基于單片機的步進電機開環控制系統:通過ATMEL89C51單片機對步進電機進行控制,主要介紹了步進電機控制器、驅動電路和LED顯示電路的設計,實現了步進電機的開環控制。在步進電機控制器的設計中,重點闡述了脈沖產生電路以及對速度的控制。該系統具有成本低、控制方便的特點。關鍵詞: 單片機; 步進電機; 開環控制 Abstract: The design using ATMEL89C51 single chip to control the step2motor with its controller, driving circuit and LED disp lay circuit to realize step motor open2loop controlwere introduced. For the controller in this design,the circuit to p roduce pulse and the speed controlwere expatiated emphatically. This system possesses features of lower cost, easier control.Key words: single ch ip; step2motor; open2loop con trol
上傳時間： 2013-10-13
上傳用戶：cicizoe
基于單片機控制的二氧化碳濃度測試計:基于CDM4161二氧化碳氣體濃度測試模塊以及ATtiny26單片機,提出了一種二氧化碳濃度測試計的設計方案。該方案具有硬件電路簡單、成本低、可靠性高、測量準確等優點，具有較高的實用價值。 Abstract: Abstract：A desigh scheme of CO2 concentration meter based on CDM4161carbon dioxide concentration test module and ATtiny26micro-controller is presented in this paper.The design scheme features simple hardware circuit,low-cost,high reli-ability，accurate measurement and it has a high practical value.
上傳時間： 2013-11-14
上傳用戶：zjwangyichao
In this document, the term Ô60xÕ is used to denote a 32-bit microprocessor from the PowerPC architecture family that conforms to the bus interface of the PowerPC 601ª, PowerPC 603ª, or PowerPC 604 microprocessors. Note that this does not include the PowerPC 602ª microprocessor which has a multiplexed address/data bus. 60x processors implement the PowerPC architecture as it is speciÞed for 32-bit addressing, which provides 32-bit effective (logical) addresses, integer data types of 8, 16, and 32 bits,and ßoating-point data types of 32 and 64 bits (single-precision and double-precision).1.1 Overview The MPC106 provides an integrated high-bandwidth, high-performance, TTL-compatible interface between a 60x processor, a secondary (L2) cache or additional (up to four total) 60x processors, the PCI bus,and main memory. This section provides a block diagram showing the major functional units of the 106 and describes brießy how those units interact.Figure 1 shows the major functional units within the 106. Note that this is a conceptual block diagram intended to show the basic features rather than an attempt to show how these features are physically implemented on the device.
上傳時間： 2013-10-08
上傳用戶：18711024007
The MC68HC05K0 is a low cost, low pin countsingle chip microcomputer with 504 bytes of userROM and 32 bytes of RAM. The MC68HC05K0 isa member of the 68HC05K series of devices whichare available in 16-pin DIL or SOIC packages.It uses the same CPU as the other devices in the68HC05 family and has the same instructions andregisters. Additionally, the device has a 15-stagemulti-function timer and 10 general purposebi-directional I/0 lines. A mask option is availablefor software programmable pull-downs on all ofthe I/O pins and four of the pins are capable ofgenerating interrupts.The device is ideally suited for remote-controlkeyboard applications because the pull-downs andthe interrupt drivers on the port pins allowkeyboards to be built without any externalcomponents except the keys themselves. There isno need for external pull-up or pull-down resistors,or diodes for wired-OR interrupts, as these featuresare already designed into the device.
上傳時間： 2014-01-24
上傳用戶：zl5712176
基于多點網絡的水廠自動監控系統設計Design of MPI Based Automatic Monitoring and Control System in Water Works劉 美 俊(湖南工程學院，湘潭411101)摘要針對水廠工作水泵多、現場離控制站距離遠的特點，提出了一種基于MPI多點網絡的自動監控系統的設計方法，分析了系統的工作原理，介紹了系統中數據的采集與處理、主站與從站的通信原理以及系統軟件的設計。由于這種系統的主、從站PLC之間采用MPI網絡通信，具有運行可靠、性能價格比高的特點，所以適用于中小規模水廠的分布式監控場合。關鍵詞多點網絡主站從站監控系統Abstract Ina ccordancew ithth efe atuersof w aterw orks,i. e. ，manyp umpsin o perationa ndth ep umps， farfor mt hec ontrolst ation,th em ethodo fdesigninga na utomati(〕monitoringa ndc ontorlsy stemb asedo nM PIis p resented.Th eo perationalpr incipleo fth esy stemi san alyzed,th ed atac olection,data processing; communication between master station and slave station as wel as design and system software are discussed. Because MPI network communicationis used among master station, slave stations and PLC, the system is reliable and high cost-efective. It is， suitable for smal and mediumsized water works for distrbuted monitoring and control.Keywords MPI Masterst ation Slaves tation Monitoringa ndc ontorlsy stem 自來 水 廠 的自動控制系統一般分為兩大部分，一對組態硬件要求較高，投資較大。