通用異步收發器UART(Universal Asynchronous Receiver/Transmitter)是廣泛使用的串行傳輸協議。串行外設用到異步串行接口一般采用專用集成電路實現。但是這類芯片一般包含許多輔助模塊，而時常不需要使用完整的UART的功能和輔助功能，或者當在FPGA上設計時，需要將UART功能集成到FPGA內部而不能使用芯片。藍牙主機控制器接口則是實現主機設備與藍牙模塊之間互操作的控制部件。當在使用藍牙設備的時候尤其是在監控場所，接口控制器在控制數據與計算機的傳輸上就起了至關重要的作用。 論文針對信息技術的發展和開發過程中的實際需要，設計了一個藍牙HCI-UART(Host Controller Interface-Universal Asynchronous Receiver/Transmitter)控制接口的模塊。使用VHDL將其核心功能集成，既可以單獨使用，也可集成到系統芯片中，并且整個設計緊湊、穩定且可靠，其用途廣泛，具有一定的使用價值。 本設計采用TOP-DOWN設計方法，整體上分為UART接口和藍牙主機控制器接口兩部分。首先根據UART和藍牙主機控制器接口的實現原理和設計指標要求進行系統設計，對系統劃分模塊以及各個模塊的信號連接；然后進行模塊設計，設計出每個模塊的功能，并用VHDL語言編寫代碼來實現模塊功能；再使用ISE8.2I自帶的仿真器對各模塊進行功能仿真和時序仿真；最后進行硬件驗證，在Virtex-II開發板上對系統進行功能驗證。實現了發送、接收和波特率發生等功能，驗證了結果，表明設計正確，功能良好，符合設計要求。
上傳時間： 2013-04-24
上傳用戶：tianyi223
·詳細說明：完整的MP3播放器源碼。包括列表窗口，音頻特性調整功能，仿照winamp。支持換膚。- Complete MP3 player source code. Including tabulates the window, the audio frequency characteristic adjustment function, imitates winamp. The support t
上傳時間： 2013-06-17
上傳用戶：郭靜0516
·詳細說明：雙音多頻（DTMF）信號發生器的使用源程序，vc 編寫，與《雙音多頻（DTMF）接收器的使用源程序》聯合用- The double sound multi- frequencies (DTMF) the signal generating device use source program, the vc compilation, (DTMF) Receiver Use Source p
上傳時間： 2013-07-23
上傳用戶：tianjinfan
Abstract: The MAX3108 is a complete high-performance universal asynchronous receiver-transmitter (UART) in a tiny 2.1mm ×
標簽： Programming Rates Baud 3108
上傳時間： 2014-12-23
上傳用戶：清風冷雨
The LT®6552 is a specialized dual-differencing 75MHzoperational amplifier ideal for rejecting common modenoise as a video line receiver. The input pairs are designedto operate with equal but opposite large-signal differencesand provide exceptional high frequency commonmode rejection (CMRR of 65dB at 10MHz), therebyforming an extremely versatile gain block structure thatminimizes component count in most situations. The dualinput pairs are free to take on independent common modelevels, while the two voltage differentials are summedinternally to form a net input signal.
上傳時間： 2014-12-23
上傳用戶：13691535575
Designers of signal receiver systems often need to performcascaded chain analysis of system performancefrom the antenna all the way to the ADC. Noise is a criticalparameter in the chain analysis because it limits theoverall sensitivity of the receiver. An application’s noiserequirement has a signifi cant infl uence on the systemtopology, since the choice of topology strives to optimizethe overall signal-to-noise ratio, dynamic range andseveral other parameters. One problem in noise calculationsis translating between the various units used by thecomponents in the chain: namely the RF, IF/baseband,and digital (ADC) sections of the circuit.
上傳時間： 2014-12-05
上傳用戶：cylnpy
分析了調幅信號和載波信號之間的相位差與調制信號的極性的對應關系,得出了相敏檢波電路輸出電壓的極性與調制信號的極性有對應關系的結論。為了驗證相敏檢波電路的這一特性,給出3 個電路方案,分別選用理想元件和實際元件,采用Multisim 對其進行仿真實驗,直觀形象地演示了相敏檢波電路的鑒相特性,是傳統的實際操作實驗所不可比擬的。關鍵詞:相敏檢波;鑒相特性;Multisim;電路仿真 Abstract : The corresponding relation between modulation signal polarity and difference phases of amplitudemodulated signal and the carrier signal ,the polarity of phase2sensitive detecting circuit output voltage and the polarity of modulation signal are correspondent . In order to verify this characteristic ,three elect ric circuit s plans are produced ,idea element s and actual element s are selected respectively. Using Multisim to carry on a simulation experiment ,and then demonst rating the phase detecting characteristic of the phase sensitive circuit vividly and directly. Which is t raditional practical experience cannot be com pared.Keywords :phase sensitive detection ;phase2detecting characteristic ;Multisim;circuit simulation
上傳時間： 2013-11-23
上傳用戶：guanhuihong
Avalanche photo diode (APD) receiver modules arewidely used in fi ber optic communication systems. AnAPD module contains the APD and a signal conditioningamplifi er, but is not completely self contained. It stillrequires signifi cant support circuitry including a highvoltage, low noise power supply and a precision currentmonitor to indicate the signal strength. The challenge issqueezing this support circuitry into applications withlimited board space. The LT®3482 addresses this challengeby integrating a monolithic DC/DC step-up converter andan accurate current monitor. The LT3482 can supportup to a 90V APD bias voltage, and the current monitorprovides better than 10% accuracy over four decades ofdynamic range (250nA to 2.5mA).
上傳時間： 2014-01-18
上傳用戶：wenyuoo
介紹一種基于C8051F060單片機和NAND Flash的數據采集存儲系統，該系統可實現3路信號采樣，每路采樣率為5KS/s,通過異步串行通信接口實現數據傳輸。并詳細說明系統的軟件設計。 Abstract: An acquisition and storage system based on C8051F060and NAND Flash is designed in this paper.The system is used to sample three-channel of signal,5KSPS each channel,and can upload data to test bench through UART（Universal Asynchronous Receiver/Transmitter）.The software design is discussed in detail.
上傳時間： 2013-10-12
上傳用戶：Jesse_嘉偉
在嵌入式系統中，嵌入式CPU往往要通過各種串行數據總線與“外界”進行通信。在應用中，異步的串行數據通信用得較多，而通用異步收發器UART（Universal Asynchronous Receiver Transmitter）在其中扮演著重要角色：完成數據的串并轉換，即把并行數據按照通信波特率轉化為通信協議中規定的串行數據流，也可從串行數據流中取出有用數據轉變為并行數據。而UART與CPU接口簡單，CPU只需通過執行讀寫操作即可完成收發數據，從而完成與外界的通信。有許多現成的芯片可以實現UART的功能，如常用的Intel8250/8251接口芯片就可以作為RS232、RS422串口的UART控制芯片。
上傳時間： 2013-11-25
上傳用戶：www240697738
