Data logger Power transision function switch among different power modes based on new Renesus microcontroller. This module has been tested on the renesus develop board with different LED to indicate different power modes.
The SP2526A device is a dual +3.0V to +5.5V USB Supervisory Power Control Switch ideal
for self-powered and bus-powered Universal Serial Bus (USB) applications. Each switch has
low on-resistance (110mΩ typical) and can supply 500mA minimum. The fault currents are
limited to 1.0A typical and the flag output pin for each switch is available to indicate fault
conditions to the USB controller. The thermal shutdown feature will prevent damage to the
device when subjected to excessive current loads. The undervoltage lockout feature will
ensure that the device will remain off unless there is a valid input voltage present.
Radio frequency (RF) power amplifiers are used in everyday life for many applica-
tions including cellular phones, magnetic resonance imaging, semiconductor wafer
processing for chip manufacturing, etc. Therefore, the design and performance of
RF amplifiers carry great importance for the proper functionality of these devices.
Furthermore, several industrial and military applications require low-profile yet
high-powered and efficient power amplifiers.
For many years prior to the 1970s, engineers designed and built switch mode
power supplies (SMPSs) using methods based largely on intuitive and exper-
imentally derived techniques. In general, these power supplies were able to
achieve their primary goal of high-efficiency power conversion; unfortu-
nately, due to the lack of adequate theoretical analysis techniques, many of
these power supplies only marginally met their desired performance require-
ments. In many cases, they were considered to be unreliable.
Abstract: This document details the Lakewood (MAXREFDES7#) subsystem reference design, a 3.3V input, ±12V (±15V) output, isolated power supply. The Lakewood reference design includes a 3W primary-side transformer H-bridge driver for isolated supplies, and two wide input range and adjustable output low-dropout linear regulators (LDOs). Test results and hardware files are included.
Abstract: This document details the Riverside (MAXREFDES8#) subsystem reference design, a 3.3V input, 12V (15V) output, isolated power supply. The Riverside reference design includes a 3W primary-side transformer H-bridge driver for isolated supplies, and one wide input range and adjustable output low-dropout linear regulator (LDO). Test results and hardware files are included.
