Altera recommends the following system configuration: * Pentium II 400 with 512-MB system memory (faster systems give better software performance) * SVGA monitor * CD-ROM drive * One or more of the following I/O ports: - USB port (if using Windows XP or Windows 2000) for USB-Blaster(TM) or MasterBlaster(TM) communications cables, or APU programming unit - Parallel port for ByteBlasterMV(TM) or ByteBlaster(TM) II download cables - Serial port for MasterBlaster communications cable * TCP/IP networking protocol installed * Windows 2000, Windows NT 4.0 with Service Pack 3 or later, or Windows XP * Internet Explorer 5.0 or later Memory & Disk Space Requirements USB開發
This example program shows how to configure and use the A/D Converter of the following microcontroller:
STMicroelectronics ST10F166
After configuring the A/D, the program reads the A/D result and outputs the converted value using the Serial port.
To run this program...
Build the project (Project Menu, Build Target)
Start the debugger (Debug Menu, Start/Stop Debug Session)
View the Serial Window (View Menu, Serial Window #1)
View the A/D converter peripheral (Peripheral Menu, A/D Converter)
Run the program (Debug Menu, Go)
A debug script (debug.ini) creates buttons that set different analog values in A/D channels. As the program runs, you will see the A/D input and output change.
Other buttons create signals that generate sine wave or sawtooth patterns as analog inputs. µ Vision3 users may enable the built-in Logic Analyzer to view, measure and compare these input signals graphically.
This a USB core stack for
the built-in USB device of LPC214x microcontrollers.
It handles the hardware interface and
USB enumeration/configuration.
Also included are application examples like
a USB joystick HID and USB Serial port emulation.
Make and answer phone calls
Detect tone and pulse digit from the phone line
Capture Caller ID
Support blind transfer, single-step transfer/conference, consultation transfer/conference, hold, unhold.
Control of the local phone handset, microphone and speaker of the modem
Send and receive faxes
Play and record on the phone line or sound card
Play music in background mode
Silence detection
VU Meter
Wave sound editor that allows your end-users to edit their own sound files.
Voice recognition and voice synthesis.
Full control over the Serial port device
ZModem file transfer utility
File compression and encryption utility
Freediag contains various drivers (ISO9141, ISO14230, SAEJ1850-VPW, SAEJ1850-PWM) for different adapters that connect the PC Serial port to a vehicle. It reads vehicle diagnostic info from vehicle electronic control unit (ecu). The source code is compiled and run in linux environment.
Infrared remote decode firmware ,use time measure pulse to decode 1 or 0 this code can decode Nec protocal remote controller and than use uart transfer the data to the pc Serial port
