Features • Compatible with MCS-51® Products • 8K Bytes of In-System Programmable (ISP) Flash Memory – Endurance: 1000 Write/Erase Cycles • 4.0V to 5.5V Operating Range • Fully Static Operation: 0 Hz to 33 MHz • Three-level Program Memory Lock • 256 x 8-bit Internal RAM • 32 Programmable I/O Lines • Three 16-bit Timer/Counters • Eight Interrupt Sources • Full Duplex UART Serial Channel • Low-power idle and Power-down Modes • Interrupt Recovery from Power-down Mode • Watchdog Timer • Dual Data Pointer • Power-off Flag
標簽： 8226 Programmable Compatible In-System
上傳時間： 2015-06-27
上傳用戶：dianxin61
利用PspTerminateProcess結束進程，除了2個系統進程（[System idle]、System），其它的都能殺。
上傳時間： 2016-04-05
上傳用戶：zq70996813
功能是檢測一個5位二進制序列“10010”?？紤]到序列重疊的可能，有限狀態機共提供8個狀態（包括初始狀態idle）。
上傳時間： 2016-07-03
上傳用戶：龍飛艇
This document describes how to switch to and program the unisersal serial bus (USB) analog phase-locked loop (APLL) on the C5506/C5507/C5509A devices. Example assembly programs for programming and switching to and from the APLL are also provided in the attached zip file. It is assumed that the reader is familiar with the use and operation of the C5506/C5507/C5509A USB digital phase-locked loop (DPLL) and C55x™ Digital Signal Processor (DSP) idle procedures.
標簽： describes unisersal document phase-lo
上傳時間： 2014-01-13
上傳用戶：hustfanenze
1. This BSP can support 2443EVT0 board. If you want to use EVT0 BSP, set followings. In smdk2443\smdk2443.bat file set BSP_EVT1=1 -> set BSP_EVT1= In smdk2443\src\inc\bsp_cfg.h file #define EVT1 -> #define EVT0 2. Default system tick mode is changed. The value is fixed tick. Fixed tick means that tick interrupt is occurred every 1ms. Variable tick means that timer interrupt period is changed when power mode is in idle. For changing to variable tick In smdk2443\src\inc\bsp_cfg.h file #define FIXEDTICK -> #define VARTICK In smdk2443\src\Common\Timer\Sources file SOURCES= timer_fixedtick.c watchdog.c -> SOURCES= timer_vartick.c watchdog.c
標簽： EVT0 followings BSP support
上傳時間： 2014-01-27
上傳用戶：fnhhs
scmRTOS is real-time preemptive operating system and supports up to 31 user processes (and one system idle process).
標簽： preemptive and real-time operating
上傳時間： 2017-06-22
上傳用戶：yulg
scmRTOS is real-time preemptive operating system and supports up to 31 user processes (and one system idle process).
標簽： preemptive and real-time operating
上傳時間： 2017-06-22
上傳用戶：894898248
WiseMAC is a medium access control protocol designed for the WiseNETTMwireless sensor network. It is based on CSMA and uses the preamble sampling technique to minimize the power consumed when listening to an idle medium.
標簽： WiseNETTMwireless designed protocol WiseMAC
上傳時間： 2014-01-20
上傳用戶：x4587
The AP2406 is a 1.5Mhz constant frequency, slope compensated current mode PWM step-down converter. The device integrates a main switch and a synchronous rectifier for high efficiency without an external Schottky diode. It is ideal for powering portable equipment that runs from a single cell lithium-Ion (Li+) battery. The AP2406 can supply 600mA of load current from a 2.5V to 5.5V input voltage. The output voltage can be regulated as low as 0.6V. The AP2406 can also run at 100% duty cycle for low dropout operation, extending battery life in portable system. idle mode operation at light loads provides very low output ripple voltage for noise sensitive applications. The AP2406 is offered in a low profile (1mm) 5-pin, thin SOT package, and is available in an adjustable version and fixed output voltage of 1.2V, 1.5V and 1.8V
上傳時間： 2017-02-23
上傳用戶：w124141
LTE小區重選相關準則 idle 和connected狀態下
上傳時間： 2019-01-01
上傳用戶：hzsc
