Abstract: Engineers often wish that radio susceptibility (RS) or radio immunity could be cured with an antibiotic, a vaccine, or someform of cure-all. Unfortunately, solving the RS problem is not that easy. Indeed, the laws of physics apply. In this article we discusssources of RS. We also offer tips and hints to protect systems, power supplies, printed circuit boards (PCBs), and electroniccomponents from radio frequency interference.
標簽： Susceptibility Radio 無線電干擾
上傳時間： 2014-12-30
上傳用戶：旗魚旗魚
針對UHF讀寫器設計中，在符合EPC Gen2標準的情況下，對標簽返回的高速數據進行正確解碼以達到正確讀取標簽的要求，提出了一種新的在ARM平臺下采用邊沿捕獲統計定時器數判斷數據的方法，并對FM0編碼進行解碼。與傳統的使用定時器定時采樣高低電平的FM0解碼方法相比，該解碼方法可以減少定時器定時誤差累積的影響；可以將捕獲定時器數中斷與數據判斷解碼相對分隔開，使得中斷對解碼影響很小，實現捕獲與解碼的同步。通過實驗表明，這種方法提高了解碼的效率，在160 Kb/s的接收速度下，讀取一張標簽的時間約為30次/s。 Abstract: Aiming at the requirement of receiving correctly decoded data from the tag under high-speed communication which complied with EPC Gen2 standard in the design of UHF interrogator， the article introduced a new technology for FM0 decoding which counted the timer counter to judge data by using the edge interval of signal capture based on the ARM7 platform. Compared with the traditional FM0 decoding method which used the timer timed to sample the high and low level， the method could reduce the accumulation of timing error and could relatively separate capture timer interrupt and the data judgment for decoding， so that the disruption effect on the decoding was small and realizd synchronization of capture and decoding. Testing result shows that the method improves the efficiency of decoding， at 160 Kb/s receiving speed， the time of the interrogator to read a tag is about 30 times/s.
上傳時間： 2013-11-10
上傳用戶：liufei
Single-Ended and Differential S-Parameters Differential circuits have been important incommunication systems for many years. In the past,differential communication circuits operated at lowfrequencies, where they could be designed andanalyzed using lumped-element models andtechniques. With the frequency of operationincreasing beyond 1GHz, and above 1Gbps fordigital communications, this lumped-elementapproach is no longer valid, because the physicalsize of the circuit approaches the size of awavelength.Distributed models and analysis techniques are nowused instead of lumped-element techniques.Scattering parameters, or S-parameters, have beendeveloped for this purpose [1]. These S-parametersare defined for single-ended networks. S-parameterscan be used to describe differential networks, but astrict definition was not developed until Bockelmanand others addressed this issue [2]. Bockelman’swork also included a study on how to adapt single-ended S-parameters for use with differential circuits[2]. This adaptation, called “mixed-mode S-parameters,” addresses differential and common-mode operation, as well as the conversion betweenthe two modes of operation.This application note will explain the use of single-ended and mixed-mode S-parameters, and the basicconcepts of microwave measurement calibration.
上傳時間： 2014-03-25
上傳用戶：yyyyyyyyyy
One of the strengths of Synplify is the Finite State Machine compiler. This is a powerfulfeature that not only has the ability to automatically detect state machines in the sourcecode, and implement them with either sequential, gray, or one-hot encoding. But alsoperform a reachability analysis to determine all the states that could possibly bereached, and optimize away all states and transition logic that can not be reached.Thus, producing a highly optimal final implementation of the state machine.
