The PCA9549 provides eight bits of high speed TTL-compatible bus switching controlledby the I2C-bus. The low ON-state resistance of the switch allows connections to be madewith minimal propagation delay. Any individual A to B channel or combination of channelscan be selected via the I2C-bus, determined by the contents of the programmable Controlregister. When the I2C-bus bit is HIGH (logic 1), the switch is on and data can flow fromPort A to Port B, or vice versa. When the I2C-bus bit is LOW (logic 0), the switch is open,creating a high-impedance state between the two ports, which stops the data flow.An active LOW reset input (RESET) allows the PCA9549 to recover from a situationwhere the I2C-bus is stuck in a LOW state. Pulling the RESET pin LOW resets the I2C-busstate machine and causes all the bits to be open, as does the internal power-on resetfunction.
基于USB接口的數據采集模塊的設計與實現Design and Implementation of USB-Based Data Acquisition Module路 永 伸(天津科技大學電子信息與自動化學院，天津300222)摘要文中給出基于USB接口的數據采集模塊的設計與實現。硬件設計采用以Adpc831與PDIUSBDI2為主的器件進行硬件設計，采用Windriver開發USB驅動，并用Visual C十十6.0對主機軟件中硬件接口操作部分進行動態鏈接庫封裝。關鍵詞USB 數據采集Adpc831 PDNSBDI2 Windriver動態鏈接庫Abstract T hed esigna ndim plementaitono fU SB-BasedD ataA cquisiitonM oduleis g iven.Th ec hips oluitonm ainlyw ithA dpc831a ndP DTUSBD12i sused for hardware design. The USB drive is developed場Wmdriver, and the operation on the hardware interface is packaged into Dynamic Link Libraries場Visual C++6.0. Keywords USB DataA cquisition Adttc831 PDfUSBD12 Windriver0 引言US B總 線 是新一代接口總線，最初推出的目的是為了統一取代PC機的各類外設接口，迄今經歷了1.0,1.1與2.0版本3個標準。在國內基于USB總線的相關設計與開發也得到了快速的發展，很多設計者從各自的應用領域，用不同方案設計出了相應的裝置[1,2]。數據采集是工業控制中一個普遍而重要的環節，因此開發基于USB接口的數據采集模塊具有很強的現實應用意義。雖然 US B總線標準已經發展到2.0版本，但由于工業控制現場干擾信號的情況比較復雜，高速數據傳輸的可靠性不容易被保證，并且很多場合對數據采集的實時性要求并不高，開發2.0標準產品的成本又較1.1標準產品高，所以筆者認為，在工業控制領域，目前開發基于USB總線1.1標準實現的數據采集模塊的實用意義大于相應2.0標準模塊。
