BC20-TE-B NB-Iot 評估板評估板原廠原理圖V1.2。完整對應實物裝置。
上傳時間： 2022-06-17
上傳用戶：
ASR M08-B設置軟件 V3.2 arduino 2560+ASRM08-B測試程序 arduino UNO+ASRM08-B測試程序語音控制臺燈電路圖及C51源碼(不帶校驗碼) 繼電器模塊設置。 ASR M08-B是一款語音識別模塊。首先對模塊添加一些關鍵字，對著該模塊說出關鍵字，串口會返回三位的數，如果是返回特定的三位數字，還會引起ASR M08-B的相關引腳電平的變化。【測試】①打開“ASR M08-B設置軟件 V3.2.exe”。②選擇“串口號”、“打開串口”、點選“十六進制顯示”。③將USB轉串口模塊連接到語音識別模塊上。接線方法如下：語音模塊TXD --> USB模塊RXD語音模塊RXD --> USB模塊TXD語音模塊GND --> USB模塊GND語音模塊3V3 --> USB模塊3V3（此端為3.3V電源供電端。）④將模塊的開關撥到“A”端，最好再按一次上面的大按鈕（按一次即可，為了確保模塊工作在正確的模式）。⑤對著模塊說“開燈”、“關燈”模塊會返回“0B”、“0A”，表示正常(注意：0B對應返回值010，0B對應返回值010，返回是16進制顯示的嘛，設置的時候是10進制設置的)。
標簽： ASR M08-B
上傳時間： 2022-07-06
上傳用戶：aben
The PCA9549 provides eight bits of high speed TTL-compatible bus switching controlledby the I2C-bus. The low ON-state resistance of the switch allows connections to be madewith minimal propagation delay. Any individual A to B channel or combination of channelscan be selected via the I2C-bus, determined by the contents of the programmable Controlregister. When the I2C-bus bit is HIGH (logic 1), the switch is on and data can flow fromPort A to Port B, or vice versa. When the I2C-bus bit is LOW (logic 0), the switch is open,creating a high-impedance state between the two ports, which stops the data flow.An active LOW reset input (RESET) allows the PCA9549 to recover from a situationwhere the I2C-bus is stuck in a LOW state. Pulling the RESET pin LOW resets the I2C-busstate machine and causes all the bits to be open, as does the internal power-on resetfunction.
上傳時間： 2014-11-22
上傳用戶：xcy122677
All inputs of the C16x family have Schmitt-Trigger input characteristics. These Schmitt-Triggers are intended to always provide proper internal low and high levels, even if anundefined voltage level (between TTL-VIL and TTL-VIH) is externally applied to the pin.The hysteresis of these inputs, however, is very small, and can not be properly used in anapplication to suppress signal noise, and to shape slow rising/falling input transitions.Thus, it must be taken care that rising/falling input signals pass the undefined area of theTTL-specification between VIL and VIH with a sufficient rise/fall time, as generally usualand specified for TTL components (e.g. 74LS series: gates 1V/us, clock inputs 20V/us).The effect of the implemented Schmitt-Trigger is that even if the input signal remains inthe undefined area, well defined low/high levels are generated internally. Note that allinput signals are evaluated at specific sample points (depending on the input and theperipheral function connected to it), at that signal transitions are detected if twoconsecutive samples show different levels. Thus, only the current level of an input signalat these sample points is relevant, that means, the necessary rise/fall times of the inputsignal is only dependant on the sample rate, that is the distance in time between twoconsecutive evaluation time points. If an input signal, for instance, is sampled throughsoftware every 10us, it is irrelevant, which input level would be seen between thesamples. Thus, it would be allowable for the signal to take 10us to pass through theundefined area. Due to the sample rate of 10us, it is assured that only one sample canoccur while the signal is within the undefined area, and no incorrect transition will bedetected. For inputs which are connected to a peripheral function, e.g. capture inputs, thesample rate is determined by the clock cycle of the peripheral unit. In the case of theCAPCOM unit this means a sample rate of 400ns @ 20MHz CPU clock. This requiresinput signals to pass through the undefined area within these 400ns in order to avoidmultiple capture events.For input signals, which do not provide the required rise/fall times, external circuitry mustbe used to shape the signal transitions.In the attached diagram, the effect of the sample rate is shown. The numbers 1 to 5 in thediagram represent possible sample points. Waveform a) shows the result if the inputsignal transition time through the undefined TTL-level area is less than the time distancebetween the sample points (sampling at 1, 2, 3, and 4). Waveform b) can be the result ifthe sampling is performed more than once within the undefined area (sampling at 1, 2, 5,3, and 4).Sample points:1. Evaluation of the signal clearly results in a low level2. Either a low or a high level can be sampled here. If low is sampled, no transition willbe detected. If the sample results in a high level, a transition is detected, and anappropriate action (e.g. capture) might take place.3. Evaluation here clearly results in a high level. If the previous sample 2) had alreadydetected a high, there is no change. If the previous sample 2) showed a low, atransition from low to high is detected now.
