This a simple bootloader for AT91SAM7{S,X}{64,128,256} processors. It permits you to download new code to the device over USB. This bootrom is installed at address 0x00000000 in the ARM, which means that it is the first piece of code to execute after reset. At startup, it waits for a few seconds to see if the downloader is trying to connect. If not, then the bootloader gives up control and jumps to your program. If the downloader is trying to connect, then the bootloader receives the new program over USB and writes it into flash.
標簽： bootloader processors download permits
上傳時間： 2015-11-30
上傳用戶：shus521
It permits simultaneous use of multiple USB Serial protocols.
標簽： simultaneous protocols multiple permits
上傳時間： 2014-01-23
上傳用戶：cccole0605
permits to negotiate of simple form (without code) some of the most utilized combinations of keys in the forms. It suffices with freeing the component on the form and to activate the properties desired segun the behavior that want. * ENTER to change of field. * ESC to close the form * to Advance al following control * to Delay al previous control * function Keys *.. .
標簽： combinations negotiate of utilized
上傳時間： 2014-01-15
上傳用戶：linlin
Avalanche photodiodes (APDs) are widely utilized in laserbased fiberoptic systems to convert optical data intoelectrical form. The APD is usually packaged with a signalconditioning amplifier in a small module. An APD receivermodule and attendant circuitry appears in Figure 1. TheAPD module (figure right) contains the APD and a transimpedance(e.g., current-to-voltage) amplifier. An opticalport permits interfacing fiberoptic cable to the APD’sphotosensitive portion. The module’s compact constructionfacilitates a direct, low loss connection between theAPD and the amplifier, necessary because of the extremelyhigh speed data rates involved
上傳時間： 2013-10-25
上傳用戶：brain kung
The PCA9516 is a BiCMOS integrated circuit intended forapplication in I2C and SMBus systems.While retaining all the operating modes and features of the I2Csystem, it permits extension of the I2C-bus by buffering both the data(SDA) and the clock (SCL) lines, thus enabling five buses of 400 pF.The I2C-bus capacitance limit of 400 pF restricts the number ofdevices and bus length. Using the PCA9516 enables the systemdesigner to divide the bus into five segments off of a hub where anysegment to segment transition sees only one repeater delay.
上傳時間： 2013-11-21
上傳用戶：q123321
The PCA9517 is a CMOS integrated circuit that provides level shifting between lowvoltage (down to 0.9 V) and higher voltage (2.7 V to 5.5 V) I2C-bus or SMBus applications.While retaining all the operating modes and features of the I2C-bus system during thelevel shifts, it also permits extension of the I2C-bus by providing bidirectional buffering forboth the data (SDA) and the clock (SCL) lines, thus enabling two buses of 400 pF. Usingthe PCA9517 enables the system designer to isolate two halves of a bus for both voltageand capacitance. The SDA and SCL pins are over voltage tolerant and arehigh-impedance when the PCA9517 is unpowered.
標簽： translating Level 9517 PCA
上傳時間： 2013-12-25
上傳用戶：wsf950131
The PCA9518 is a BiCMOS integrated circuit intended forapplication in I2C and SMBus systems.While retaining all the operating modes and features of the I2Csystem, it permits extension of the I2C-bus by buffering both thedata (SDA) and the clock (SCL) lines, thus enabling virtuallyunlimited buses of 400 pF.
標簽： Expandable 5channel 9518 PCA
上傳時間： 2013-10-23
上傳用戶：dumplin9
The PCA9519 is a 4-channel level translating I2C-bus/SMBus repeater that enables theprocessor low voltage 2-wire serial bus to interface with standard I2C-bus or SMBus I/O.While retaining all the operating modes and features of the I2C-bus system during thelevel shifts, it also permits extension of the I2C-bus by providing bidirectional buffering forboth the data (SDA) and the clock (SCL) lines, thus enabling the I2C-bus or SMBusmaximum capacitance of 400 pF on the higher voltage side. The SDA and SCL pins areover-voltage tolerant and are high-impedance when the PCA9519 is unpowered.
標簽： 4channel transla level 9519
上傳時間： 2013-11-19
上傳用戶：jisiwole
The P82B96 offers many different ways in which it can be used as abus interface. In its simplest application it can be used as aninterface between bus systems operating from different supplyvoltages. Opto isolation between two bus systems is possible, andalso the availability of the Tx and Rx signals permits interfacing ofthe P82B96 with other bus systems which separate the forwardoutput path, from the backward input signal path.
上傳時間： 2013-10-11
上傳用戶：洛木卓
迭代自適應Simpson，Lobatto積分 In almost every standard book on numerics quadrature algorithms like the adaptive Simpson or the adaptive Lobatto algorithm are presented in a recursive way. The benefit of the recursive programming is the compact and clear representation. However, recursive quadrature algorithms might be transformed into iterative quadrature algorithms without major modifications in the structure of the algorithm. We present iterative adaptive quadrature algorithm (adaptiveSimpson and adaptiveLobatto), which preserves the compactness and the clarity of the recursive algorithms (e.g. quad, quadv, and quadl). Our iterative algorithm provides a parallel calculation of the integration function, which leads to tremendous gain in run-time, in general. Our results suggest a general iterative and not a recursive implementation of adaptive quadrature formulas, once the programming language permits parallel access to the integration function. For details the attached PDF file Conrad_08.pdf.
上傳時間： 2014-10-25
上傳用戶：xc216