標簽： Synplicity Machine Verilog Design
上傳時間： 2013-10-20
上傳用戶：蒼山觀海
在Multisim 10軟件環境下，設計一種由運算放大器構成的精確可控矩形波信號發生器，結合系統電路原理圖重點闡述了各參數指標的實現與測試方法。通過改變RC電路的電容充、放電路徑和時間常數實現了占空比和頻率的調節，通過多路開關投入不同數值的電容實現了頻段的調節，通過電壓取樣和同相放大電路實現了輸出電壓幅值的調節并提高了電路的帶負載能力，可作為頻率和幅值可調的方波信號發生器。Multisim 10仿真分析及應用電路測試結果表明，電路性能指標達到了設計要求。 Abstract: Based on Multisim 10， this paper designed a kind of rectangular-wave signal generator which could be controlled exactly composed of operational amplifier， the key point was how to implement and test the parameter indicators based on the circuit diagram. The duty and the frequency were adjusted by changing the time constant and the way of charging and discharging of the capacitor， the width of frequency was adjusted by using different capacitors provided with multiple switch， the amplitude of output voltage was adjusted by sampling voltage and using in-phase amplifier circuit，the ability of driving loads was raised， the circuit can be used as squarewave signal generator whose frequency and amplitude can be adjusted. The final simulation results of Multisim 10 and the tests of applicable circuit show that the performance indicators of the circuit meets the design requirements.
上傳時間： 2014-01-21
上傳用戶：shen007yue
This simple SDI Notepad-like application demonstrates how, taking advantage of the MFC support for Unicode, to Turkmenize labels of the specified menu items. Actually, Turkmen is not supported by Windows 2000, therefore, to create such resources as menu so that strings in Turkmen could be displayed I had to invent an additional technique 這是一個與記事本類似的簡單的SDI應用程序，演示了怎樣使用MFC來支持 Unicode，對指定的菜單條目進行Turkmenize標簽化。實際上，Windwos 2000并不支持Turknen,因此,創建了那些菜單資源以便那些字符串可以在Turknen中顯示,為此我必須開發其它的技術。 來源: http://www.codeguru.com/advancedui/SDI_Note.html
標簽： Notepad-like demonstrates application advantage
上傳時間： 2013-11-26
上傳用戶：txfyddz
FPFilter is a sample disk filter driver that demonstrates how a disk failure prediction filter driver could be implemented. A failure prediction filter driver can predict when a disk may fail and notify the disk driver stack of this condition.
標簽： filter disk demonstrates prediction
上傳時間： 2015-03-30
上傳用戶：變形金剛
Although there has been a lot of AVL tree libraries available now, nearly all of them are meant to work in the random access memory(RAM). Some of them do provide some mechanism for dumping the whole tree into a file and loading it back to the memory in order to make data in that tree persistent. It serves well when there s just small amount of data. When the tree is somewhat bigger, the dumping/loading process could take a lengthy time and makes your mission-critical program less efficient. How about an AVL tree that can directly use the disk for data storage ? If there s something like that, we won t need to read through the whole tree in order to pick up just a little bit imformation(a node), but read only the sectors that are neccssary for locating a certain node and the sectors in which that node lies. This is my initial motivation for writing a storage-media independent AVL Tree. However, as you step forth, you would find that it not only works fine with disks but also fine with memorys, too.
標簽： available libraries Although nearly
上傳時間： 2014-01-22
上傳用戶：zhoujunzhen
Many applications use connection/object pool. A program may require a IMAP connection pool and LDAP connection pool. One could easily implement a IMAP connection pool, then take the existing code and implement a LDAP connection pool. The program grows, and now there is a need for a pool of threads. So just take the IMAP connection pool and convert that to a pool of threads (Copy, paste, find, replace????). Need to make some changes to the pool implementation? Not a very easy task, since the code has been duplicated in many places. Re-inventing source code is not an intelligent approach in an object oriented environment which encourages re-usability. It seems to make more sense to implement a pool that can contain any arbitrary type rather than duplicating code. How does one do that? The answer is to use type parameterization, more commonly referred to as templates.
標簽： connection pool applications program
上傳時間： 2013-12-25
上傳用戶：playboys0
This build is for developing a "binary-to-BCD" converter for use in // displaying numerals in base-10 so that people can read and interpret the // numbers more readily than they could if the numbers were displayed in // binary or hexadecimal format. Also, a "BCD-to-binary" converter is // tested in this build.
標簽： binary-to-BCD developing displaying for
上傳時間： 2015-07-07
上傳用戶：lmeeworm
