Convergence between the two largest networks (Telecom and IP) is taking place
very rapidly and at diff erent levels: (1) network level: unifi cation of IP networks
with traditional Telecom networks through evolving standards (Session Initiation
Protocol (SIP), Realtime Transfer Protocol (RTP), SS7, 3G) to support interopera-
bility; (2) Service level: traditional Telecom Services like voice calls are being provi-
sioned on the IP backbone (VoIP), while traditional IP Services (most data-driven
Services such as multimedia, browsing, chatting, gaming, etc.) are accessible over
the Telecom network.
標簽：
Platforms
Delivery
Service
上傳時間：
2020-06-01
上傳用戶：shancjb
Over the past few decades there has been an exponential growth in Service robots
and smart home technologies, which has led to the development of exciting new
products in our daily lives. Service robots can be used to provide domestic aid for
the elderly and disabled, serving various functions ranging from cleaning to enter-
tainment. Service robots are divided by functions, such as personal robots, field
robots, security robots, healthcare robots, medical robots, rehabilitation robots and
entertainment robots. A smart home appears “intelligent” because its embedded
computers can monitor so many aspects of the daily lives of householders. For
example, the refrigerator may be able to monitor its contents, suggest healthy alter-
natives and order groceries. Also, the smart home system may be able to clean the
house and water the plants.
標簽：
Robotics
Service
Digital
within
Home
the
上傳時間：
2020-06-06
上傳用戶：shancjb
Agilent 34401A Service Guide.pdfIEC Measurement Category II includes electrical devices connected to mains at an outlet on a branch circuit. Such devices include
most small appliances, test equipment, and
other devices that plug into a branch outlet
or socket. The 34401A may be used to make
measurements with the HI and LO inputs
connected to mains in such devices, or to
the branch outlet itself (up to 300 VAC).
However, the 34401A may not be used with
its HI and LO inputs connected to mains in
permanently installed electrical devices
such as the main circuit-breaker panel,
sub-panel disconnect boxes, or permanently
wired motors. Such devices and circuits are
subject to overvoltages that may exceed the
protection limits of the 34401A.
Note: Voltages above 300 VAC may be measured only in circuits that are isolated from
mains. However, transient overvoltages are
also present on circuits that are isolated
from mains. The Agilent 34401A are
designed to safely withstand occasional
transient overvoltages up to 2500 Vpk. Do
not use this equipment to measure circuits
where transient overvoltages could exceed
this level.
Additional Notices
Waste Electrical and
Electronic Equipment (WEEE)
Directive 2002/96/EC
This product complies with the WEEE Directive (2002/96/EC) marking requirement.
The affixed product label (see below) indicates that you must not discard this electrical/electronic product in domestic
household waste.
Product Category: With reference to the
equipment types in the WEEE directive
Annex 1, this product is classified as a
"Monitoring and Control instrumentation"
product.
Do not dispose in domestic household
waste.
To return unwanted products, contact your
local Agilent office, or see
www.agilent.com/environment/product
for more information.
Agilent 34138A Test Lead Set
The Agilent 34401A is compatible with the
Agilent 34138A Test Lead Set described
below.
Test Lead Ratings
Test Leads - 1000V, 15A
Fine Tip Probe Attachments - 300V, 3A
Mini Grabber Attachment - 300V, 3A
SMT Grabber Attachments - 300V, 3A
Operation
The Fine Tip, Mini Grabber, and SMT Grabber attachments plug onto the probe end of
the Test Leads.
Maintenance
If any portion of the Test Lead Set is worn or
damaged, do not use. Replace with a new
Agilent 3413
標簽：
agilent
上傳時間：
2022-02-20
上傳用戶：
