The Hardware Book contains misc technical information about computeRS
and other electronic devices. You ll find the pinout to most common
(and uncommon) connectors availble, as well as info about how to build
ACM試題An Easy Problem
Description
As we known, data stored in the computeRS is in binary form. The problem we discuss now is about the positive integers and its binary form. Given a positive integer I, you task is to find out an integer J, which is the minimum integer greater than I, and the number of 1 s in whose binary form is the same as that in the binary form of I. For example, if "78" is given, we can write out its binary form, "1001110". This binary form has 4 1 s. The minimum integer, which is greater than "1001110" and also contains 4 1 s, is "1010011", i.e. "83", so you should output "83".
The Linux Enterprise Cluster explains how to take a number of inexpensive computeRS with limited resources, place them on a normal computer network, and install free software so that the computeRS act together like one powerful server. This makes it possible to build a very inexpensive and reliable business system for a small business or a large corporation. The book includes information on how to build a high-availability server pair using the Heartbeat package, how to use the Linux Virtual Server load balancing software, how to configure a reliable printing system in a Linux cluster environment, and how to build a job scheduling system in Linux with no single point of failure.
The book also includes information on high availability techniques that can be used with or without a cluster, making it helpful for System Administrators even if they are not building a cluster. Anyone interested in deploying Linux in an environment where low cost computer reliability is important will find this book useful.
This project aim was to build wireless software modem for data communication
between two computeRS using an acoustic interface in the voice frequency range (20Hz–
20,000Hz). The transmitting antenna is a speaker (frequency response of: 90Hz –
20,000Hz) and the receiving antenna is a microphone (frequency response of: 100Hz –
16,000Hz). The test files used as information files were text files.
This goal was attained both in an incoherent scheme and in a coherent scheme.
Build under Matlab code, our modem uses OFDM (orthogonal frequency division
multiplexing) modulation, synchronization by LMS sequence, channel estimation (no
equalizer) via pilot tones. The symbols are either PSK or ASK for a constellation size of
2 or 4. To optimize the probability of error, these symbols were mapped using Gray
mapping.
Report
As mentioned, most computeRS include a serial port. The only hardware setup required is connecting the serial cable to the serial port on the PC and the serial port on the instrument. The serial instrument may include some hardware drivers or software utilities for communication, and should include documentation on the baud rate, packet size, stop bits, and parity bits that the instrument will use. Additionally, check the National Instruments Instrument Driver Network to see if LabVIEW drivers already exist for yout instrument, as
The Hardware Book contains misc technical information about computeRS
and other electronic devices. You ll find the pin out to most common
(and uncommon) connectors availble, as well as info about how to build cables.
