欧美中文字幕视频,亚洲激情综合,少妇一区二区视频

adjustable

A fast customizable function for locating and measuring the peaks in noisy time-series signals. Adju

A fast customizable function for locating and measuring the peaks in noisy time-series signals. adjustable parameters allow discrimination of "real" signal peaks from noise and background. Determines the position, height, and width of each peak by least-squares curve-fitting.

標簽： customizable time-series measuring function

上傳時間： 2015-08-10

上傳用戶：invtnewer
Software uart using a general purpose io and an external interrupt pin of an atmel uc. half duplex o

Software uart using a general purpose io and an external interrupt pin of an atmel uc. half duplex operation, adjustable baud rate

標簽： interrupt Software external general

上傳時間： 2013-12-31

上傳用戶：zhangyigenius
MAX1771

12V or adjustable, High-Efficiency,Low IQ, Step-Up DC-DC Controller

標簽： 1771 MAX

上傳時間： 2016-10-20

上傳用戶：oyjwle
AP2406技術手冊

The AP2406 is a 1.5Mhz constant frequency, slope compensated current mode PWM step-down converter. The device integrates a main switch and a synchronous rectifier for high efficiency without an external Schottky diode. It is ideal for powering portable equipment that runs from a single cell lithium-Ion (Li+) battery. The AP2406 can supply 600mA of load current from a 2.5V to 5.5V input voltage. The output voltage can be regulated as low as 0.6V. The AP2406 can also run at 100% duty cycle for low dropout operation, extending battery life in portable system. Idle mode operation at light loads provides very low output ripple voltage for noise sensitive applications. The AP2406 is offered in a low profile (1mm) 5-pin, thin SOT package, and is available in an adjustable version and fixed output voltage of 1.2V, 1.5V and 1.8V

標簽： 2406 AP 技術手冊

上傳時間： 2017-02-23

上傳用戶：w124141
AZ1117H

The AZ1117 is a series of low dropout three-terminal regulators with a dropout of 1.15V at 1A output current. The AZ1117 series provides current limiting and thermal shutdown. Its circuit includes a trimmed bandgap reference to assure output voltage accuracy to be within 1% for 1.5V, 1.8V, 2.5V, 2.85V, 3.3V, 5.0V and adjustable versions or 2% for 1.2V version. Current limit is trimmed to ensure specified output current and controlled short-circuit current. On-chip thermal shutdown provides protection against any combination of overload and ambient temperature that would create excessive junction temperature. The AZ1117 has an adjustable version, that can provide the output voltage from 1.25V to 12V with only 2 external resistors.

標簽： 1117H 1117 AZ

上傳時間： 2019-04-11

上傳用戶：heaven0o0o0
SC3633

Wide 2.2V to 6V Input Voltage Range ? 0.20V FB adjustable LED drive current ? Directly drive 9 Series 1W LED at VIN>=6V ? Fixed 800KHz Switching Frequency ? Max. 3A Switching Current Capability ? Up to 92% efficiency ? Excellent line and load regulation ? EN PIN TTL shutdown capability ? Internal Optimize Power MOSFET

標簽： sc3633

上傳時間： 2021-11-05

上傳用戶：d1997wayne
PW2053-2.0.pdf規格書

The PW2053 is a high-efficiency monolithic synchronous buck regulator using a constantfrequency, current mode architecture. The device is available in an adjustable version. Supply currentwith no load is 40uA and drops to <1uA in shutdown. The 2.5V to 5.5V input voltage range makesthe PW2053 ideally suited for single Li-Ion battery powered applications. 100% duty cycle provideslow dropout operation, extending battery life in portable systems. PWM/PFM mode operationprovides very low output ripple voltage for noise sensitive applications. Switching frequency isinternally set at 1.2MHz, allowing the use of small surface mount inductors and capacitors. Lowoutput voltages are easily supported with the 0.6V feedback reference voltage

標簽： pw2053

上傳時間： 2022-02-14

上傳用戶：jason_vip1
步進電機驅動器原理圖+PCB+驅動源碼+使用教程等

該步進電機驅動器又稱為EasyDriver，EasyDriver能夠為兩級步進電機提供大約每相750mA（兩極一共1.5A）的驅動。它默認設置為8步細分模式（所以如果你的電機是每圈200步，你使用EasyDriver時默認為每圈1600步），更多細分模式可以通過將MS1或MS2兩個接腳接地進行設置。這是一種基于Allegro A3967驅動芯片的細分斷路器。對于此設計的完整規格，請查閱A3967的參數表。它的最大每相電流從150mA到750mA。可以采用的最大驅動電壓大概是30V，其中包括板載5V的調壓器，所以只需要一個電源。質優價廉，這玩意兒只要十幾美元，比你自己制作電路板更便宜。步進電機驅動器設計特色：· A3967 Microstepping Driver· MS1 and MS2 pins broken out to change microstepping resolution to full, half, quarter and eighth steps (defaults to eighth)· Compatible with 4, 6, and 8 wire stepper motors of any voltage· adjustable current control from 150mA/phase to 700mA/phase· Power supply range from 6V to 30V. The higher the voltage, the higher the torque at high speeds

標簽： 步進電機驅動器 pcb 驅動

上傳時間： 2022-04-27

上傳用戶：