Summary
Many control applications require converting some analog input to a digital format. The ADCINC12 User
Module is a general-purpose, 12-bit analog to digital converter (ADC) that does just that. This Application
Note is meant to be a simple introduction into its operation. The steps required to define, place, and write
software are presented. Examples are developed in both assembly and C.
The MEASURE program uses analog and digital inputs to simulate a datalogger.
You may watch the value of analog input POT1 and the state of S2, S3 Buttons
on MCBSTM32 evaluation board.
This document describes how to switch to and program the unisersal serial bus (USB)
analog phase-locked loop (APLL) on the C5506/C5507/C5509A devices. Example
assembly programs for programming and switching to and from the APLL are also
provided in the attached zip file. It is assumed that the reader is familiar with the use
and operation of the C5506/C5507/C5509A USB digital phase-locked loop (DPLL) and
C55x™ Digital Signal Processor (DSP) IDLE procedures.
In C Algorithms for Real-Time DSP, author Paul M. Embree presents a complete guide to digital signal processing techniques in the C programming language. This book is structured in such a way that it will be most useful to the engineer who is familiar with DSP and the C language, but who is not necessarily an expert in both. All of the example programs in this book have been tested using standard C compilers in the UNIX and MS-DOS programming environments. In addition, the examples have been compiled using the real-time programing tools of specific real-time embedded DSP microprocessors (Analog Devices ADSP-21020 and ADSP-21062 Texas Instruments TMS320C30 and TMS320C40 and AT&T DSP32C) and then tested with real-time hardware using real-world signals.
