介紹了一種基于c8051F020單片機的多路壓力測量儀。該測量儀選用電阻應變式壓力傳感器采集壓力信號,并經放大電路處理后送入c8051F020單片機,再由c8051F020單片機內部的A/D轉換器將采集到的壓力信號進行模數轉化,然后分別對數據進行存儲和顯示。該測量儀能測量6路壓力信號,并且各測量點都能單獨檢測和設置。由于采用了c8051F020單片機,簡化了硬件電路,增強了抗干擾能力,使得測量儀具有測量精度高,沖擊小等特點。
Abstract:
A measurement apparatus for multi-channel pressure based on single chip microcomputer is introduced.It can measure 6 channels signal of the pressure,and the pressure measure points can be detection and located individually.The pressure signal sampling is obtained by resistor stress-type pressure sensors,the digital signals of 6 channels are collected through amplifying and adjustment circuit of pressure signals and internal integrated A/D converter of MCU.Finally,and it realizes the function to store and display data separately.c8051F020 was used to made hardware circuit simple,and it also enhanced the anti-interference ability.It features high precision and little impact.
c8051F020單片機通過SPI接口驅動四線電阻式觸摸屏控制器TSC2046,利用中斷方式驅動TSC2046設計軟件。介紹了觸摸屏的工作原理、TSC2046工作方式以及典型應用電路。
Abstract:
The c8051F020 MCU is connected with the TSC2046 which is a 4-wire touch screen controller. The TSC2046 is controlled by interrupt mode, the? operation principle of touch screen is introduced. The operation mode of TSC2046 and typical application circuit are also discussed.
介紹了基于單片機c8051F020的通用串口適配器的設計與實現方法,即由單片機控制的智能化一對多口收發信號轉換器。通過采用C51對單片機進行編程,控制與RS-232(標準RS-232電平)、RS232(TTL電平)、RS-422接口的數據通信;采用C++ Builder作為開發平臺,通過RS-232接口實現上位機對適配器各個通信端口的控制。
Abstract:
Design and realization of a universal serial port adapter based on the MCU c8051F020 are introduced.The adapter is an intelligent one-to-more receiving and transmitting signal converter controlled by the MCU. By programming the MCU with the language C51,MCU control data communication between the MCU and RS-232(RS-232 level),RS-232(TTL level),RS-422 port; Using C++ Builder as the development plane, by one RS232 port, the upper PC can control each of the communication port of the adapter.
The c8051F020/1/2/3 devices are fully integrated mixed-signal System-on-a-Chip MCUs with 64 digital I/O pins (c8051F020/2) or 32 digital I/O pins (C8051F021/3). Highlighted features are listed below; refer to Table 1.1 for specific product feature selection.