A digital fi‘equeney meter designed with FPGA development software Q-~us 11 is introduced．The 1 Hz—l MHz input measured pulse signals of the digital ii‘equency meter can be used for measuring frequency，period，pulse width and duty ratio，etc．The test results stably display O71 3 seven—segment numeric tubes，and the measuring ranges may be switched over automatically．The measuring error is equal to or less than 0．1％．
標簽： development introduced designed software
上傳時間： 2016-04-09
上傳用戶：stewart·
DFT(Discrete Fourier Transformation)是數字信號分析與處理如圖形、語音及圖像等領域的重要變換工具，直接計算DFT的計算量與變換區間長度N的平方成正比。當N較大時，因計算量太大，直接用DFT算法進行譜分析和信號的實時處理是不切實際的。快速傅立葉變換(Fast Fourier Transformation，簡稱FFT)使DFT運算效率提高1～2個數量級。其原因是當N較大時，對DFT進行了基4和基2分解運算。FFT算法除了必需的數據存儲器ram和旋轉因子rom外，仍需較復雜的運算和控制電路單元，即使現在,實現長點數的FFT仍然是很困難。本文提出的FFT實現算法是基于FPGA之上的，算法完成對一個序列的FFT計算，完全由脈沖觸發，外部只輸入一脈沖頭和輸入數據，便可以得到該脈沖頭作為起始標志的N點FFT輸出結果。由于使用了雙ram，該算法是流型(Pipelined)的，可以連續計算N點復數輸入FFT，即輸入可以是分段N點連續復數數據流。采用DIF(Decimation In Frequency)-FFT和DIT(Decimation In Time)-FFT對于算法本身來說是無關緊要的，因為兩種情況下只是存儲器的讀寫地址有所變動而已，不影響算法的結構和流程，也不會對算法復雜度有何影響。
標簽： Transformation Discrete Fourier DFT
上傳時間： 2016-04-12
上傳用戶：lx9076
This example demonstrates how the C8051F06x SMBus interface can communicate // with a 256 byte I2C Serial EEPROM (Microchip 24LC02B). // - Interrupt-driven SMBus implementation // - Only master states defined (no slave or arbitration) // - Timer4 used by SMBus for SCL low timeout detection // - SCL frequency defined by <SMB_FREQUENCY> constant
標簽： demonstrates communicate C8051F06x interface
上傳時間： 2016-04-12
上傳用戶：hanli8870
在DAB系統中的頻率同步，載頻同步，參考一下Carrier frequency offset estimation of DAB receiver based on phase reference symbol
上傳時間： 2014-11-23
上傳用戶：songrui
// // Histogram Sample // This sample shows how to use the Sample Grabber filter for video image processing. // Conceptual background: // A histogram is just a frequency count of every pixel value in the image. // There are various well-known mathematical operations that you can perform on an image // using histograms, to enhance the image, etc. // Histogram stretch (aka automatic gain control): // Stretches the image histogram to fill the entire range of values. This is a "point operation," // meaning each pixel is scaled to a new value, without examining the neighboring pixels. The // histogram stretch does not actually require you to calculate the full histogram. The scaling factor // is calculated from the minimum and maximum values in the image.
標簽： Sample Histogram Grabber sample
上傳時間： 2013-12-15
上傳用戶：ryb
Squaring circuits are an important building block for impulse-radio UWB non-coherent receivers. This work proposes a squarer, based on the quadratic law of saturated transistors. Such a circuit has already been proposed for lower frequency applications, therefore this work focuses on the extension to ultra wide bandwidth, with particular care to the consequences related to the deviation from the ideal quadratic law of 0.18μm CMOS transistors.
標簽： impulse-radio non-coherent important receivers
上傳時間： 2013-12-24
上傳用戶：kikye
This paper presents the key circuits of a 1MHz bandwidth, 750kb/s GMSK transmitter. The fractional-N synthesizer forming the basis of the transmitter uses a combined phasefrequency detector (PFD) and digital-to-analog converter (DAC) circuit element to obtain >28dB high frequency noise reduction when compared to classicalfrequency synthesis.
標簽： fractional-N transmitter bandwidth circuits
上傳時間： 2016-04-14
上傳用戶：er1219
This manual describes Freescale’s IEEE™ 802.15.4 Standard compliant MAC/PHY software. The Freescale 802.15.4 MAC/PHY software is designed for use with the Freescale MC1319x and MC1320x, family of short range, low power, 2.4 GHz Industrial, Scientific, and Medical (ISM) band transceivers, designed for use with the HCS08 Family of MCUs. The MAC/PHY software also works with the MC1321x family of short range, low power, 2.4 GHz ISM band transceivers that incorporate a low power 2.4 GHz radio frequency transceiver and an 8-bit microcontroller into a single LGA package. Throughout this manual, the term transceiver refers to either the MC1319x, MC1320x, or the internal counterpart inside the MC1321x System in a Package (SiP).
標簽： Freescale describes compliant Standard
上傳時間： 2016-04-17
上傳用戶：caiiicc
Using LabVIEW 8.5 Language to control Tektronix AWG3102. This program can select output waveform, frequency and amplitude.
標簽： Tektronix Language waveform LabVIEW
上傳時間： 2016-05-17
上傳用戶：xlcky
Using LabVIEW to control Tektronix AWG2021 via GPIB. This program can select output waveform, frequency and amplitude.
標簽： Tektronix waveform LabVIEW control
上傳時間： 2014-10-13
上傳用戶：66666
