亚洲国产成人二区,亚洲国产精品va,欧美人与性禽动交精品

TESTING

MIMO_device_TESTING

Anritsu公司的TESTING your MIMO Devices: A focus on RF

標簽： MIMO_device_TESTING

上傳時間： 2013-11-09

上傳用戶：黃酒配奶茶
XAPP1023-測試Virtex-4 TEMAC系統的性能

This application note provides step-by-step instructions on how to recreate a Tri-Mode Ethernet(TEMAC) performance TESTING system using the ML405 board and MontaVista Linux 4.0. Thisapplication note shows how to set up a simple EDK Base System Builder system on the ML405Evaluation Platform and run performance tests. The network architecture for the test isdescribed. A system is built and downloaded into the FPGA. A MontaVista Linux kernel isconfigured, built, and downloaded into the ML405 Evaluation Platform. The instructions forobtaining and setting up the software used to perform the measurements, netperf, are given.

標簽： Virtex TEMAC XAPP 1023

上傳時間： 2013-11-11

上傳用戶：saharawalker
UHF讀寫器設計中的FM0解碼技術

針對UHF讀寫器設計中，在符合EPC Gen2標準的情況下，對標簽返回的高速數據進行正確解碼以達到正確讀取標簽的要求，提出了一種新的在ARM平臺下采用邊沿捕獲統計定時器數判斷數據的方法，并對FM0編碼進行解碼。與傳統的使用定時器定時采樣高低電平的FM0解碼方法相比，該解碼方法可以減少定時器定時誤差累積的影響；可以將捕獲定時器數中斷與數據判斷解碼相對分隔開，使得中斷對解碼影響很小，實現捕獲與解碼的同步。通過實驗表明，這種方法提高了解碼的效率，在160 Kb/s的接收速度下，讀取一張標簽的時間約為30次/s。 Abstract: Aiming at the requirement of receiving correctly decoded data from the tag under high-speed communication which complied with EPC Gen2 standard in the design of UHF interrogator， the article introduced a new technology for FM0 decoding which counted the timer counter to judge data by using the edge interval of signal capture based on the ARM7 platform. Compared with the traditional FM0 decoding method which used the timer timed to sample the high and low level， the method could reduce the accumulation of timing error and could relatively separate capture timer interrupt and the data judgment for decoding， so that the disruption effect on the decoding was small and realizd synchronization of capture and decoding. TESTING result shows that the method improves the efficiency of decoding， at 160 Kb/s receiving speed， the time of the interrogator to read a tag is about 30 times/s.

標簽： UHF FM0 讀寫器解碼技術

上傳時間： 2013-11-10

上傳用戶：liufei
xapp069 - 使用XC9500 JTAG邊界掃描接口

This application note explains the XC9500™/XL/XV Boundary Scan interface anddemonstrates the software available for programming and TESTING XC9500/XL/XV CPLDs. Anappendix summarizes the iMPACT software operations and provides an overview of theadditional operations supported by XC9500/XL/XV CPLDs for in-system programming.

標簽： xapp 9500 JTAG 069

上傳時間： 2013-11-01

上傳用戶：南國時代
基于FPGA的光纖光柵解調系統的研究

波長信號的解調是實現光纖光柵傳感網絡的關鍵，基于現有的光纖光柵傳感器解調方法，提出一種基于FPGA的雙匹配光纖光柵解調方法，此系統是一種高速率、高精度、低成本的解調系統，并且通過引入雙匹配光柵有效地克服了雙值問題同時擴大了檢測范圍。分析了光纖光柵的測溫原理并給出了該方案軟硬件設計，綜合考慮系統的解調精度和FPGA的處理速度給出了基于拉格朗日的曲線擬合算法。 Abstract: Sensor is one of the most important application of the fiber grating. Wavelength signal demodulating is the key techniques to carry out fiber grating sensing network， based on several existing methods of fiber grating sensor demodulation inadequate， a two-match fiber grating demodulation method was presented. This system is a high-speed， high precision， low-cost demodulation system. And by introducing a two-match grating effectively overcomes the problem of double value while expands the scope of TESTING. This paper analyzes the principle of fiber Bragg grating temperature and gives the software and hardware design of the program. Considering the system of demodulation accuracy and processing speed of FPGA，this paper gives the curve fitting algorithm based on Lagrange.

