RF前置放大電路即讀取光碟片射頻信號的放大電路.其放大電路性能的好壞會直接影響到DVD-ROM產品性能的好壞.其主要功能如下: (1)對鐳射二極體供電進行控制.并產生參考 電壓. (2)對從光感檢測器輸出的微弱電流信號轉成 電壓信號進行放大處理.
上傳時間： 2013-11-22
上傳用戶：linlin
Designers of signal receiver systems often need to performcascaded chain analysis of system performancefrom the antenna all the way to the ADC. Noise is a criticalparameter in the chain analysis because it limits theoverall sensitivity of the receiver. An application’s noiserequirement has a signifi cant infl uence on the systemtopology, since the choice of topology strives to optimizethe overall signal-to-noise ratio, dynamic range andseveral other parameters. One problem in noise calculationsis translating between the various units used by thecomponents in the chain: namely the RF, IF/baseband,and digital (ADC) sections of the circuit.
上傳時間： 2014-12-05
上傳用戶：cylnpy
本文以f1禁系統的可靠性和低成本為立足點，提出了一種基于AT89C2051單片機的RF卡門禁系統設 系計方法。首先簡單介紹了組成這個系統的非接觸式IC卡，然后詳細描述了其軟硬件設計的過程。在實際的應用 統設過程中已經驗證了該設計方法的合理性。
上傳時間： 2013-10-15
上傳用戶：takako_yang
作者RICHARD CHI-HSI LI，結合自己20年RF設計經驗，整理的RF設計技術與經驗，工程性很強，從最基本的LNA、MIXERS、差分對等講起，涉及到阻抗匹配，接地，天線設計，RF系統分析，是一本很不錯的書。英文版
上傳時間： 2013-10-30
上傳用戶：ve3344
手機RF知識講座
上傳時間： 2013-10-25
上傳用戶：黑漆漆
The CC1101 is a low-cost sub- 1 GHztransceiver designed for very low-powerwireless applications. The circuit is mainlyintended for the ISM (Industrial, Scientific andMedical) and SRD (Short Range Device)frequency bands at 315, 433, 868, and 915MHz, but can easily be programmed foroperation at other frequencies in the 300-348MHz, 387-464 MHz and 779-928 MHz bands.CC1101 is an improved and code compatibleversion of the CC1100 RF transceiver. Themain improvements on the CC1101 include:
上傳時間： 2013-11-12
上傳用戶：363186
過去，RF功率的性能完全取決于線性效率。如今，開發者遇到更加復雜的挑戰：需要滿足多種標準、信號變化和嚴格的帶寬要求等。針對這一問題，飛思卡爾半導體(NYSE：FSL)日前推出新型硅片RF LDMOS功率晶體管Airfast RF功率解決方案，將性能和能效提升至新的高度。飛思卡爾通過新的產品系列解決了這種模式轉變帶來的問題，該產品系列基于一種更加全面、完整的系統級RF功率技術方法。
上傳時間： 2013-11-25
上傳用戶：drink！
The main objective of this book is to present all the relevant informationrequired for RF and micro-wave power amplifier design includingwell-known and novel theoretical approaches and practical design techniquesas well as to suggest optimum design approaches effectively combininganalytical calculations and computer-aided design. This bookcan also be very useful for lecturing to promote the analytical way ofthinking with practical verification by making a bridge between theoryand practice of RF and microwave engineering. As it often happens, anew result is the well-forgotten old one. Therefore, the demonstrationof not only new results based on new technologies or circuit schematicsis given, but some sufficiently old ideas or approaches are also introduced,that could be very useful in modern practice or could contributeto appearance of new ideas or schematic techniques.
標簽： Amplifier Microwave Design Power
上傳時間： 2013-12-22
上傳用戶：vodssv
When I started writing the first edition of RF Power Amplifiers for Wireless Communications,some time back in 1997, it seemed that I was roaming a largely uninhabitedlandscape. For reasons still not clear to me there were few, if any, otherbooks dedicated to the subject of RF power amplifiers. Right at the same time, however,hundreds of engineers were being assigned projects to design PAs for wirelesscommunications products. It was not, therefore, especially difficult to be successfulwith a book that was fortuitously at the right place and the right time.
標簽： Communications Amplifiers Wireless Edition
上傳時間： 2013-11-12
上傳用戶：YYRR
RF circuit design theory and application(射頻電路設計)
標簽： application circuit design theory
上傳時間： 2014-12-30
上傳用戶：aeiouetla