上傳時間： 2013-10-23
上傳用戶：copu
附件有51單片機加上sl811讀寫U盤的源程序和原理圖 /*--------------------------------------------------------------------------AT89X52.H Header file for the low voltage Flash Atmel AT89C52 and AT89LV52.Copyright (c) 1995-1996 Keil Software, Inc. All rights reserved.--------------------------------------------------------------------------*/ #ifndef AT89X52_HEADER_FILE#define AT89X52_HEADER_FILE 1 /*------------------------------------------------Byte Registers------------------------------------------------*/sfr P0 = 0x80;sfr SP = 0x81;sfr DPL = 0x82;sfr DPH = 0x83;sfr PCON = 0x87;sfr TCON = 0x88;sfr TMOD = 0x89;sfr TL0 = 0x8A;sfr TL1 = 0x8B;sfr TH0 = 0x8C;sfr TH1 = 0x8D;sfr P1 = 0x90;sfr SCON = 0x98;sfr SBUF = 0x99;sfr P2 = 0xA0;sfr IE = 0xA8;sfr P3 = 0xB0;sfr IP = 0xB8;sfr T2CON = 0xC8;sfr T2MOD = 0xC9;sfr RCAP2L = 0xCA;sfr RCAP2H = 0xCB;sfr TL2 = 0xCC;sfr TH2 = 0xCD;sfr PSW = 0xD0;sfr ACC = 0xE0;sfr B = 0xF0;
上傳時間： 2014-01-05
上傳用戶：lnnn30
摘 要:用一種新的思路和方法,先計算低通、再計算高通濾波器的有關參數,然后組合成帶通濾波器.關鍵詞:濾波器;參數;新思路中圖分類號: TN713. 5 文獻識別碼:B 文章編號:1008 - 1666 (1999) 04 - 0089 - 03A New Consideration of the Band Filter’s CalculationGuo Wencheng( S hao Yang B usiness and Technology school , S haoyang , Hunan ,422000 )Abstract :This essay deals with a new method of calculating the band filters - first calculatingthe relevant parameters of low - pass filters ,then calculating the ones of high - pass filters.Key words :filter ; parameters ;new considercation八十年代后,信息產業得到了迅猛發展. 帶通濾波器在微波通信、廣播電視和精密儀器設備中得到了廣泛應用. 帶通濾波器性能的優劣,對提高接收機信噪比,防止鄰近信道干擾,提高設備的技術指標,有著十分重要的意義.我在長期的教學實踐中,用切比雪夫型方法設計、計算出寬帶濾波器集中參數元件的數據. 該濾波器可運用在檢測微波頻率的儀器和其他設備中. 再將其思路和計算方法介紹給大家,供參考.
上傳時間： 2014-12-28
上傳用戶：Yukiseop
The RT9018A/B is a high performance positive voltage regulator designed for use in applications requining very low Input voltage and very low dropout voltage at up to 3A(peak).
上傳時間： 2013-10-10
上傳用戶：geshaowei
DirectX not only provides fast access to the hardware and therefore incredibly speedy performance, but it also makes it much easier for hardware developers to produce new devices that work well in the Windows environment. The DirectX APIs take away the necessity of writing your own low-level, device-specific code to access hardware such as the display adapter and network card, making it much easier for you to write programs that take full advantage of the computer s multimedia capabilities.
標簽： performance incredibly therefore hardware
上傳時間： 2016-02-16
上傳用戶：秦莞爾w
Lithium–sulfur batteries are a promising energy-storage technology due to their relatively low cost and high theoretical energy density. However, one of their major technical problems is the shuttling of soluble polysulfides between electrodes, resulting in rapid capacity fading. Here, we present a metal–organic framework (MOF)-based battery separator to mitigate the shuttling problem. We show that the MOF-based separator acts as an ionic sieve in lithium–sulfur batteries, which selectively sieves Li+ ions while e ciently suppressing undesired polysulfides migrating to the anode side. When a sulfur-containing mesoporous carbon material (approximately 70 wt% sulfur content) is used as a cathode composite without elaborate synthesis or surface modification, a lithium–sulfur battery with a MOF-based separator exhibits a low capacity decay rate (0.019% per cycle over 1,500 cycles). Moreover, there is almost no capacity fading after the initial 100 cycles. Our approach demonstrates the potential for MOF-based materials as separators for energy-storage applications.
上傳時間： 2017-11-23
上傳用戶：653357637
Fire and Fury。 This article is about the 2018 book. For other uses, see Fire and Fury (disambiguation). The title refers to a quote by Trump about the conflict with North Korea. The book became a New York Times number one bestseller.Fire and Fury: Inside the Trump White House is a 2018 book by Michael Wolff which details the behavior of U.S. President Donald Trump and the staff of his 2016 presidential campaign and White House. The book highlights descriptions of Trump's behavior, chaotic interactions among senior White House staff, and derogatory comments about the Trump family by former White House Chief StrategistSteve Bannon. Trump is depicted as being held in low regard by his White House staff, leading Wolff to state that "100% of the people around him" believe Trump is unfit for office.[1] Reviewers generally accepted Wolff's portrait of a dysfunctional Trump administration, but were skeptical of many of the book's most controversial claims.
上傳時間： 2018-02-26
上傳用戶：Yoobaobao