相對而言，MPI網是水源地深水泵的工作控制，一是水廠區變頻恒壓供絡速度可達187.5 M bps，通過一級中繼器傳輸距離可水控制，兩部分的實際距離通常都比較遠。某廠水源達Ikm 。根據水廠的具體情況，確定以MPI方式組地有3臺深井泵給水廠區的蓄水池供水。水廠區的成網絡，主站PLC為S7-300系列的CPU3121FM，從任務是對水池的水進行消毒處理后，通過加壓泵向管站為S7-200系列的CPU222。這樣既滿足了系統要路恒壓供水。選用Siemens公司的S7系列可編程控求，又相對于Profibus網絡節省了三分之一的成本，制器(PLC)和上位機組成實時數據采集和監控系統， 這種分布式監控系統具有較高的性能價格比。系統對深水泵進行遠程控制，對供水泵采用變頻器進行恒中PLC的物理層采用RS - 485接口，網絡延伸選用壓控制以保證整個水廠的電機設備安全、可靠地運帶防雷保護的中繼器，使系統的安全運行得到了保行。證。MPI網絡的拓撲結構如圖1所示。1 多點網絡(NWI)監控系統的組成Sie me ns 公司S7系列PLC通常有MP」多點網絡與Profibus現場總線網絡兩種組網方式。Profibus現場總線的應用目前較為普遍，通用性較好，它由Profibus一DP, Profibus一FMS, Profibus一PA組成。Profibus - DP型用于分散外設間的數據傳輸，傳輸速率為9.6kbps一12Mbps，主要用于現場控制器與分散1/0之間的通信，可滿足交直流調速系統快速響應的時間要求，特別適合于加工自動化領域的應用;Profibus - FMS主要解決車間級通信問題，完成中等傳輸速度的循環或非循環數據交換任務，適用于紡織、樓宇自動化、可編程控制器、低壓開關等;Profibus - PA型采用了OSI模型的物理層和數據鏈路層，適用于過程自動化的總線類型。
上傳時間： 2013-10-09
上傳用戶：fac1003
為了擴大監控范圍，提高資源利用率，降低系統成本，提出了一種多通道視頻切換的解決方案。首先從視頻信號分離出行場信號，然后根據行場信號由DSP和FPGA產生控制信號，控制多路視頻通道之間的切換，從而實現讓一個視頻處理器同時監控不同場景。實驗結果表明，該方案可以在視頻監控告警系統中穩定、可靠地實現視頻通道的切換。 Abstract: To expand the scope of monitoring， improve resource utilization， reduce system cost， a multiple video channels signal switching method is pointed out in this paper. First， horizontal sync signal and field sync signal from the video signal are separated， then control signal according to the sync signal by DSP and FPGA is generated to control the switching between multiple video channels. Thus， it achieves to make a video processor to monitor different place. Experimental results show that the method can realize video channel switching reliably， and is applied in the video monitoring warning system successfully.
上傳時間： 2013-11-09
上傳用戶：不懂夜的黑
As businesses and consumers expect more fromportable electronics, the FPGA industry has beencompelled to re-think how it serves these low-power,cost-sensitive markets. Application classes like
上傳時間： 2013-11-10
上傳用戶：XLHrest
This application note shows how to achieve low-cost, efficient serial configuration for Spartan FPGA designs. The approachrecommended here takes advantage of unused resources in a design, thereby reducing the cost, part count, memory size,and board space associated with the serial configuration circuitry. As a result, neither processor nor PROM needs to be fullydedicated to performing Spartan configuration.In particular, information is provided on how the idle processing time of an on-board controller can be used to loadconfiguration data from an off-board source. As a result, it is possible to upgrade a Spartan design in the field by sending thebitstream over a network.
上傳時間： 2014-08-16
上傳用戶：adada
WP369可擴展式處理平臺-各種嵌入式系統的理想解決方案 ：Delivering unrivaled levels of system performance,flexibility, scalability, and integration to developers,Xilinx's architecture for a new Extensible Processing Platform is optimized for system power, cost, and size. Based on ARM's dual-core Cortex™-A9 MPCore processors and Xilinx’s 28 nm programmable logic,the Extensible Processing Platform takes a processor-centric approach by defining a comprehensive processor system implemented with standard design methods. This approach provides Software Developers a familiar programming environment within an optimized, full featured,powerful, yet low-cost, low-power processing platform.
上傳時間： 2013-10-22
上傳用戶：685
FPGAs have changed dramatically since Xilinx first introduced them just 15 years ago. In thepast, FPGA were primarily used for prototyping and lower volume applications; custom ASICswere used for high volume, cost sensitive designs. FPGAs had also been too expensive and tooslow for many applications, let alone for System Level Integration (SLI). Plus, the development
標簽： Methodology Design Reuse FPGA
上傳時間： 2013-10-23
上傳用戶：旗魚旗魚
