basic.c */
/**//* Project:NeuroBasic, basic package*//**/
/* Survey:This is a simple Basic b-code compiler which*/
/*can be used as a comfortable command shell for */
/* any program. The actual compiler is found in */
/*compiler.c.*/
/*The functions m_fctptr() and user_server()*/
/*build an interface to an
I. C. Wong, Z. Shen, J. G. Andrews, and B. L. Evans, ``A Low Complexity Algorithm for Proportional Resource Allocation in OFDMA Systems , Proc. IEEE Int. Work. Signal Processing Systems, 針對這篇文章給出的源代碼
Abstract-In this paper, simple autonomous chaotic circuits
coupled by resistors are investigated. By carrying out computer
calculations and circuit experiments, irregular self-switching phenomenon
of three spatial patterns characterized by the phase
states of quasi-synchronization of chaos can be observed from
only four simple chaotic circuits. This is the same phenomenon
as chaotic wandering of spatial patterns observed very often from
systems with a large number of degrees of freedom. Namely, one
of spatial-temporal chaos observed from systems of large size can
be also generated in the proposed system consisting of only four
chaotic circuits. A six subcircuits case and a coupled chaotic circuits
networks are also studied, and such systems are confirmed
to produce more complicated spatio-temporal phenomena.
隨著光伏發電系統快速發展,以及電動汽車充電樁的普及,傳統的剩余電流保護器無法滿足實際需求。介紹了一款B型剩余電流保護器,采用磁調制剩余電流互感器和零序電流互感器采集剩余電流。根據GB/T 22794—2017標準要求,可識別1 kHz及以下的正弦交流、帶和不帶直流分量的脈動直流、平滑直流等剩余電流信號。經信號調理電路將電壓信號送到單片機進行采集和判斷。通過試驗測試,該樣機在測試精度和速度上均符合國家標準的相關要求。The rapid development of photovoltaic power generation systems and the popularity of electric vehicle charging piles make the traditional residual current protective devices unable to meet the actual demand.This paper proposed a type B residual current protective device,which uses the magnetically modulated residual current transformer and the zero sequence current transformer to acquire the residual current.According to the requirements of GB/T 22794—2017,the type B residual current protective device can detect sinusoidal AC residual current of 1kHz and below 1kHz,pulsating DC residual current with and without DC component,smooth DC residual current and so on.The signal processing circuit sends the voltage signal to the MCU for acquisition and judgment.Through experimental tests,the device meets the relevant requirements of national standards in terms of test accuracy and speed.
