UCOS/II for ICCAVR - The version of UCOS/II is 2.04 - the original port was done by Ole Saether for the IAR compiler. Jens E. Holtegaard ported one version using ICCAVR. Joerg Meyer did another port (using Jens port as a start?). This is basically Joerg s port plus a little bit of changes and documentation by me. - YOU MUST DOWNLOAD THE MAIN PART OF THE UCOS/II FROM THE UCOS/II WEBSITE http://www.ucos-ii.com . The supplied project file assumes the portable source is in the ..\source directory. - Joerg has written couple document showing the stack frames etc. but it is in German :-) They are included in this directory. - The Timer2 overflow interrupt is used for Timer Tick. If you want to change that, modify os_cpu_c.c and os_cpu_a.s - I have tested this using ATMega103 with and without external RAM using AVR Studio simulator. See test1.c test program. Both Code Compressed (PRO) and STD versions have been tested.
標簽： UCOS original Saether version
上傳時間： 2015-11-14
上傳用戶：ippler8
This file is distributed in the hope that it will be useful, but WITHOUT * WARRANTY OF ANY KIND. * * Author(s): Ole Saether * * DESCRIPTION: * * Hello World program. Please note that this program runs the internal 8051 * on the default power up frequency of 4MHz. See ex3c.c for an example on how * to switch to 16MHz. * * The functionality is the same as in ex1a.asm. * * COMPILER: * * This program has been tested with Keil V7.07a. * * $Revision: 3 $ *
標簽： distributed WARRANTY WITHOUT useful
上傳時間： 2017-05-17
上傳用戶：515414293
This file is distributed in the hope that it will be useful, but WITHOUT WARRANTY OF ANY KIND. Author(s): Ole Saether DESCRIPTION: nRF9E5 Hello World program. Please note that this program runs the internal 8051 on the default power up frequency of 4MHz. See ex3a.asm for an example on how to switch to 16MHz. The functionality is the same as in ex1c.c. ASSEMBLER: You need as31.exe to assemble this program. It can be downloaded from this web page: http://www.pjrc.com/tech/8051/ $Revision: 4 $
標簽： distributed WARRANTY WITHOUT useful
上傳時間： 2017-05-17
上傳用戶：wuyuying
This file is distributed in the hope that it will be useful, but WITHOUT WARRANTY OF ANY KIND. Author(s): Ole Saether DESCRIPTION: This example should be used together with ex2a-tx433.asm. One nRF9E5 evaluation board (receiver) should be programmed with the hex-file generated from assembling this file and the other evaluation board (transmitter) programmed with the hex-file generated from assembling ex2a-tx433.asm. All switches on the DIP-swith S206 on the receiver must be set to the "on" position and all switches on the DIP-swith S205 on the transmitter must be set to the "on" position. When one of the switched SW1-SW4 on the transmitter is pressed the corresponding LED on the receiver is turned on. The functionality is the same as in ex2c-rx.c.
標簽： distributed WARRANTY WITHOUT useful
上傳時間： 2017-05-17
上傳用戶：xieguodong1234