標簽： FPGA 光纖光柵解調系統

上傳時間： 2013-10-10

上傳用戶：zxc23456789
磁芯電感器的諧波失真分析

磁芯電感器的諧波失真分析摘要：簡述了改進鐵氧體軟磁材料比損耗系數和磁滯常數ηB，從而降低總諧波失真THD的歷史過程，分析了諸多因數對諧波測量的影響，提出了磁心性能的調控方向。關鍵詞：比損耗系數，磁滯常數ηB ，直流偏置特性DC-Bias，總諧波失真THD Analysis on THD of the fer rite co res u se d i n i nductancShi Yan Nanjing Finemag Technology Co. Ltd., Nanjing 210033 Abstract: Histrory of decreasing THD by improving the ratio loss coefficient and hysteresis constant of soft magnetic ferrite is briefly narrated. The effect of many factors which affect the harmonic wave TESTING is analysed. The way of improving the performance of ferrite cores is put forward. Key words: ratio loss coefficient，hysteresis constant，DC-Bias，THD 近年來，變壓器生產廠家和軟磁鐵氧體生產廠家，在電感器和變壓器產品的總諧波失真指標控制上，進行了深入的探討和廣泛的合作，逐步弄清了一些似是而非的問題。從工藝技術上采取了不少有效措施，促進了質量問題的迅速解決。本文將就此熱門話題作一些粗淺探討。一、歷史回顧總諧波失真（Total harmonic distortion），簡稱THD，并不是什么新的概念，早在幾十年前的載波通信技術中就已有嚴格要求<1>。1978年郵電部公布的標準YD/Z17－78“載波用鐵氧體罐形磁心”中，規定了高μQ材料制作的無中心柱配對罐形磁心詳細的測試電路和方法。如圖一電路所示，利用LC組成的150KHz低通濾波器在高電平輸入的情況下測量磁心產生的非線性失真。這種相對比較的實用方法，專用于無中心柱配對罐形磁心的諧波衰耗測試。這種磁心主要用于載波電報、電話設備的遙測振蕩器和線路放大器系統，其非線性失真有很嚴格的要求。圖中 ZD —— QF867 型阻容式載頻振蕩器，輸出阻抗 150Ω， Ld47 —— 47KHz 低通濾波器，阻抗 150Ω，阻帶衰耗大于61dB， Lg88 ——并聯高低通濾波器，阻抗 150Ω，三次諧波衰耗大于61dB Ld88 ——并聯高低通濾波器，阻抗 150Ω，三次諧波衰耗大于61dB FD —— 30～50KHz 放大器，阻抗 150Ω，增益不小于 43 dB，三次諧波衰耗b3(0)≥91 dB, DP —— Qp373 選頻電平表，輸入高阻抗， L ——被測無心罐形磁心及線圈， C ——聚苯乙烯薄膜電容器CMO-100V-707APF±0.5%,二只。測量時，所配用線圈應用絲包銅電磁線SQJ9×0.12(JB661-75)在直徑為16.1mm的線架上繞制 120 匝，（線架為一格），其空心電感值為 318μH（誤差1％）被測磁心配對安裝好后，先調節振蕩器頻率為 36.6～40KHz，使輸出電平值為+17.4 dB，即選頻表在 22′端子測得的主波電平（P2）為+17.4 dB，然后在33′端子處測得輸出的三次諧波電平（P3），則三次諧波衰耗值為：b3(+2)= P2+S+ P3 式中：S 為放大器增益dB 從以往的資料引證，就可以發現諧波失真的測量是一項很精細的工作，其中測量系統的高、低通濾波器，信號源和放大器本身的三次諧波衰耗控制很嚴，阻抗必須匹配，薄膜電容器的非線性也有相應要求。濾波器的電感全由不帶任何磁介質的大空心線圈繞成，以保證本身的“潔凈” ，不至于造成對磁心分選的誤判。為了滿足多路通信整機的小型化和穩定性要求，必須生產低損耗高穩定磁心。上世紀 70 年代初，1409 所和四機部、郵電部各廠，從工藝上改變了推板空氣窯燒結，出窯后經真空罐冷卻的落后方式，改用真空爐，并控制燒結、冷卻氣氛。技術上采用共沉淀法攻關試制出了μQ乘積 60 萬和 100 萬的低損耗高穩定材料，在此基礎上，還實現了高μ7000～10000材料的突破，從而大大縮短了與國外企業的技術差異。當時正處于通信技術由FDM（頻率劃分調制）向PCM（脈沖編碼調制）轉換時期，日本人明石雅夫發表了μQ乘積125 萬為 0.8×10 ，100KHz）的超優鐵氧體材料<3>，其磁滯系數降為優鐵

標簽： 磁芯電感器分諧波失真

上傳時間： 2013-12-15

上傳用戶：天空說我在
如何測試穩壓器的負載瞬態響應

Semiconductor memory, card readers, microprocessors,disc drives, piezoelectric devices and digitally based systemsfurnish transient loads that a voltage regulator mustservice. Ideally, regulator output is invariant during a loadtransient. In practice, some variation is encountered andbecomes problematic if allowable operating voltage tolerancesare exceeded. This mandates TESTING the regulatorand its associated support components to verify desiredperformance under transient loading conditions. Variousmethods are employable to generate transient loads, allowingobservation of regulator response

標簽： 如何測試穩壓器瞬態響應負載

上傳時間： 2013-11-21

上傳用戶：semi1981
BGP測試工具集的設計與實現

協議是互聯網絡的靈魂，而協議測試是確保網絡交互暢通無阻的守護神。尤其是當人們進入一個新的紀元，網絡通信成為信息流通的首選手段，與協議不符合的產品必將被淘汰，因而協議測試也越來越受到人們的重視。Protocols are the soul of the Internet, and Protocol TESTING isa guarding deamon for the network transaction to be sound and strong.

標簽： BGP 測試工具

上傳時間： 2013-10-08

上傳用戶：zhyfjj
Grammatica is a C# and Java parser generator (compiler compiler). It improves upon simlar tools (lik

Grammatica is a C# and Java parser generator (compiler compiler). It improves upon simlar tools (like yacc and ANTLR) by creating well-commented and readable source code, by having automatic error recovery and detailed error messages, and by support for TESTING and debugging grammars without generating source code. It supports LL(k) grammars with an unlimited number of look-ahead tokens.

標簽： compiler Grammatica generator improves

上傳時間： 2015-01-11

上傳用戶：stella2015
The Gray Watson debugging malloc library is C source code for a drop in replacement for the system m

The Gray Watson debugging malloc library is C source code for a drop in replacement for the system malloc & other memory manage ment routines. What is unique about this library is that it contains a number of powerful debugging facilities including very comprehensive heap TESTING and ex- cellent run-time debugging information.

標簽： replacement debugging for library

上傳時間： 2015-02-05

上傳用戶：TF2015