This package contains assembly programs for testing how many clock cycles a piece of code takes to execute.
標簽： contains assembly programs package
上傳時間： 2013-11-25
上傳用戶：asdfasdfd
Edge Disjoint cycles. You are given an input graph that is either directed or undirected. Write a program that reads in a vertex number and lists the number of edge disjoint cycles that start and end at this vertex. The output should also list the edges in each of the cycle discovered. Input will be the adjacency matrix preceded by a 0 or 1 representing Directed or Undirected graphs respectively.
標簽： undirected Disjoint directed cycles
上傳時間： 2017-04-08
上傳用戶：13188549192
Utils and test SD card read write cycles
上傳時間： 2017-04-29
上傳用戶：小草123
Industrial systems demand semiconductors that are precise, flexibleand reliable. Linear Technology offers a broad line of high performanceanalog ICs that simplify system design with rugged devices featuringparameters fully guaranteed over the -40°C to 85°C temperature range.We back this up with knowledgeable applications support, long productlife cycles and superior on-time delivery.
上傳時間： 2013-11-02
上傳用戶：xiaodu1124
高的工作電壓高達100V N雙N溝道MOSFET同步驅動 The D810DCDC is a synchronous step-down switching regulator controller that can directly step-down voltages from up to 100V, making it ideal for telecom and automotive applications. The D810DCDC uses a constant on-time valley current control architecture to deliver very low duty cycles with accurate cycle-by-cycle current limit, without requiring a sense resistor. A precise internal reference provides 0.5% DC accuracy. A high bandwidth (25MHz) error amplifi er provides very fast line and load transient response. Large 1Ω gate drivers allow the D810DCDC to drive multiple MOSFETs for higher current applications. The operating frequency is selected by an external resistor and is compensated for variations in VIN and can also be synchronized to an external clock for switching-noise sensitive applications. Integrated bias control generates gate drive power from the input supply during start-up and when an output shortcircuit occurs, with the addition of a small external SOT23 MOSFET. When in regulation, power is derived from the output for higher effi ciency.
上傳時間： 2013-10-24
上傳用戶：wd450412225
The LTC®3610 is a high power monolithic synchronousstep-down DC/DC regulator that can deliver up to 12Aof continuous output current from a 4V to 24V (28Vmaximum) input supply. It is a member of a high currentmonolithic regulator family (see Table 1) that featuresintegrated low RDS(ON) N-channel top and bottomMOSFETs. This results in a high effi ciency and highpower density solution with few external components.This regulator family uses a constant on-time valleycurrent mode architecture that is capable of operatingat very low duty cycles at high frequency and with veryfast transient response. All are available in low profi le(0.9mm max) QFN packages.
上傳時間： 2013-11-07
上傳用戶：moerwang
Although Stellaris microcontrollers have generous internal SRAM capabilities, certain applicationsmay have data storage requirements that exceed the 8 KB limit of the Stellaris LM3S8xx seriesdevices. Since microcontrollers do not have an external parallel data-bus, serial memory optionsmust be considered. Until recently, the ubiquitous serial EEPROM/flash device was the only serialmemory solution. The major limitations of EEPROM and flash technology are slow write speed, slowerase times, and limited write/erase endurance.Recently, serial SRAM devices have become available as a solution for high-speed dataapplications. The N256S08xxHDA series of devices, from AMI Semiconductor, offer 32 K x 8 bits oflow-power data storage, a fast Serial Peripheral Interface (SPI) serial bus, and unlimited write cycles.The parts are available in 8-pin SOIC and compact TSSOP packages.
上傳時間： 2013-10-14
上傳用戶：cxl274287265
特點 精確度0.1%滿刻度 ±1位數 可量測 交直流電流/交直流電壓/電位計/傳送器/Pt-100/荷重元/電阻 等信號 顯示范圍-1999-9999可任意規劃 具有異常值與異常次數記錄保留功能 異常信號過高或過低或范圍內或范圍外檢測可任意設定 報警繼電器復歸方式可任意設定 尺寸小,穩定性高 2.主要規格 精確度: 0.1% F.S. ±1 digit 0.2% F.S. ±1 digit(AC) 取樣時間: 16 cycles/sec. 顯示值范圍: -1999 - +9999 digit adjustable 啟動延遲動作時間: 0-99.9 second adjustable 繼電器延遲動作時間: 0-99.9 second adjustable 繼電器復歸方式: Manual (N) / latch(L) can be modified 繼電器動作方向: HI /LO/GO/HL can be modified 繼電器容量: AC 250V-5A, DC 30V-7A 過載顯示: "doFL" 溫度系數: 50ppm/℃ (0-50℃) 顯示幕: Red high efficiency LEDs high 14.22mm(.56")(PV) Red high efficiency LEDs high 7.0mm(.276")(NO) 參數設定方式: Touch switches 記憶型式 : Non-volatile E2PROM memory 絕緣耐壓能力: 2KVac/1 min. (input/output/power) 1600Vdc(input/output 使用環境條件 : 0-50℃(20 to 90% RH non-condensed) 存放環境條件: 0-70℃(20 to 90% RH non-condensed) CE認證: EN 55022:1998/A1:2000 Class A EN 61000-3-2:2000 EN 61000-3-3:1995/A1:2001 EN 55024:1998/A1:2001
上傳時間： 2013-11-02
上傳用戶：fandeshun
特點 精確度0.05%滿刻度 ±1位數 顯示范圍-19999-99999可任意規劃 可直接量測直流4至20mA電流,無需另接輔助電源 尺寸小(24x48x50mm),穩定性高 分離式端子,配線容易 CE 認證 主要規格 輔助電源: None 精確度: 0.05% F.S. ±1 digit(DC) 輸入抗阻: approx. 250 ohm with 20mA input 輸入電壓降: max. DC5V with 20mA input 最大過載能力: < ±50mA 取樣時間: 2.5 cycles/sec. 顯示值范圍: -19999 - 99999 digit adjustable 歸零調整范圍: -999-999 digit adjustable 最大值調整范圍: -999-999 digit adjustable 過載顯示: " doFL " or "-doFL" 極性顯示: " 一 " for negative readings 顯示幕 : Brigh Red LEDs high 8.6mm(.338") 溫度系數 : 50ppm/℃ (0-50℃) 參數設定方式: Touch switches 記憶型式: Non-volatile E2 外殼材料: ABS 絕緣耐壓能力: 2KVac/1 min. (input/case) 使用環境條件: 0-50℃(20 to 90% RH non-condensed) 存放環境條件: 0-70℃(20 to 90% RH non-condensed) 外型尺寸: 24x48x50mm CE認證: EN 55022:1998/A1:2000 Class A EN 61000-3-2:2000 EN 61000-3-3:1995/A1:2001 EN 55024:1998/A1:2001
上傳時間： 2013-10-09
上傳用戶：lhuqi
特點 精確度0.1%滿刻度 ±1位數 顯示范圍-19999-99999可任意規劃 可直接量測直流電流/直流電壓,無需另接輔助電源 尺寸小(24x48x50mm),穩定性高 分離式端子,配線容易 CE 認證 2.主要規格 輔助電源: None 精確度: 0.1% F.S. ±1 digit(1-100%F.S.) 輸入抗阻 : >100Mohm(<2V range) >2Mohm(<2Vrange) < 0.25VA(current ranges) < 1000Vrms(>54V ranges) 最大過載能力: < 150Vrms(<54V ranges)
上傳時間： 2013-10-08
上傳用戶：tiantwo
