘潭411101)摘要針對水廠工作水泵多、現場離控制站距離遠的特點，提出了一種基于MPI多點網絡的自動監控系統的設計方法，分析了系統的工作原理，介紹了系統中數據的采集與處理、主站與從站的通信原理以及系統軟件的設計。由于這種系統的主、從站PLC之間采用MPI網絡通信，具有運行可靠、性能價格比高的特點，所以適用于中小規模水廠的分布式監控場合。關鍵詞多點網絡主站從站監控系統Abstract Ina ccordancew ithth efe atuersof w aterw orks,i. e. ，manyp umpsin o perationa ndth ep umps， farfor mt hec ontrolst ation,th em ethodo fdesigninga na utomati(〕monitoringa ndc ontorlsy stemb asedo nM PIis p resented.Th eo perationalpr incipleo fth esy stemi san alyzed,th ed atac olection,data ProcessING; communication between master station and slave station as wel as design and system software are discussed. Because MPI network communicationis used among master station, slave stations and PLC, the system is reliable and high cost-efective. It is， suitable for smal and mediumsized water works for distrbuted monitoring and control.Keywords MPI Masterst ation Slaves tation Monitoringa ndc ontorlsy stem
自來 水 廠 的自動控制系統一般分為兩大部分，一對組態硬件要求較高，投資較大。相對而言，MPI網是水源地深水泵的工作控制，一是水廠區變頻恒壓供絡速度可達187.5 M bps，通過一級中繼器傳輸距離可水控制，兩部分的實際距離通常都比較遠。某廠水源達Ikm 。根據水廠的具體情況，確定以MPI方式組地有3臺深井泵給水廠區的蓄水池供水。水廠區的成網絡，主站PLC為S7-300系列的CPU3121FM，從任務是對水池的水進行消毒處理后，通過加壓泵向管站為S7-200系列的CPU222。這樣既滿足了系統要路恒壓供水。選用Siemens公司的S7系列可編程控求，又相對于Profibus網絡節省了三分之一的成本，制器(PLC)和上位機組成實時數據采集和監控系統， 這種分布式監控系統具有較高的性能價格比。系統對深水泵進行遠程控制，對供水泵采用變頻器進行恒中PLC的物理層采用RS - 485接口，網絡延伸選用壓控制以保證整個水廠的電機設備安全、可靠地運帶防雷保護的中繼器，使系統的安全運行得到了保行。證。MPI網絡的拓撲結構如圖1所示。1 多點網絡(NWI)監控系統的組成Sie me ns 公司S7系列PLC通常有MP」多點網絡與Profibus現場總線網絡兩種組網方式。Profibus現場總線的應用目前較為普遍，通用性較好，它由Profibus一DP, Profibus一FMS, Profibus一PA組成。Profibus - DP型用于分散外設間的數據傳輸，傳輸速率為9.6kbps一12Mbps，主要用于現場控制器與分散1/0之間的通信，可滿足交直流調速系統快速響應的時間要求，特別適合于加工自動化領域的應用;Profibus - FMS主要解決車間級通信問題，完成中等傳輸速度的循環或非循環數據交換任務，適用于紡織、樓宇自動化、可編程控制器、低壓開關等;Profibus - PA型采用了OSI模型的物理層和數據鏈路層，適用于過程自動化的總線類型。
This application note shows how to achieve low-cost, efficient serial configuration for Spartan FPGA designs. The approachrecommended here takes advantage of unused resources in a design, thereby reducing the cost, part count, memory size,and board space associated with the serial configuration circuitry. As a result, neither processor nor PROM needs to be fullydedicated to performing Spartan configuration.In particular, information is provided on how the idle ProcessING time of an on-board controller can be used to loadconfiguration data from an off-board source. As a result, it is possible to upgrade a Spartan design in the field by sending thebitstream over a network.
The introduction of Spartan-3™ devices has createdmultiple changes in the evolution of embedded controldesigns and pushed ProcessING capabilities to the “almostfreestage.” With these new FPGAs falling under $20, involume, with over 1 million system gates, and under $5for 100K gate-level units, any design with programmablelogic has a readily available 8- or 16-bit processor costingless than 75 cents and 32-bit processor for less than $1.50.
WP369可擴展式處理平臺-各種嵌入式系統的理想解決方案 ：Delivering unrivaled levels of system performance,flexibility, scalability, and integration to developers,Xilinx's architecture for a new Extensible ProcessING Platform is optimized for system power, cost, and size. Based on ARM's dual-core Cortex™-A9 MPCore processors and Xilinx’s 28 nm programmable logic,the Extensible ProcessING Platform takes a processor-centric approach by defining a comprehensive processor system implemented with standard design methods. This approach provides Software Developers a familiar programming environment within an optimized, full featured,powerful, yet low-cost, low-power ProcessING platform.
