determine whether a graph is semi-connected
標簽： semi-connected determine whether graph
上傳時間： 2017-04-30
上傳用戶：lanjisu111
在研究傳統家用燃氣報警器的基礎上，以ZigBee協議為平臺，構建mesh網狀網絡實現網絡化的智能語音報警系統。由于傳感器本身的溫度和實際環境溫度的影響，傳感器標定后采用軟件補償方法。為了減少系統費用，前端節點采用半功能節點設備，路由器和協調器采用全功能節點設備，構建mesh網絡所形成的家庭內部報警系統，通過通用的電話接口連接到外部的公用電話網絡，啟動語音模塊進行報警。實驗結果表明，在2.4 GHz頻率下傳輸，有墻等障礙物的情況下，節點的傳輸距離大約為35 m，能夠滿足家庭需要，且系統工作穩定，但在功耗方面仍需進一步改善。 Abstract: On the basis of studying traditional household gas alarm system, this paper proposed the platform for the ZigBee protocol，and constructed mesh network to achieve network-based intelligent voice alarm system. Because of the sensor temperature and the actual environment temperature, this system design used software compensation after calibrating sensor. In order to reduce system cost, semi-functional node devices were used as front-end node, however, full-function devices were used as routers and coordinator，constructed alarm system within the family by building mesh network，connected to the external public telephone network through the common telephone interface, started the voice alarm module. The results indicate that nodes transmit about 35m in the distance in case of walls and other obstacles by 2.4GHz frequency transmission, this is able to meet family needs and work steadily, but still needs further improvement in power consumption.
上傳時間： 2013-10-30
上傳用戶：swaylong
2012年最新NIKO-SEMI 產品選型表。
上傳時間： 2013-10-12
上傳用戶：lanhuaying
This program demonstrates how to do disconnected briefcase applications with ADO. When the Connected checkbox is unchecked the application is switched into offline mode. If the application is exited at that point then the data is persisted to a file on disk (along with any edits to the data). When the application is restarted it will load the persisted data if present, otherwise it will fetch the data from the database.
標簽： demonstrates applications disconnected Connected
上傳時間： 2015-03-24
上傳用戶：xcy122677
1.初始化程序時候,獲取本機的撥號連接 2.撥號時候,利用選擇的撥號連接進行撥號 3.成功后提示connected.點擊OK掛斷. 4.注意程序中用戶名和密碼的設定.
上傳時間： 2013-12-09
上傳用戶：牛布牛
This example shows how to read and write the SPI eeprom connected to the nRF9E5 and nRF24E1 devices.
上傳時間： 2015-05-08
上傳用戶：181992417
DriverManagerConnectionProvider.java is the common function connected to data base
標簽： DriverManagerConnectionProvider connected function common
上傳時間： 2013-12-22
上傳用戶：天誠24
Jtag schematic for embemed system design. It support parallel port connected to jtag.
標簽： schematic connected parallel embemed
上傳時間： 2014-12-05
上傳用戶：chens000
semi-supervised MCMC classification
標簽： semi-supervised classification MCMC
上傳時間： 2016-01-05
上傳用戶：頂得柱
This a c_based JATG.This code assumes that you have a JTAG parallel cable connected to your PC // Works with Xilinx parallel III or Altera ByteBlasterMV/
標簽： This connected parallel c_based
上傳時間： 2014-01-17
上傳用戶：guanliya
<option id="4yo4e"></option>
